Inhaltszusammenfassung zur Seite Nr. 1
ASSEMBLY INSTRUCTIONS
OPERATOR’S MANUAL
PARTS LIST
CLASSIC
Walk-Behind
Leaf Blower
Series 1
Models covered:
Actual product may differ slightly from product pictured above
SLBC55151BV
(Part #3085650)
Manual No. 3071768 (I.R. 2/4/04)
Inhaltszusammenfassung zur Seite Nr. 2
1 preliminaries Congratulations! You have just purchased one of the finest pieces of outdoor power equipment on the market today. If properly cared for, your new blower will provide years of dependable service. Please read and follow this instruction manual carefully in order to get the most out of your new equipment. As you carefully unpack your unit, you will find the following items: 1 Blower Unit 1 Handle Assembly including: 1 – Upper Handle with foam grip 2 – Lower H
Inhaltszusammenfassung zur Seite Nr. 3
2 safety rules regarding outdoor power equipment IMPORTANT! READ CAREFULLY THE FOLLOWING SAFETY RULES BEFORE ASSEMBLING OR OPERATING UNIT. • Operate only in the daylight or with good artificial TRAINING light, keeping away from holes and hidden hazards. • Read, understand, and follow all instructions in the • Be sure of your footing while using pedestrian manual and on the unit before starting. If the controlled equipment, especially when backing up. operator(s) or mechanic(s) can
Inhaltszusammenfassung zur Seite Nr. 4
2 safety rules regarding outdoor power equipment (cont.) • Watch for holes, ruts, or bumps. Uneven terrain • Always follow the engine manual instructions for could overturn the unit. Tall grass can hide storage preparations before storing the unit for both obstacles. short and long term periods. • Keep all movement on the slopes slow and • Always follow the engine manual instructions for gradual. Do not make sudden changes in speed or proper start-up procedures when returning the unit di
Inhaltszusammenfassung zur Seite Nr. 5
3 unit assembly Note: Please refer to Parts List for correct part identification and placement. FRONT WHEEL ASSEMBLY • Attach left and right caster brackets to caster wheel using 3/8-18 x 2-1/4 bolt and lock nut. Insert bolt through hole in bracket. Place caster wheel onto bolt Place other caster bracket onto bolt. Secure with lock nut. Do not over tighten. Wheel must roll freely. Place caster brackets onto the threaded studs located near the discharge on the front of the machi
Inhaltszusammenfassung zur Seite Nr. 6
4 unit operation STARTING THE ENGINE IMPORTANT NOTE: The procedures outlined within this section are general guidelines, and are in no way meant to replace or supercede engine manufacturer’s operating instructions. In order to obtain optimum performance from your engine, refer to your engine manual. WARNING! IMPELLER IS MOUNTED DIRECTLY TO ENGINE SHAFT – STARTING ENGINE WILL RESULT IN IMMEDIATE HIGH-VELOCITY DISCHARGE. TO AVOID INJURY OR DAMAGE, BE SURE DISCHARGE IS POINTED AWAY FR
Inhaltszusammenfassung zur Seite Nr. 7
4 unit operation (cont.) STARTING THE ENGINE (cont.) • Bracing unit with one hand on the upper handle and one foot on the right rear tire, firmly grasp recoil handle and pull briskly. You may have to pull several times before engine starts. (If RECOIL HANDLE engine fails to start within a reasonable amount of time, discontinue and check engine manual for further instructions.) Note: Do not allow recoil rope to snap back into recoil; damage to the rope or recoil could result. PUL
Inhaltszusammenfassung zur Seite Nr. 8
4 unit operation (cont.) GENERAL RULES TO OBSERVE BEFORE AND DURING OPERATION: • Inspect your unit before each and every use. Check for worn, bent or broken components, loose fasteners, low or flat tires, etc., and repair or replace prior to operation. DO NOT OPERATE A MACHINE THAT IS WORN OR DAMAGED – SERIOUS INJURY OR DEATH CAN RESULT. • Clear the entire work area of all debris that could cause damage to or become entangled in the unit. Rocks and large branches can wedge them
Inhaltszusammenfassung zur Seite Nr. 9
5 maintenance BEFORE MAKING ANY ADJUSTMENTS, STOP ENGINE AND DISCONNECT SPARK PLUG WIRE TO PREVENT INADVERTENT STARTING OF UNIT. GENERAL: • Follow implicitly the engine manufacturer’s recommendations for maintenance. • Always keep your machine clean - especially the engine. Check all adjustments periodically. Also, periodically check that all fasteners are secure. • Never make any adjustments to the unit until the engine is off and the spark plug wire is disconnected. • If car
Inhaltszusammenfassung zur Seite Nr. 10
5 maintenance (cont.) BEFORE MAKING ANY ADJUSTMENTS, STOP ENGINE AND DISCONNECT SPARK PLUG WIRE TO PREVENT INADVERTENT STARTING OF UNIT. TROUBLESHOOTING: • UNIT WILL NOT START: • Check fuel and oil levels. • Check to make sure choke is set when engine is cold, off when hot. • Check throttle for proper operation. • Check intake baffle for jammed debris or accumulation of debris. • If condition persists, contact dealer. • UNIT STALLS: • Check fuel and oil levels.
Inhaltszusammenfassung zur Seite Nr. 11
6 illustrated parts list
Inhaltszusammenfassung zur Seite Nr. 12
6 illustrated parts list (cont’d) Item Part No. Qty Description 1 3010003 1 WELDMENT, Base & Housing 52 Classic 2 3021506 1 WELDMENT, Impeller Steel 4 Blade 15.00 O.D. 3 90167 1 SCREW, 3/8-24 x 2" Hex Head Cap, GR5 4 3020234 1 WELDMENT, Intake Baffle 5 91511 8 NUT, 5/16-18 Hex, GR5 or B 6 91315 10 WASHER, 5/16" Split Lock 7 3024507 1 DEFLECTOR, Side Air 8 90188 8 WASHER, .34 x .69 x .08 Flat 9 13010 1 DECAL, Danger, Cut Finger 10 3024508 1 WELDMENT, Door Front/Side Discharge 11 9149
Inhaltszusammenfassung zur Seite Nr. 13
6 illustrated parts list (cont’d) 42 90391 4 WASHER, 5/16" Internal Tooth Lock 43 3071776 4 KNOB, Folding Handle 44 46465 1 GUIDE, Rope 45 90372 1 NUT, 1/4-20 Hex Center Lock, GR5 or B 46 3071800 1 THROTTLE CONTROL, B&S 47 90505 1 SCREW, 1/4-20 x 2" Hex Head Cap, GR5 48 76978 1 NUT, 1/4-20 Hex Nyloc 49 1717312 4 WASHER, 5/16" Curved \
Inhaltszusammenfassung zur Seite Nr. 14
NOTES __________________________________________________________________________ __________________________________________________________________________ __________________________________________________________________________ __________________________________________________________________________ __________________________________________________________________________ __________________________________________________________________________ _____________________________________
Inhaltszusammenfassung zur Seite Nr. 15
NOTES __________________________________________________________________________ __________________________________________________________________________ __________________________________________________________________________ __________________________________________________________________________ __________________________________________________________________________ __________________________________________________________________________ _____________________________________
Inhaltszusammenfassung zur Seite Nr. 16
ASSEMBLY INSTRUCTIONS OPERATOR’S MANUAL PARTS LIST CLASSIC Walk-Behind Leaf Blower Series 1 McDonough, GA 30253 U.S.A. Manual No. 3071768 (I.R. 2/4/04)
