Bedienungsanleitung Fluke 80K-15

Inhaltszusammenfassung zur Seite Nr. 1

®
Performance Test
80K-15
Verify the accuracy of the probe by measuring a 15 kV dc
(± 0.25 %) voltage source. When used with a compatible Electronic Air Cleaner Probe
dc voltmeter, the probe should measure the source with
± 1% accuracy. No calibration adjustments are needed.
Instruction Sheet
Warranty
Introduction
LIMITED WARRANTY & LIMITATION OF LIABILITY
The 80K-15 Electronic Air Cleaner Probe (hereafter referred
This Fluke product will be free from defects in material
to as “the probe”) is

Inhaltszusammenfassung zur Seite Nr. 2

80K-15 Electronic Air Cleaner Probe 4. Connect the alligator clip of the probe’s grounding lead Symbols to earth ground. Double insulated. T 5. Touch the probe tip to the circuit being measured and read the measurement on the meter display. If Refer to explanation in this instruction sheet. W necessary, apply a correction factor to the reading. (See “Note” in the “Specifications,” below. Lethal voltages may be present. X Table 1. 80K-15 Circuit Loading and Input/Output Complies with relevant Can

Inhaltszusammenfassung zur Seite Nr. 3

® Performance Test 80K-15 Verify the accuracy of the probe by measuring a 15 kV dc (± 0.25 %) voltage source. When used with a compatible Electronic Air Cleaner Probe dc voltmeter, the probe should measure the source with ± 1% accuracy. No calibration adjustments are needed. Instruction Sheet Warranty Introduction LIMITED WARRANTY & LIMITATION OF LIABILITY The 80K-15 Electronic Air Cleaner Probe (hereafter referred This Fluke product will be free from defects in material to as “the probe”) is