Bedienungsanleitung Halfords

Inhaltszusammenfassung zur Seite Nr. 1

Halfords hi 3 bike instructions 6/8/07 12:01 PM Page 1
Metal Clamp High 3 Bike Carrier
Fitting Instructions
Please follow instructions carefully to ensure the safety of yourself and other road users.
The initial assembly and fitting of this carrier will take approximately 15 minutes.
Before you begin:
• Under no circumstances should this carrier be fitted to your car unless it is adjusted to
the exact settings specified in the enclosed vehicle application list. This carrier must
not be fitted

Inhaltszusammenfassung zur Seite Nr. 2

Halfords hi 3 bike instructions 6/8/07 12:05 PM Page 3 INITIAL PREPARATION CARRIER SET-UP Adjuster Plate 1 3 2 REFER TO APPLICATION GUIDE 1 180° 3 Refer to the enclosed application list to find the correct angle for the Fit the thumb screw nuts to the inside face of the angle adjusters, vehicle support arm for your car. Insert the bolts from the outside making sure the bolt passes through the vehicle support arm. Position the assembled carrier on a clean surface as illustrated. firm for both

Inhaltszusammenfassung zur Seite Nr. 3

Halfords hi 3 bike instructions 6/8/07 12:05 PM Page 5 SLIGHTLY 9 10 ABOVE HORIZONTAL FITTING 6 2 1 3 Reposition the cycle support arm so it is positioned slightly above Position your cycle(s) into the saddle area of the frame locator. Pass horizontal. the webbing strap over the frame of the cycle and thread through the metal loop. Pull the strap back tightly and press the hook and loop fastener to secure. Note: there must be a minimum 45mm of overlap (See Diagram). If the straps supplied wi

Inhaltszusammenfassung zur Seite Nr. 4

Halfords hi 3 bike instructions 6/8/07 12:05 PM Page 7 Special Recommendations 13 •Avoid any vehicle bodywork of insufficient • The carrier may obstruct the rear window strength, trim and items such as aerofoils wiper of your vehicle. DO NOT operate the or spoilers. wiper with the carrier fitted. (HINT) Remove fuse for extra safety. • IMPORTANT! Fabric straps should be checked routinely for signs of wear and • When positioning cycles on the carrier abrasion, and any worn straps must be ens