Inhaltszusammenfassung zur Seite Nr. 1
Driveway Racer
Driveway Racer
™
Owner's Manual
with Assembly Instructions
For Models H2836, C0530, C0532
Model C0532
Model H2836
Please read this manual and save
it with your original sales receipt.
Tools needed for assembly: Phillips
Screwdriver and Adjustable Wrench
(tools not included).
®
Use only with a Power Wheels
12 Volt Lead-Acid Rechargeable
®
Battery and Power Wheels
12 Volt Charger with Type “12V”
Connector (included).
Model C0530
Requires one LR44 alkaline
button cell battery for
St
Inhaltszusammenfassung zur Seite Nr. 2
Table of Contents A Important Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 B Warnings and Cautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 C Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 3
Warnings and Cautions B ELECTRICAL HAZARD WARNING • Battery can fall out and injure a child if vehicle tips over. Always use battery cover (clamp). • PREVENT FIRE - Never modify the electrical system. Alterations could cause a fire resulting in serious injury and could also ruin the electrical system. - Use of the wrong type battery or charger could cause a fire or explosion resulting in serious injury. ® ® - Use of Power Wheels components in products other than Power Wheels vehicles could ca
Inhaltszusammenfassung zur Seite Nr. 4
Parts C • If you experience a problem with this product, or are missing a part, please call us at 1-800-348-0751, rather than return this product to the store. • Please identify all parts before assembly and save all packaging material until assembly is complete to ensure that no parts are discarded. • Metal parts have been coated with a lubricant to protect them during shipment. Wipe all metal parts with a paper towel to remove any excess lubricant. Stopwatch Pretend Motor Steering Wheel Batter
Inhaltszusammenfassung zur Seite Nr. 5
Pb Parts Rear Bumper 2 Struts Wing (Left and Right) 12 Volt Battery 2 Flaps 4 Caps 12 Volt Charger (Left and Right) Parts not shown: Label Sheet, Collapsible Pylons, Stencil, and Chalk. Note: Tighten and loosen all screws with a Phillips screwdriver. Do not over-tighten the screws. 3mm x 21mm Screw - 1 1 4 / - 20 x 3" Screw - 2 3mm Lock Nut - 1 1 3 4 / " Washer - 2 4 #8 x / " Screw - 35 1 3 3 /4"- 20 Lock Nut - 2 /16" Washer - 2 .375" Washer - 1 /8" - 16 Lock Nut - 2 (Attached to Steering Col
Inhaltszusammenfassung zur Seite Nr. 6
Pb Parts Diagram D 8 Note: Model C0530 frame 7 shown in illustration below. 6 5 13 11 12 9 4 13 14 1 10 14 15 17 16 2 3 No. Part Quantity No. Part Quantity Parts Not Shown 1 1 Frame 1 10 Pretend Motor 1 /4"- 20 x 3" Screw 2 1 2 Steering Column 1 4 11 Seat 1 / " Washer 2 3 3 Rear Bumper 1 12 Wing 1 /16" Washer 2 1 4 Cowling Cover 1 13 Flap (Left and Right) 2 /4"- 20 Lock Nut 2 3 5 Cowling 1 14 Strut (Left and Right) 2 /8"- 16 Lock Nut 2 3 6 Steering Tube 1 15 Cap 4 #8 x /4" Screw 35 7 Steering Wh
Inhaltszusammenfassung zur Seite Nr. 7
Battery Charging E About Thermal Fuses ELECTRICAL HAZARD ® Your Power Wheels 12 volt battery is equipped with a built-in thermal fuse. The thermal fuse is a self-resetting WARNING safety device which automatically “trips” and shuts down operation of the vehicle if the vehicle is overloaded or the driving conditions too severe. Once a fuse has “tripped”, • Battery can fall out and injure a it will automatically reset itself after approximately child if vehicle tips over. Always use 25 seconds
Inhaltszusammenfassung zur Seite Nr. 8
Battery Charging Assembly F Note: The illustrations in the Assembly section show the model C0530 frame. Assembly is the same for all models (H2836, C0530 and C0532). Battery WARNING Children can be harmed by small parts, sharp edges and sharp points in the vehicle’s unassembled state, or by electrical items. Care should be taken in unpacking and assembly of the vehicle. Children should not handle parts, including the Charger battery, or help in assembly of the vehicle. Connector Cowling Cover 1
Inhaltszusammenfassung zur Seite Nr. 9
Assembly 3 Cowling 5 Assembly 3 #8 x /4" Screws Frame 3 #8 x /4" Bottom View Screws •Turn the frame on its side. 3 • Insert four #8 x /4" screws into the holes in the bottom of the frame and into the cowling assembly. Tighten the screws. • Fit the cowling assembly into the front end of the frame. Steering Tube Hint: Squeeze the cowling assembly slightly (on each 6 Curve Faces side) to fit it inside the frame. Front End 3 of Frame 4 • Insert two #8 x / " screws into the front holes in the cowlin
Inhaltszusammenfassung zur Seite Nr. 10
Assembly 7 9 Steering Wheel Closed End Faces Rear of Frame Steering Column Side View Hand-tighten Bottom View 3 8 •Turn the frame on it’s side. Fit a / " - 16 lock nut onto each end of the steering tube. Make sure the rounded side is facing out. • Hand-tighten the lock nuts. Hint: You will fully-tighten these lock nuts in step 10. •Turn the frame upright. 8 • Position the steering wheel so that the closed end faces the rear of the frame. Fit the steering wheel onto the steering column. •Insert
Inhaltszusammenfassung zur Seite Nr. 11
