Inhaltszusammenfassung zur Seite Nr. 1
XRS_R7_R9G_Final_012507.qxd:Layout 1 1/25/07 4:30 PM Page FC1
IntelliLink™ Wireless Remote Series
12-Band™ S-XRS™ Maximum Performance Digital Radar/Laser
Detector with Red Light/Speed Camera GPS Locator*
Inhaltszusammenfassung zur Seite Nr. 2
XRS_R7_R9G_Final_012507.qxd:Layout 1 1/25/07 4:30 PM Page A1 Important Information and Customer Assistance Introduction Important Information � Safe Driving Motorists are expected to exercise all due caution while using this product, and to obey all applicable traffic laws. Do not attempt to change settings of the unit while the car is in motion. Federal Laws Governing the Use of Radar Detectors ® It is not against federal law to receive radar transmissions with your Cobra radar/laser dete
Inhaltszusammenfassung zur Seite Nr. 3
THIS SURFACE TOWARDS SKY XRS_R7_R9G_Final_012507.qxd:Layout 1 1/25/07 4:30 PM Page A2 Controls, Indicators and Connections Introduction The XRS R7 provides detection capabilities for radar, laser and strobe signals. The XRS R9G has all the features of the XRS R7 plus a GPSL module which provides alerts when approaching photo-enforced intersections and roads with fixed red light/speed cameras. The XRS R9G can store up to 1,000 additional user-programmable Location Alerts. ™ IntelliLink Remote
Inhaltszusammenfassung zur Seite Nr. 4
XRS_R7_R9G_Final_012507.qxd:Layout 1 1/25/07 4:30 PM Page A3 In This Package Introduction In This Package � 12V Power Cord with In-line Fuse 12V Power Cord with In-line Fuse and Cigarette Lighter Plug for Hardwired Installation 12V to 5V USB Power Adapter USB to Mini-USB Retractable Cable RDU Holster and Vent/Visor Clips GPSL Cable (R9G Only) MDU Power Cord Clips and Pre-cut Optional Hook and Loop Strips Adhesive Tapes for Mounting Holster ® Nothing Comes Close to a Cobra A3
Inhaltszusammenfassung zur Seite Nr. 5
XRS_R7_R9G_Final_012507.qxd:Layout 1 1/25/07 4:30 PM Page 1 Contents Introduction Introduction Warranty Important Information . . . . . . . . . .A1 Warranty . . . . . . . . . . . . . . . . . . . . .37 Customer Assistance . . . . . . . . . . .A1 User License Controls, Indicators and User License . . . . . . . . . . . . . . . . . .39 Connections . . . . . . . . . . . . . . . .A2 Customer Assistance In This Package . . . . . . . . . . . . . . .A3 Product Service . . . . . . . . . . . . . . .41
Inhaltszusammenfassung zur Seite Nr. 6
XRS_R7_R9G_Final_012507.qxd:Layout 1 1/25/07 4:30 PM Page 2 Product Overview Introduction Cobra XRS R7 and XRS R9G � WARNING Modifications or parts not approved by Cobra Electronics Corporation may violate FCC Rules and void authority to operate this equipment. Read and understand the information in the Installation Overview and Installation sections of this manual for best operation. The XRS R7 consists of a Main Detector Unit (MDU) and a wireless Remote Display Unit (RDU). The XRS R9G adds
Inhaltszusammenfassung zur Seite Nr. 7
XRS_R7_R9G_Final_012507.qxd:Layout 1 1/25/07 4:30 PM Page 3 Product Overview Introduction Remote Display Unit (RDU) The RDU is a wireless remote controller/display module that shows alerts ™ detected by the MDU. The RDU display uses an Extreme Bright DataGrafix (Organic Light Emitting Diode) Display to show large graphical alerts as signals are detected. The RDU uses a rechargeable lithium-ion (LiON) battery and is supplied with a holster and clips for mounting on heating/air conditioner vent
Inhaltszusammenfassung zur Seite Nr. 8
XRS_R7_R9G_Final_012507.qxd:Layout 1 1/25/07 4:30 PM Page 4 Installation Overview Introduction Mount Unit Main Detector Unit (MDU) Note: To power the MDU, use one of the two power cords provided (See Page A3). � 12V Power Cord with In-line Fuse for Hardwired Installation: For connection to vehicle’s fuse box or battery, or � 12V Power Cord with In-line Fuse and Cigarette Lighter Plug: For connection to 12-volt vehicle accessory outlet (cigarette lighter plug). Fuse box hard wiring is recomme
Inhaltszusammenfassung zur Seite Nr. 9
THIS SURFACE TOWARDS SKY XRS_R7_R9G_Final_012507.qxd:Layout 1 1/25/07 4:30 PM Page 5 Installation Overview Introduction Figure B Figure C Mount the MDU high on windshield to right of rear view mirror (Figure B). The MDU must have a clear view through the windshield, be parallel to the road (Figure C) and have clearance to snap into the “up” position. Position the MDU for easy access to power switch, cable connections and for mirror movement. Mount the MDU on the windshield close to the headli
Inhaltszusammenfassung zur Seite Nr. 10
XRS_R7_R9G_Final_012507.qxd:Layout 1 1/25/07 4:30 PM Page 6 Installation Overview Introduction Global Positioning System Locator (GPSL) - (XRS R9G Model Only) Figure E Internal View Mount GPSL module close enough to the MDU for supplied cable to connect both modules (Figure E). Mount GPSL with proper side (“This Surface Toward Sky” wording embossed in unit case) attached to windshield and exposed to the sky. Figure F Internal View IMPORTANT: Some States and municipalities prohibit mounting an
Inhaltszusammenfassung zur Seite Nr. 11
