Inhaltszusammenfassung zur Seite Nr. 1
Instructions for use
WASHING MACHINE
Contents
GB
Installation, 2-3-4-5-6-7
GB
Unpacking and levelling
Connecting the electricity and water supplies
English,1
The first wash cycle
Technical data
Instructions for the fitter
Description of the washing machine, 8-9
Control panel
Display
Running a wash cycle, 10
Wash cycles and functions, 11
Table of wash cycles
Wash functions
BHWMD 732 Detergents and laundry, 12
Detergent dispenser drawer
Preparing the laundry
Special wash cycles
Load balancing sys
Inhaltszusammenfassung zur Seite Nr. 2
Installation 2. If the floor is not perfectly level, compensate for any ! Keep this instruction manual in a safe place for future referen- GB unevenness by tightening or loosening the adjustable front ce. Should the appliance be sold, transferred or moved, make feet (see figure); the angle of inclination, measured accor- sure the instruction manual accompanies the washing machine ding to the worktop, must not exceed 2°. to inform the new owner as to its operation and features. Levelling your
Inhaltszusammenfassung zur Seite Nr. 3
65 - 100 cm Connecting the drain hose • the supply voltage is included within the values indica- GB ted on the Technical Data Plate fixed on the machine. Connect the drain hose, without bending it, to a • the socket is compatible with the washing machine’s draining duct or a wall drain plug. If this is not the case, replace the socket or the situated between 65 and plug. 100 cm from the floor; Your appliance is now supplied with a 13 amp fused plug it can be plugged into a 13 amp so
Inhaltszusammenfassung zur Seite Nr. 4
As the colours of the wires in the lead may not correspond The first wash cycle GB with the coloured markings identifying the terminals in your plug, proceed as follows: Once the appliance has been installed, and before you use Connect Green & Yellow wire to terminal marked E or it for the first time, run a wash cycle with detergent and no or coloured Green or Green & Yellow. laundry, using the wash cycle (60°C). Connect Brown wire to terminal marked L or coloured Red. Connect Blue wire
Inhaltszusammenfassung zur Seite Nr. 5
GB Technical data Model BHWMD 732 width 59.5 cm Dimensions height 81.5 cm depth 54.5 cm Capacity from 1 to 7 kg Electrical please refer to the technical data plate fixed to the machine connections maximum pressure 1 MPa (10 bar) Water connections minimum pressure 0.05 MPa (0.5 bar) drum capacity 52 litres Spin speed up to 1300 rotations per minute Test wash cycles in accordance programme ; with directives temperature 60°C (2nd press of the button); 1061/2010 and temperature 40°C (3rd pre
Inhaltszusammenfassung zur Seite Nr. 6
Door Mounting Accessories (Fig. 1-2-3-4-5). Instructions for the fitter GB Mounting the wooden panel onto the door and in- serting the machine into cabinets: In the case where the machine must be shipped for final installation after the wooden panel has been mounted, we suggest leaving it in its original packaging. The packaging was designed to make it possible to mount the wooden panel onto the machine without removing it completely (see figures below). N° 2 Hinge Supports N° 2 Hinges T
Inhaltszusammenfassung zur Seite Nr. 7
Using the Drilling Template. - To trace the positions of the holes on the left-hand side of GB the panel, align the drilling template to the top left side of the panel using the lines traced on the extremities as a referen- ce. - To trace the positions of the holes on the right-hand side of the panel, align the drilling template to the top right side of the panel. - Use an appropriately sized router to mill the holes for the Fig. 8 Fig. 9 two hinges, the rubber plug and the magnet. Accessor
Inhaltszusammenfassung zur Seite Nr. 8
Description of the washing machine Control panel GB ON/OFF CHILD LOCK SPIN SPEED button button button DISPLAY MY CYCLE button WASH FUNCTION CYCLE buttons START/PAUSE DELAY SELECTOR Detergent dispenser drawer button with TIMER buttons indicator light TEMPERATURE button button Detergent dispenser drawer: used to dispense deter- CHILD LOCK button: to activate the control panel lock, gents and washing additives (see “Detergents and laundry”). press and hold the button for approximately 2
Inhaltszusammenfassung zur Seite Nr. 9
Display GB A B D C E F The display is useful when programming the machine and provides a great deal of information. The two upper strings A and B provide details of the wash cycle selected, the wash cycle phase in progress and all informa- tion relating to the progress status of the wash cycle. String C shows the time remaining until the end of the wash cycle in progress and, if a DELAYED START has been set, the time remaining until the start of the selected wash cycle. String D shows the maxim
