Inhaltszusammenfassung zur Seite Nr. 1
These log sets can be installed in vented or unvented applications. See installation details for the particular application that applies.
1
INSTALLER: THESE INSTRUCTIONS MUST BE CONVEYED TO AND REMAIN WITH THE HOMEOWNER.
INSTALLATION AND
OPERATION INSTRUCTIONS
CERTIFIED UNDER: ANSI Z21.11.2B-2004 GAS FIRED ROOM HEATER : VOLUME II, UNVENTED ROOM HEATERS AND
ANSI Z21.60-2002 / CSA 2.26-2002 DECORATIVE GAS APPLIANCES FOR INSTALLATION IN SOLID-FUEL BURNING APPLIANCES
WARNING
If the information in t
Inhaltszusammenfassung zur Seite Nr. 2
2 TABLE OF CONTENTS 7 Installing In A Vented Application 2 Warnings Damper Stop Installation 3 Warranty 8-9 Operating / Maintenance 4-5 General Instructions Operating Instructions General Information Lighting Instructions Maintenance and Cleaning ODS Pilot Cleaning Air Shutter Match Lighting Instructions Minimum Fireplace Size 10 Log Placement Andiron and Grate Assembly Logo Placement Gas Piping 11 Finishing 6-7 Installing In An Unvented Application Rating Plate Combustion and Ventilation 12 Rep
Inhaltszusammenfassung zur Seite Nr. 3
3 NAPOLEON products are manufactured under the strict Standard of the world recognized ISO 9001:2000 Quality Assurance Certificate. NAPOLEON products are designed with superior components and materials, assembled by trained crafts- men who take great pride in their work. Once assembled the complete log set is thoroughly inspected by a qualified technician before packaging to ensure that you, the customer, receive the quality product that you expect from NAPOLEON. NAPOLEON GAS LOG SET LIMITED WAR
Inhaltszusammenfassung zur Seite Nr. 4
4 GENERAL INSTRUCTIONS GENERAL INFORMATION Do not use this gas log set if any part has been under FOR YOUR SATISFACTION, THIS FIREPLACE HAS BEEN water. TEST-FIRED TO ASSURE ITS OPERATION AND QUAL- ITY! Maximum input is 40,000 BTU/hr for natural gas and Call a qualified service technician to inspect the appliance propane. before operating. Minimum inlet gas supply pressure is 4.5 inches water col- Thoroughly clean the chimney, flue and fireplace before in- umn for natural gas and 11 inches water
Inhaltszusammenfassung zur Seite Nr. 5
5 AIR SHUTTER GAS PIPING This appliance must be isolated from the gas supply pip- LOG SET AIR SHUTTER ing system by closing the individual manual shut off valve during any pressure testing of the gas supply piping sys- NG LP FUEL tem at test pressure equal to or less than ½ psi (3.5 kPa) 9 5 GVFL18 /32" /16" 1. Centre the appliance in the fireplace opening, making 9 5 GVFL24 /32" /16" sure the appliance has enough room behind it for the gas 9 5 GVFL30 /32" /16" line to run behind the log set und
Inhaltszusammenfassung zur Seite Nr. 6
6 INSTALLING IN AN UNVENTED APPLICATION COMBUSTION & VENTILATION DETERMINING CONFINED OR UNCONFINED AIR PROVISIONS SPACE This heater shall not be installed in a confined space or To determine the volume of the room where the heater is to unusually tight construction unless provisions are pro- be installed, multiply the width x the length x the ceiling height vided for adequate combustion and ventilation air. of that room measured in feet. If any adjoining rooms are In order to avoid the possibi
Inhaltszusammenfassung zur Seite Nr. 7
7 Unvented gas heaters are a supplemental zone During manufacturing, fabricating and shipping heater. They are not intended to be the primary various components of this appliance are heating appliance. treated with certain oils, films or bonding Unvented gas heaters emit moisture into the agents. living area. In most homes of average construc- These materials may produce smoke and smells tion, this does not pose a problem. In houses of as they are burned off during the initial extremely tight co
Inhaltszusammenfassung zur Seite Nr. 8
8 OPERATION / MAINTENANCE OXYGEN DEPLETION SENSOR PILOT OPERATING INSTRUCTIONS CLEANING IF THE FIREPLACE IS EQUIPPED WITH DECORATIVE GLASS DOORS, THEY MUST BE FULLY OPENED WHEN OPERATING This procedure must be performed by a qualified service person! THIS GAS LOG SET. Inspect the pilot for any visible contamination or debris (usu- LIGHTING INSTRUCTIONS ally lint, pet hair, spider webs, carpet fibre, etc.) and remove. 7 Disconnect the pilot from the pilot tubing line. Using a /16” 1. Locate the p
Inhaltszusammenfassung zur Seite Nr. 9
O H L I L I I O L P P F F O N O T O 9 FOR YOUR SAFETY READ BEFORE LIGHTING: WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. This fireplace is equipped with a pilot which must be lit WHAT TO DO IF YOU SMELL GAS: by hand while following these instructions exactly. • Do not try to light any appliance. B. Before operating smell all around the fireplace area for • Do not touch any electric switch; do
Inhaltszusammenfassung zur Seite Nr. 10
10 5. Position the holes on the LOG PLACEMENT bottom of #5 on the pin on TM PHAZER logs, exclusive to Napoleon Fireplaces, provide the left end of log #1 and a unique and realistic glowing effect that is different in every the pin on the left end of installation. These logs are fuel specific. Do not log #2. interchange. Refer to the replacement parts list. Failure to follow these log placement instructions may cause sooting. 1. Place the rear log #1 onto the locating studs on the rear log suppor
Inhaltszusammenfassung zur Seite Nr. 11
11 FINISHING GVFL24 1. Place lava or ember rock around the base of the appli- ance, making sure not to block any burner ports or valve access. Retain a small amount of lava rock for step 3 and if applicable step 4. 2. Place formed charcoal lumps around the front and sides of the unit. 3. Use remaining lava or ember rock to blend with the char- coal lumps. GVFL18 GVFL30 4. GVFL30 ONLY: Sprinkle remaining lava rock onto the outer fibre ember beds to hide the seam. RATING PLATE THE RATING PLATE IS
Inhaltszusammenfassung zur Seite Nr. 12
12 REPLACEMENTS Contact your dealer for questions concerning prices and 1. MODEL & SERIAL NUMBER OF FIREPLACE availability of replacement parts. Normally all parts can be 2. INSTALLATION DATE OF FIREPLACE ordered through your Napoleon dealer or distributor. 3. PART NUMBER When ordering replacement parts always give the following 4. DESCRIPTION OF PART information: 5. FINISH FOR WARRANTY REPLACEMENT PARTS, A PHOTOCOPY OF * IDENTIFIES ITEMS WHICH ARE NOT ILLUSTRATED. FOR THE ORIGINAL INVOICE
