Bedienungsanleitung Cannon MAG 10HS

Bedienungsanleitung für das Gerät Cannon MAG 10HS

Gerät: Cannon MAG 10HS
Kategorie: Angelausrüstung
Produzent: Cannon
Größe: 3.99 MB
Datum des Hinzufügens: 5/16/2013
Seitenanzahl: 16
Anleitung drucken

Herunterladen

Wie kann man es nutzen?

Unser Ziel ist Ihnen einen schnellen Zugang zu Inhalten in Bedienungsanleitungen zum Gerät Cannon MAG 10HS zu garantieren. Wenn Sie eine Online-Ansicht nutzten, können Sie den Inhaltsverzeichnis schnell durchschauen und direkt zu der Seite gelangen, auf der Sie die Lösung zu Ihrem Problem mit Cannon MAG 10HS finden.

Für Ihre Bequemlichkeit

Wenn das direkte Durchschauen der Anleitung Cannon MAG 10HS auf unserer Seite für Sie unbequem ist, können sie die folgende zwei Möglichkeiten nutzen:

  • Vollbildsuche – Um bequem die Anleitung durchzusuchen (ohne sie auf den Computer herunterzuladen) können Sie den Vollbildsuchmodus nutzen. Um das Durchschauen der Anleitung Cannon MAG 10HS im Vollbildmodus zu starten, nutzen Sie die Schaltfläche Vollbild
  • Auf Computer herunterladen – Sie können die Anleitung Cannon MAG 10HS auch auf Ihren Computer herunterladen und sie in Ihren Sammlungen aufbewahren. Wenn Sie jedoch keinen Platz auf Ihrem Gerät verschwenden möchten, können Sie sie immer auf ManualsBase herunterladen.
Cannon MAG 10HS Handbuch - Online PDF
Advertisement
« Page 1 of 16 »
Advertisement
Druckversion

Viele Personen lesen lieber Dokumente nicht am Bildschirm, sondern in gedruckter Version. Eine Druckoption der Anleitung wurde ebenfalls durchdacht, und Sie können Sie nutzen, indem Sie den Link klicken, der sich oben befindet - Anleitung drucken. Sie müssen nicht die ganze Cannon MAG 10HS Anleitung drucken, sondern nur die Seiten, die Sie brauchen. Schätzen Sie das Papier.

Zusammenfassungen

Unten finden Sie Trailer des Inhalts, der sich auf den nächsten Anleitungsseiten zu Cannon MAG 10HS befindet. Wenn Sie den Seiteninhalt der nächsten Seiten schnell durchschauen möchten, können Sie sie nutzen.

Inhaltszusammenfassungen
Inhaltszusammenfassung zur Seite Nr. 1

CAUTION:
READ THIS MANUAL CAREFULLY
BEFORE OPERATING YOUR NEW
®
CANNON DOWNRIGGER.
RETAIN FOR FUTURE REFERENCE.
MAG 10HS
MAG 10TS
NOTE: Do not return your CANNON® Downrigger to your
retailer. Your retailer is not authorized to repair or replace
this unit. You may obtain service by:
• calling CANNON® at 1-800-227-6433;
• returning your downrigger to the Factory Service
Center;
• sending or taking your downrigger to any CANNON®
MAG 5HS
Authorized Service Center on enclosed list.

Inhaltszusammenfassung zur Seite Nr. 2

Introduction to downriggers Introduction to Controlled Depth Fishing Undoubtedly there are many fishermen One essential feature of the downrigger is familiar with the methods and use of controlled the depth meter or gauge that indicates lure depth fishing. During the mid 1960's the state of depth. This allows the angler to control as well Michigan introduced Pacific salmon into the Great as return to specific depths where fish have lakes in an attempt to revitalize its sport fishing

Inhaltszusammenfassung zur Seite Nr. 3

MOUNTING & SETUP Downrigger Mounting on Boats A downrigger should be mounted where ever it Arrows is easy to operate and observe. You want to be Indicate able to see your fishing rod and to react quickly. Mounting So, choosing a good spot to mount your Locations downrigger on your boat is 99% of the job. Due to the great variety of boats available, mounting your downrigger can be a dilemma. Having proper mounting accessories is essential. Cannon has a complete line of mounting a

