Bedienungsanleitung BBE DI-10

Inhaltszusammenfassung zur Seite Nr. 1

s
BBE DI-10
USER MANUAL

Inhaltszusammenfassung zur Seite Nr. 2

Use the following illustrations as a starting point for proper placement Congratulations on the purchase of your of the BBE DI-10. BBE DI-10 direct box! The BBE DI-10 is an active direct box used for converting line out and speaker out signals to balanced and unbalanced signals. The user also SPEAKER OUT has the ability to select between two frequency responses (flat, or SPEAKER IN BALANCED OUTPUT speaker compensated). Using the outputs from the DI-10, the user can DI-10 direct feed to a mixe

Inhaltszusammenfassung zur Seite Nr. 3

FRONT PANEL CONTROLS REAR PANEL CONNECTIONS 1 2 3 4 5 6 1. D.C. INLET: This jack is for connecting the 9 VDC power source. The 9 4. SPEAKER THRU AND SPEAKER INPUT: These are 1/4” mono phone VDC power plug must be of the type where the positive voltage is on the outer jacks. When using an amplifier, the output from the power amp section connects ring. to the ‘speaker input’ jack while the amplifier speakers connect to the ‘speaker 2. FILTER SWITCH: This switch is used to operate the speaker si

Inhaltszusammenfassung zur Seite Nr. 4

SPECIFICATIONS WARRANTY Warranty registration of the unit to BBE Sound Inc. is not necessary. However, it is strongly recommended that a FREQUENCY RESPONSE copy of the bill of sale is retained for future reference. FILTER OFF . . . . . . . . . . . . . . . . . . .5Hz to 30kHz FILTER ON . . . . . . . . . . . . . . . . . . . .40Hz to 4kHz IT IS THE SOLE RESPONSIBILITY OF THE END USER TO PROVIDE THE BILL OF SALE OR OTHER MEANS OF PROOF OF PURCHASE TO VALIDATE THE WARRANTY IF WARRANTY SER- SIGNAL TO