Assembly 11 13 Rear Bumper Top View 1 • From the top side of the frame, attach a /4" washer and 1 /4" - 20 lock nut to each screw. •Fit the rear bumper onto the rear end of the frame. • While holding the 3" screws steady with a Phillips screw- driver, tighten the lock nuts with an adjustable wrench. 12 3 14 #8 x /4" Screws Pretend Motor 1 /4" - 20 x 3" Screws •Turn the frame upright. • Fit the pretend motor to the top side of the rear bumper. 3 4 • Insert three #8 x / " into the pretend motor an
Inhaltszusammenfassung zur Seite Nr. 12
Assembly 15 17 Left Flap 3 4 #8 x / " Cap Screws Cap Right Flap Wing • Fit a cap over each retainer. Hint:There is a left and right flap. Locate the L on the left 3 • Insert a #8 x /4" screw through each cap and tighten. flap and an R on the right flap. • Repeat steps 16 and 17 to assemble the right strut and •Turn the wing upside down. Fit the flaps to the sides of remaining caps to the wing. the wing. 3 4 • Insert two #8 x / " screws into the inside edge of the wing and each flap. Tighten the
Inhaltszusammenfassung zur Seite Nr. 13
Assembly 19 21 Seat Assembly 3 3 • Slide a /16" washer onto two #8 x /4" screws. 3 • Insert the #8 x /4" screws with washers through the seat and into the wing. Tighten the screws. Hint: The wing is designed to be adjustable. Please refer to page 22 for information on how to adjust the wing. Assembly is now complete. • Fit the seat assembly into the frame. 3 #8 x /4" 3 #8 x /4" Screws 20 Screws 3 • Insert six #8 x /4" screws through the seat and into the frame, as shown. Tighten the screws. 13
Inhaltszusammenfassung zur Seite Nr. 14
Stopwatch Battery Replacement G Stopwatch Battery Compartment Door Shown Actual Size Hint: The stopwatch comes with an alkaline button cell battery. Use the following instructions only to replace the button cell battery. • Loosen the screws in the stopwatch battery compartment door. • Slide the stopwatch into the groove in the steering wheel. • Remove the battery compartment door and the worn LR44 button cell battery. Throw the worn battery away. • Insert a new, alkaline LR44 button cell battery
Inhaltszusammenfassung zur Seite Nr. 15
TM TM Label Decoration H Proper label application will help to keep the labels looking their best! When applying labels, keep the following guidelines in mind: •Wash your hands before applying the labels. • Before applying the labels, wipe the surface of the vehicle with a clean, dry cloth to remove any dust or oils. • Place the labels exactly as shown in the illustrations. • For best results, avoid repositioning a label once it has been applied to the vehicle. • After applying a label, rub the
Inhaltszusammenfassung zur Seite Nr. 16
Label Decoration 9 12 10 11 4 10 6 8 3 5 2 1 7 Left Front View - Model C0532 Right Front View - Model C0532 5 3 1 2 4 6 6 10 10 10 10 10 10 9 8 7 Left Front View - Model C0530 Right Front View - Model C0530 16
Inhaltszusammenfassung zur Seite Nr. 17
Battery Installation I ® IMPORTANT! Use only a Power Wheels 12 volt battery. Use of any other battery will damage your vehicle. Make 3 Tabs sure that you charge the battery for at least 18 hours using ® the enclosed Power Wheels 12 volt charger before operating your vehicle for the first time. Charge the battery for at least 14 hours after each use of the vehicle. Never charge the battery longer than 30 hours. Failure to follow these instructions may damage your battery and will void your warran
Inhaltszusammenfassung zur Seite Nr. 18
Battery Care and Disposal J Care Disposal ® If a battery leak develops, avoid contact with the leaking •Your Power Wheels battery is a sealed lead-acid acid and place the damaged battery in a plastic bag. Please battery. It must be recycled or disposed of in an refer to the information on this page for proper disposal. environmentally sound manner. If acid comes in contact with skin or eyes, flush with cool • Do not dispose of a lead-acid battery in your regular, water for at least 15 minutes a
Inhaltszusammenfassung zur Seite Nr. 19
Rules for Safe Driving K RIDING HAZARD 8. Do not allow any child to drive the vehicle in the dark. A child could encounter unexpected obstacles and WARNING have an accident. Operate the vehicle only in the daytime or a well-lit area. Prevent Injuries and Deaths 9. Do not allow your child to drive on steep inclines. Restrict your child’s driving to generally level ground • Direct Adult Supervision Required. ONLY! • Keep Children Within Safe Riding Areas 10. Do not allow your child to drive down
Inhaltszusammenfassung zur Seite Nr. 20
Go-Kart Racing - Tips, Tricks & Tracks K PERFORMANCE FEATURES GET READY… Heads up! This is no ordinary vehicle. It’s a Hot Wheels™ Go-Kart, designed for speed and meant for racing. Here’s Reset/Clear Button some tips, tricks and track layouts to get you out of the Start/Stop Button gate and enhance go-kart racing thrills. BRAKE Pedal Low Drag Body GO Pedal Performance Compound Tires Removable Stopwatch Super Responsive Steering Steel Ladder Working the Watch Chassis Removable stopwatch sits righ