Inhaltszusammenfassung zur Seite Nr. 4

MOUNTING & SETUP Side Rail Mounting Side/Rail on T-Section Side/Rail mounts can be mounted to a welded T-section. It can also be used at the two rail section butt joint. In both installations it is recommended to use a non-slip material, such as rubber or a thin wood sheet, between metal surfaces. You can also use these for mounting to a very narrow side gunwale. There is a plate provided for back-up with bolts and washers. If the gunwale compartment is foamed in, then wellnuts

Inhaltszusammenfassung zur Seite Nr. 5

MOUNTING & SETUP Installing the Base on Your Boat Decks up to 7/16" thick Decks up to Where access to the underside of the deck is 7/16" Thick not available, the mounting base can be mounted Base using wellnuts. Use the base as a template to mark locations and drill four 1/2" holes. Mount the base using four 1/4-20 x 4" truss head screws and four wellnuts. Tighten the screws so the wellnuts are firmly compressed as pictured. Wellnuts Decks thicker than 7/16" For decks thicker t

Inhaltszusammenfassung zur Seite Nr. 6

MOUNTING & SETUP Mounting the Downrigger on the Base Slide body over the lip of the base, with boom outboard or facing the stern. Lift Lock Knob to hold threaded shaft clear of base until body completely covers base. Turn Lock Knob clockwise to tighten the downrigger to the base. Tip: Periodically check base to ensure integrity. Lock Knob The base should be replaced at least every 5 years. Setting Up Your Downrigger 3/4”-Long Attaching the Boom Boom Telescopic Boom The in

Inhaltszusammenfassung zur Seite Nr. 7

TERMINATOR & LINE RELEASE Terminating the Downrigger Cable Examine the top of the terminator and note the order shown in the detail to run cable. Unwind about 2 feet of cable Cable Rubber Cushion and thread the cable through the rubber cushion. CABLE IN CABLE IN Attach to terminator. CABLE OUT Snap & Swivel Tip: A set of pliers with wire cutters is recommended for this part of setup. TIP: Use only straight cable, not kinked. Slide the cushion over the top of the Lead cable in

Inhaltszusammenfassung zur Seite Nr. 8

ATTACHING THE ROD HOLDER Attaching the Rod Holder The positive lock rod holder incorporates a CAUTION: This rod holder is intended for use locking disk that allows the rod holder to be of up to 30 lb. test line only, and is not aligned in 15 degree increments. Slide the rod recommended for use with any tackle IGFA holder tube into the clamp to the desired position rated higher than 30 lb. A safety strap (not within the recommended area (see below). included) is recommended for all Be

Inhaltszusammenfassung zur Seite Nr. 9

WIRING YOUR DOWNRIGGER Wiring Your Downrigger Electrical Specifications & Wiring Your Boat's Electrical Condition Instructions It is important to make sure that your boat is The Mag 10HS \ Mag 10TS \ Mag 5HS are properly set up before installing your Mag 10HS \ rated at 25 amps (full load), 12 volts DC and is Mag 10TS \ Mag 5HS with Positive Ion Control. protected by a 30 amp manual reset circuit Whenever a boat is in water, various submerged breaker. Be sure to measure the battery

Inhaltszusammenfassung zur Seite Nr. 10

OPERATING YOUR DOWNRIGGER Operating Your Downrigger After mounting the Cannon downrigger to your boat, release some line from your rod and reel so that the lure is anywhere from 5 to 100 feet behind the boat. This is called drop back. Attach the fishing line firmly into the line release. Press and hold the toggle switch down to lower the weight to the desired depth as indicated on the depth meter. Place the fishing rod in the rod holder and reel up To Lower the slack so that your rod

Inhaltszusammenfassung zur Seite Nr. 11

THE SHORT STOP SYSTEM Adjusting the Depth Meter The Cannon Depth Meter provides non-slip accuracy, plus easy resetting. To reset, just slide the meter away from the reel until the gears are disengaged. Spin meter gear to change setting. NOTE: Actual fishing depth may vary from depth shown on meter due to trolling speed and weight of cannon ball. (See "Blowback" on page 12) The Short Stop System The Short Stop system is composed of three critical components: the electronic unit,

