Inhaltszusammenfassung zur Seite Nr. 1
FP0301-N
AQUA-LEISURE® SIMPLE-SETTM POOLS
EASY-CLEAN FILTER PUMP SYSTEM
USER MANUAL
MODEL SA-3766
Inhaltszusammenfassung zur Seite Nr. 2
Table of contents Introduction -------------------------------------------------------- 2 Safety Instructions ------------------------------------------------ 3 Parts Listing & Illustration -------------------------------------- 4+5 Installation Instructions ------------------------------------------ 6 Installation Illustrations ------------------------------------------ 7 Operations ---------------------------------------------------------- 8 General Maintenance --------------------------------
Inhaltszusammenfassung zur Seite Nr. 3
Introduction Congratulations! You are the proud owner of an Aqua-Leisure® Simple-SetTM Pool Easy-Clean Filter Pump System. This filter pump system has been manufactured to the highest quality standards, and will provide seasons of clean, sparkling-clear water activity in your new Simple-SetTM Pool. This Simple-SetTM Easy-Clean Filter Pump System Manual will provide you with all of the easy instructions you need to follow in order to set up and operate this state-of-the-art filter pump system eff
Inhaltszusammenfassung zur Seite Nr. 4
Safety Instructions The following important points should be read and understood prior to use: 1. WARNING To prevent possible electric shock, do not attempt to plug in power cord with wet hands or while standing in water. 2. WARNING To prevent possible electric shock, connect power cord into a grounded receptacle protected by a ground-fault circuit interrupter (GFCI). 3. WARNING To prevent possible electric shock, never use a damaged or frayed power cord. 4. WARNING This filter pump is not i
Inhaltszusammenfassung zur Seite Nr. 5
SA-3766 -4-
Inhaltszusammenfassung zur Seite Nr. 6
ITEM NO ITEM DESCRIPTION QTY P1 Air valve cover 1 P2-1,P2-2 Air valve pin 2 P3 Air valve screw 1 P4 Filter chamber cover 1 P5 Filter chamber rubber gasket 1 P6 Filter 1 P7 Pump chamber end cover nut 1 P8 Body 1 P9 Pump chamber end cover sealing flat gasket 1 P10 Pump chamber end cover 1 P11 Pump chamber end cover sealing 1 P12 Rubber shaft base 2 P13 Plastic ring 2 P14 Impeller 1 P15 Magnet rotor 1 P16 Motor shaft 1 P17 Pump body and motor stator assembly 1 P18
Inhaltszusammenfassung zur Seite Nr. 7
Installation Instructions 1. Prior to set-up and installation of filter pump, you must first set up the Simple-SetTM Pool and fill it completely with water, exactly following the Simple-SetTM Pool Manual instructions for pool set-up. 2. For optimal filter pump performance, position the filter pump unit at least 8 inches below the highest water level in the pool. 3. Keep the position of the filter pump unit at least 2 feet away from the sidewall of the pool itself. 4. Place clean filter cartr
Inhaltszusammenfassung zur Seite Nr. 8
-7- INSTALLATION ILLUSTRATION WATER LEVEL UPPER PROTRUDING HOSE CONNECTION P29 P35 P29 INLET PORT P34 LOWER HOSE CONNECTION WATER DIRECTION P35 P34 P29 P28 INSIDE OF POOL P29 P28 OUTLET P21 (ILLUSTRATION NOT TO SCALE) W A T E R D I R E C T I O N
Inhaltszusammenfassung zur Seite Nr. 9
Operating Instructions 1. The filter pump will prime itself as long as it is positioned at least 8 inches below the highest water level in the pool. If for some reason an airlock occurs, there is a relief valve located on the top of the pump. Simply turn the valve knob counter-clockwise, and when a small amount of water escapes, close immediately by turning clockwise. The pump will now be completely primed. 2. Never operate the filter pump dry. This can cause damage to seals which may resul
Inhaltszusammenfassung zur Seite Nr. 10
General Maintenance 1. To avoid dangerous or fatal electrical shock hazard, always disconnect power to the unit before attempting to clean pump. 2. There is no need for any regular mechanical maintenance on the pump unit. (Do not attempt to disassemble the pump motor at any time.) 3. If necessary, clean outside of pump with a mild detergent and water, rinsing off with a hose. 4. There is no need for the use of any lubricants on the pump. 5. Do not use solvents to clean the filter cartridge, a
Inhaltszusammenfassung zur Seite Nr. 11
Cleaning and Replacement 1. As a general rule, the filter cartridge in your pump filter system should be replaced approximately once per month. This will vary depending on usage hours by bathers, number of bathers, and the amount of time the filter system is run without bathers on a daily basis. 2. In between replacing filter cartridges, periodically cleaning of your filter cartridge can enhance the effectiveness of your filter pump and moderately prolong the cartridge's lifespan prior to re
Inhaltszusammenfassung zur Seite Nr. 12
Trouble Shooting Guide 1. PUMP DOES NOT OPERATE A. Check to make sure pump unit power cord is plugged into GFCI outlet properly. B. Check GFCI for proper operation according to GFCI manufacturer's instructions. C. Check for blown fuses or tripped circuit breakers. D. Check to see if motor is too hot, this may cause overload and shutdown. E. Contact the toll-free customer service number for assistance. 2. MOTOR RUNS, BUT DOES NOT PUMP WATER OR WATERFLOW IS TOO SLOW A. Check for possible obstr
Inhaltszusammenfassung zur Seite Nr. 13
LIMITED WARRANTY Aqua-Leisure® Simple-SetTM Filter Pumps ATTENTION CUSTOMER - Please read this statement carefully and keep your original store receipt along with this warranty certificate at all times. Your receipt is required as proof of purchase and to verify the length of your pool ownership. Aqua-Leisure® Industries, Inc. warrants all filter pump units against defects in materials and workmanship under normal use and service for a period of 1 year from the date of purchase for the origina
