Bedienungsanleitung ATD Tools ATD-701

Inhaltszusammenfassung zur Seite Nr. 1

Warning
Do not point laser at eye or indirectly off reflective surfaces.
ATD-701
1. When take measurement, point thermometer toward
Non-contact Infrared Thermometer
the object to be measured and hold the red trigger. The
object under test should be larger than the spot size
Instruction manual
calculated by the field of view diagram.

2. Distance ＆ spot size: As the distance from the object
increase, the spot size of measuring area becomes

larger.

Inhaltszusammenfassung zur Seite Nr. 2

Note: 1) Do not use solvent to clean lens. 2) Do not submerge the unit in water. 2. Locating a hot spot aim the thermometer outside the area of interest, then scan across with up and down 4. Specifications motions until you locate the hot spot.(please turn on the Temperature Infrared ：-30 ℃ to 550 ℃(-22 to1022 ℉) laser to for accurate measuring) range ±3 ℃or ±3%of rdg,-30 ℃ to 0 ℃(-22 to 32) Accuracy ±2 ℃or ±2% of rdg,0 ℃ to 100 ℃(32 to 212 ℉) ±3 ℃or ±3% of rdg, ≥100 ℃(2