Inhaltszusammenfassung zur Seite Nr. 12

POSITIVE ION CONTROL The Positive Ion Control System Your boat has an electrical charge around the Using Positive Ion Control hull in water. If a boat is properly bonded and Positive Ion Control is very effective when properly zinced, that charge should be slightly trolling. The zone of attraction created at the positive when measured from ground to the downrigger wire will attract the fish. It is best to use downrigger cable. Positive Ion Control (PIC) is the a short drop back betw

Inhaltszusammenfassung zur Seite Nr. 13

Blowback & TROUBLE SHOOTING Actual Depth of Weight (ft.) Actual Depth of Weight (ft.) ActualDepth of Weight (ft.) Blowback Charts Trouble Shooting PROBLEM: Up or down will not work. 8-Lb. Weight at 2, 4, and 6 MPH SOLUTION: Check the battery cable polarity then check the 2 MPH battery voltage. A properly connected and charged battery is important for safety and for proper operation of 4 MPH the downrigger. PROBLEM: 6 MPH The Mag 10HS \ Mag 10TS \ Mag 5HS fails to continue

Inhaltszusammenfassung zur Seite Nr. 14

TROLLING TIPS 5) Locate fish on a vertical plane. Place lures Ten Good Trolling Tips in areas where fish might be. Skilled fishermen 1) Test your lures over the boat side before call these areas the “strike zones”. They include sending them down and back. Do this to make the edges of the week beds, structure along sure the lure wiggles and wobbles properly bottom, drop-offs, preferred temperature of the without going belly up or wandering off. Some target species, and the thermocline.

Inhaltszusammenfassung zur Seite Nr. 15

LIMITED WARRANTY & SERVICE POLICY ® CANNON® LIMITED WARRANTY CANNON SERVICE POLICY Johnson Outdoors Inc. warrants to the original purchaser that if the AFTER THE APPLICABLE WARRANTY PERIOD accompanying product (see exclusions below) proves to be defective in material or workmanship within the following warranty periods, Johnson Outdoors Inc. will, at its option, either repair or replace same After the applicable warranty period, or, if one of the above exclusions applies, Cannon® p

Inhaltszusammenfassung zur Seite Nr. 16

ENVIRONMENTAL COMPLIANCE STATEMENT: It is the intention of Johnson Outdoors Inc. to be a responsible corporate citizen, operating in compliance with known and applicable environmental regulations, and a good neighbor in the communities where we make or sell our products. WEEE Directive: EU Directive 2002/96/EC “Waste of Electrical and Electronic Equipment Directive (WEEE)” impacts most distributors, sellers, and manu- facturers of consumer electronics in the European Union. The WEEE Dire


Ähnliche Anleitungen
# Bedienungsanleitung Kategorie Herunterladen
1 Cannon 1904031 Handbuch Angelausrüstung 2
2 Cannon 5 ST Handbuch Angelausrüstung 29
3 Cannon Adjustable Single Axis 1907001 Handbuch Angelausrüstung 0
4 Cannon Adjustable Downrigger Mount (Metallic) 1907022 Handbuch Angelausrüstung 0
5 Cannon 1904033 Handbuch Angelausrüstung 0
6 Cannon 1904030 Handbuch Angelausrüstung 0
7 Cannon Adjustable Downrigger Mount (Black) 1907023 Handbuch Angelausrüstung 0
8 Cannon Adjustable Rail Mount 1907020 Handbuch Angelausrüstung 2
9 Cannon EASI-TROLL /E Handbuch Angelausrüstung 9
10 Cannon LAKE-TROLL Handbuch Angelausrüstung 6
11 Cannon DIGI-TROLL 5 Handbuch Angelausrüstung 33
12 Cannon Uni-Troll 10 Handbuch Angelausrüstung 20
13 Cannon DIGI-TROLL 5 TS Handbuch Angelausrüstung 18
14 Cannon Uni-Troll 10TS Handbuch Angelausrüstung 6
15 Cannon Uni-Troll 5 Handbuch Angelausrüstung 6
16 Anderson Manufacturing 6T Handbuch Angelausrüstung 0
17 Aquapro Fish Feeders ADF-25DX Handbuch Angelausrüstung 16
18 Aquapro Fish Feeders ADF-150DX Handbuch Angelausrüstung 9
19 Aquapro Fish Feeders ATX Handbuch Angelausrüstung 10
20 Ardent C400 Handbuch Angelausrüstung 2