Inhaltszusammenfassung zur Seite Nr. 1
Steam Station
Model EP7005
120 Volt, 60 Hz, 1400 W.
Tank Water Capacity Approx.: 1 Liter
Use and Care Instructions
Congratulations! You are the owner of the Steam Station. To fully enjoy the
advantages of your appliance, please take a few minutes to read all the “Use &
Care Instructions” and keep the instructions handy for easy reference. Please
review the product warranty and mail the owner registration form.
EURO-PRO OPERATING LLC, 21 Lawrence Paquette Industrial Drive, Champlain, New Yo
Inhaltszusammenfassung zur Seite Nr. 2
IMPORTANT SAFEGUARDS When using your iron, basic safety precautions should always be followed, including the following: 1. Read all instructions before using the iron. 2. Use iron only for its intended use. 3. To protect against a risk of electrical shock, do not immerse in water or other liquids. 4. The iron thermostat should always be turned to its lowest position before plugging or unplugging from outlet. Never yank cord to disconnect from outlet, instead grasp plug and pull to disco
Inhaltszusammenfassung zur Seite Nr. 3
SPECIAL INSTRUCTIONS 1. To avoid a circuit overload, do not operate another high-wattage appliance on the same circuit. 2. If an extension is absolutely necessary, a 15-ampere rated cord with a polarized plug should be used. Cords rated for less amperage may overheat. Care should be taken to arrange so that it cannot be pulled on or tripped over. This appliance has a polarized plug (one blade is wider than the other). POLARIZED PLUG As a safety feature, this plug will fit into a polarized o
Inhaltszusammenfassung zur Seite Nr. 4
STEAM STATION Model EP7005 Main Components 1400 watts 120V - 60Hz 1. Temperature Control (Rotate Dial) 2. Steam Control (Rotate Dial) 3. Steam Trigger (Pull) 3A. Steam Trigger Lock 4. Spray Button (Push) 5. Spray Nozzle 6. Burst-of-steam (Push) 7. Temperature Pilot Light (right side) 8. Iron Stand 8A. Water Tank 8B. Water Tank Lock 9. Water Filling Hole 10. Rubber Mat 11. Power Cord 12. Connecting Cord / Supply Hose 13. Internal Spray Water Reservoir 14. Iron 15. Water Pump On/Off Pilot Light 16
Inhaltszusammenfassung zur Seite Nr. 5
Choosing the Ironing Temperature Temperature Setting Diagram Instructions Temperature Steam Shot of Fabric Spray on Label Control Control Steam Synthetic fibers, e.g. acryl, viscose, polyamide 0 (nylon), polyester Silk Wool Cotton MAX Linen MAX Please note that on the label means: "This article cannot be ironed" Ironing Temperature Always check first to see whether a label with ironing instructions is attached to the article to be ironed. (See table above.) Follow these ironing instructions
Inhaltszusammenfassung zur Seite Nr. 6
Before First Use Remove any labels, stickers or tags which may be attached to the body or the soleplate of the iron before using the iron. Read all instructions carefully. Always follow the Important Safeguards. IMPORTANT The first time an iron is used, some odor and small white particles may come out of the steam vents. This is perfectly normal and will cease to occur after the iron has been in use for a short while. Before you start using your iron, follow the instructions in manual and
Inhaltszusammenfassung zur Seite Nr. 7
Installing the Rubber Mat (10) onto the Iron Stand (8) Please note that during transportation, the rubber mat (10) may come off its place. • The iron stand (8) has 5 holes on the circumference of its top. • The rubber mat (10) has 5 pins in the corresponding locations. • Place the rubber mat (10) on top of the iron stand (8) and push each individual pin into its hole. (Fig. 1) IMPORTANT: Never place the hot iron on the plastic iron stand without the rubber mat on top of the iron stand. Fig. 1 4
Inhaltszusammenfassung zur Seite Nr. 8
Filling the Water Tank (8) A Word on Water Our steam irons should be used with tap water up to 3 mmol/l alkaline earth ions (check the degree of hardness of your water with your local water authority) or a mixture of distilled/demineralized water with tap water. If your tap water is very hard, you can mix 1:1 distilled / demineralized water with mineral water so that your steam performance will be good. Never use water containing additives, battery top-up water from service stations, water f
Inhaltszusammenfassung zur Seite Nr. 9