Inhaltszusammenfassung zur Seite Nr. 10
Running a wash cycle 1. SWITCH THE MACHINE ON. Press the On/Off 7. START THE PROGRAMME. Press the START/ GB button ; the text HELLO will appear on the display PAUSE button. The corresponding indicator light will and the START/PAUSE indicator light will flash slowly in become green, remaining lit in a fixed manner, and the a green colour. door will be locked (the DOOR LOCKED symbol will be on). During the wash cycle, the name of the phase in 2. LOAD THE LAUNDRY. Open the porthole door. progr
Inhaltszusammenfassung zur Seite Nr. 11
Wash cycles and functions Table of wash cycles GB Detergents Max. Max. Description of the wash cycle temp. speed (°C) (rpm) Fabric Wash softener CLEAN Plus Anti Stain 40° 1300 4 - - - 180’ White Cottons (1st press of the button): extremely soiled whites and resistant colours. 90° 1300 7 53 2,16 72 160’ Standard Cotton (1) (2nd press of the button): heavily soiled whites and delicate colours. 60° 1300 7 53 1,10 58 190’ Standard Cotton (1-2) (3rd press of the button): lightly soiled
Inhaltszusammenfassung zur Seite Nr. 12
Detergents and laundry Detergent dispenser drawer Special wash cycles GB Good washing results also depend on the correct dose of Anti Stain : this programme is suitable to heavily-soiled detergent: adding too much detergent will not necessarily garments with resistant colours. It ensures a washing result in a more efficient wash, and may in fact cause a class that is higher than the standard class (A class). When build up on the inside of your appliance and contribute to running the programme
Inhaltszusammenfassung zur Seite Nr. 13
Precautions and tips ! This washing machine was designed and constructed in Opening the porthole door manually GB accordance with international safety regulations. The fol- In the event that it is not possible to open the porthole lowing information is provided for safety reasons and must door due to a powercut, and if you wish to remove the therefore be read carefully. laundry, proceed as follows: General safety 1. remove the plug from the electrical socket. • This appliance was designed fo
Inhaltszusammenfassung zur Seite Nr. 14
Care and maintenance To access the pre-chamber: Cutting off the water and electricity GB supplies 1. unscrew the lid by rota- ting it anti-clockwise (see • Turn off the water tap after every wash cycle. This will limit figure): a little water may wear on the hydraulic system inside the washing machine trickle out. This is perfectly and help to prevent leaks. normal; • Unplug the washing machine when cleaning it and du- ring all maintenance work. Cleaning the washing machine 2. clean the i
Inhaltszusammenfassung zur Seite Nr. 15
Troubleshooting Your washing machine could fail to work. Before contacting the Technical Assistance Centre (see “Assistance”), make sure GB that the problem cannot be solved easily using the following list. Problem: Possible causes / Solutions: The machine does not switch on. • The appliance is not plugged into the socket fully, or not enough to make contact. • There is no power to the socket, or the fuse has blown in the mains plug. The wash cycle does not start. • The door is not closed prop
Inhaltszusammenfassung zur Seite Nr. 16
The machine is noisy. • There will always be some motor, pump and drum noise during spin. GB The machine wont spin properly. • Out of Balance detected when attempting to go into a spin cycle - If this happens the machine will continue to try to repeat the distribution of the load required before the machine will go into higher spin speeds - This will increase the programme time accordingly. This is a safety feature to prevent damage. Out of Balance can be caused by washing a single heavy it
Inhaltszusammenfassung zur Seite Nr. 17
Assistance Before calling for Assistance: GB • Check whether you can solve the problem alone (see “Troubleshooting”); • Restart the programme to check whether the problem has been solved; • If this is not the case, contact an authorised Technical Assistance Centre using the telephone number provided on the guarantee certificate. ! Always request the assistance of authorised technicians. Have the following information to hand: • the type of problem; • the appliance model (Mod.); • the serial num
Inhaltszusammenfassung zur Seite Nr. 18
GB 18
Inhaltszusammenfassung zur Seite Nr. 19
GB 19
Inhaltszusammenfassung zur Seite Nr. 20
195102743.01 05/2012 - Xerox Fabriano GB 20