XRS_R7_R9G_Final_012507.qxd:Layout 1 1/25/07 4:30 PM Page 7 Installation Your Detector Main Detector Unit (MDU) 1. Position MDU before actual mount. � Do not attempt to adjust MDU bracket. � Hold unit in place. � Using non-permanent pen, mark two opposite corners. 2. Peel off film from two-piece fastener strips. Align with two corner markings made in step 1. Press MDU bracket against windshield. � Fastener strips cannot easily be removed. Strength of adhesive strips increases with time. � Do
Inhaltszusammenfassung zur Seite Nr. 12
XRS_R7_R9G_Final_012507.qxd:Layout 1 1/25/07 4:30 PM Page 8 Installation Your Detector 1. Loosen MDU (gray) bracket 1 Not In Use. adjust knob. Stored/Concealed Position. Bracket Adjust Knob Loosen 2. Adjust module to a position 2 parallel to the road. Lower to Operating Detection Position. 3 3. Tighten knob to set proper Detection horizontal detection Position position. The MDU mounting bracket has two detent positions: Tighten � one for detection operation (horizontal position) � one for
Inhaltszusammenfassung zur Seite Nr. 13
XRS_R7_R9G_Final_012507.qxd:Layout 1 1/25/07 4:30 PM Page 9 Installation Your Detector 4. Attach power cord to MDU. Use power cord clips to route to fuse box or lighter/accessory outlet, depending on the selected power cord. Surfaces must be clean and free of dirt, oil and dust. Plug in the power cord. Internal View ® Nothing Comes Close to a Cobra 9
Inhaltszusammenfassung zur Seite Nr. 14
XRS_R7_R9G_Final_012507.qxd:Layout 1 1/25/07 4:30 PM Page 10 Installation Your Detector Remote Display Unit (RDU) � Battery Installation 1. Turn RDU over and slide battery cover off of RDU body. 2. Carefully plug battery wire connector into the battery connection port in RDU. Connector only fits one way. 3. Replace battery cover. Battery Charging The unit is shipped with a sealed lithium-ion (LiON) battery pack that is rechargeable. IMPORTANT: Avoid temperature extremes (hot and/or cold) to h
Inhaltszusammenfassung zur Seite Nr. 15
XRS_R7_R9G_Final_012507.qxd:Layout 1 1/25/07 4:30 PM Page 11 Installation Your Detector 1. Attach 12V to 5V retractable USB power cable to bottom of RDU and to 12V power adapter. 2. Connect 12V power adapter to vehicle accessory outlet (cigarette lighter plug). 3. Initial charge for battery is two (2) hours. (RDU may be used while charging.) WARNING This lithium-ion (LiON) battery should only be recharged inside the RDU. Do not substitute any other type of charging adapter or charging base to
Inhaltszusammenfassung zur Seite Nr. 16
XRS_R7_R9G_Final_012507.qxd:Layout 1 1/25/07 4:30 PM Page 12 Installation Your Detector RDU Holster A holster is provided to allow you to position the RDU for best driver visibility and access while charging the battery. A vent or visor clip will attach to the rear of the holster. Self-adhesive hook and loop strips are also included for alternative mounting locations. Hook and Loop Strips Vent Clip Visor Clip English 12
Inhaltszusammenfassung zur Seite Nr. 17
THIS SURFACE TOWARDS SKY XRS_R7_R9G_Final_012507.qxd:Layout 1 1/25/07 4:30 PM Page 13 Installation Your Detector Global Positioning System Locator (GPSL) (XRS Model R9G Only) � 1. Position GPSL before actual mount. � Hold GPSL unit in place with USB cable connected to MDU. � Using non-permanent pen, mark two opposite corners. 2. Peel off film from two-piece fastener strips. Align with two corner markings made in step 1. Press GPSL bracket against windshield. � Fastener strips cannot easily
Inhaltszusammenfassung zur Seite Nr. 18
XRS_R7_R9G_Final_012507.qxd:Layout 1 1/25/07 4:30 PM Page 14 Installation Your Detector GPSL Initial Satellite Lock � The GPSL module now needs to detect the Global Positioning satellites. 1. With vehicle running and parked in an area clear of obstructions to the sky, turn on the power to the MDU with GPSL connected. 2. Keep the MDU turned on for at least 15 minutes. This GPSL Icon will allow fast satellite acquisition in subsequent power-ups. IMPORTANT: This procedure may need to be repeated
Inhaltszusammenfassung zur Seite Nr. 19
XRS_R7_R9G_Final_012507.qxd:Layout 1 1/25/07 4:31 PM Page 15 Controls and Display Your Detector RDU Controls MUTE/Button Press for Standby Status Screens. Mutes an alert. Selects features in Menu mode. DIM/Button CITY/Button Toggle between Press for display Highway and City brightness. modes. Navigates Menu Screens. Navigates Menu Screens. Adjusts volume DOWN Adjusts volume UP in Volume mode. in Volume mode. MENU/SAVE Button Press to enter Menu screen. Press and hold to save POWER/VO
Inhaltszusammenfassung zur Seite Nr. 20
XRS_R7_R9G_Final_012507.qxd:Layout 1 1/25/07 4:31 PM Page 16 Controls and Display Your Detector RDU Display Standby Screen The IntelliMute RDU battery icon displays (I-Mute) symbol charge condition of RDU shows only if the battery. Sections change to feature is activated. display battery level, or if Symbol changes to the battery is being charged. indicate if above or below Set-point when IntelliMute is City/Highway symbol turned on. changes to indicate activated alert filtering (Refer to pag