How the Water is Pumped to the Iron 1. The water is pumped from the water tank (8A) to the iron (14) through the supply hose (12) by a built-in water pump. 2. This water pump is activated by pulling on the trigger (3). The water pump pilot light (15) will go on. 3. The water pump will stay activated as long as your finger pulls the trigger (3) or the trigger will stay pulled in permanently if the trigger lock (3A) is pushed backwards. But you will only get steam if the variable steam Control
Inhaltszusammenfassung zur Seite Nr. 10
Ironing With Steam • Make sure that the Steam Station is unplugged from the power source. • Set the variable steam control (2) TO “0”. (Fig. 3) • Fill the water tank (8A) with tap water, following the instructions for filling the water tank. • Make sure that the iron is resting on top of the rubber mat (10). IMPORTANT: Do not place the rubber mat (10) on a table or any other surface which may be damaged by heat. Fig. 3 Fig. 4 • Plug the power cord (11) into the 120 volt AC electrical outlet. •
Inhaltszusammenfassung zur Seite Nr. 11
Anti-Drip Function Steam ironing is only possible at higher temperatures with conventional steam irons. Water may leak from the soleplate if the temperature selected is too low and therefore this may cause stains. The anti-drip shut-off functions as follows: At low temperature, the iron will stop steaming. To avoid the formation of water droplets, when the drip-stop is activated, you will hear a “click” indicating the flow of water has been stopped. Set the temperature control (1) up to th
Inhaltszusammenfassung zur Seite Nr. 12
Burst-Of-Steam Function • By pushing the “Burst-of-Steam” button (6) a powerful shot of steam is emitted from the soleplate. (Fig. 6) • This steam is useful, for example, when removing stubborn creases and can be used during continuous steaming, but do not use burst of steam too often in a short period or you will get water spots.. Fig. 6 Note: The Burst-of-Steam function can only be used while ironing with high ironing temperatures and at an intervals of 5 seconds or you risk water spotting.
Inhaltszusammenfassung zur Seite Nr. 13
Steaming in a Vertical Position • Burst-of-Steam (6) can also be applied when holding the iron in a vertical position. (Fig. 7) this is useful when removing creases from hanging clothes, curtains, etc… The Burst-of- Steam (6) feature can only be used while ironing at high temperatures at an interval of 5 seconds. • The iron is also suitable for continuous vertical steam (and horizontal) but only on maximum temperature. Fig. 7 Water Spraying • You can spray at any temperature by pushing on th
Inhaltszusammenfassung zur Seite Nr. 14
Attaching Iron to the Ironing Board Your Steam Station is equipped with a clamp that can be used to attach the iron stand (8) to your ironing board (or any other suitable surface). (Fig. 10) • Rotate the clamp 90°, so that it points down. • Place the iron stand (8) next to the edge of the table with the clamp on the bottom. • Turn the wing nut clockwise and then tighten it to the ironing board or table. • Reverse the process when finished ironing to remove the Steam Station from the ironing b
Inhaltszusammenfassung zur Seite Nr. 15
Cleaning • Before cleaning, remove the power cord (11) from the wall outlet and allow the iron to cool down sufficiently. • Scale and other deposits can be wiped off the soleplate with a damp cloth and some non-scratching (fluid) abrasive. • Keep the soleplate smooth: avoid hard contact with metal objects. • From time to time clean the inside of the water tank (8A) by filling it with water and shaking. Storage • Remove the power cord (11) from the wall outlet. • Pour any remaining water out o
Inhaltszusammenfassung zur Seite Nr. 16
Iron Troubleshooting PROBLEM POTENTIAL REASON & SOLUTIONS • Iron should be plugged into a 120V AC electrical outlet only. Iron does not work Make sure that the plug is securely in the socket. • Thermostat setting is too low. Turn to higher setting. • This is normal. The light goes On and Off as the thermostat is Thermostat ready light switching the heating element On and Off to maintain the goes On and Off selected temperature. Some odor or small • This is normal. Follow instructions for firs
Inhaltszusammenfassung zur Seite Nr. 17
ONE (1) YEAR LIMITED WARRANTY EURO-PRO OPERATING LLC warrants this product to be free from defects in material and workmanship for a period of one (1) years from the date of the original purchase, when utilized for normal household use, subject to the following conditions, exclusions and exceptions. If your appliance fails to operate properly while in use under normal household conditions within the warranty period, return the complete appliance and accessories, freight prepaid to EURO-PRO Op
