Bedienungsanleitung Renesas R8C/27

Inhaltszusammenfassung zur Seite Nr. 1

Renesas Starter Kit for R8C/27
Quick Start



LCD module

E8a header

Application Board Interface
Reset switch
LCD module
connector
LIN connector


E8a emulator
Application Board Interface


Analog adjust
User LEDs

User switches










D007284_11_S01_V04

Inhaltszusammenfassung zur Seite Nr. 2

1. Installation Do not connect the E8a emulator hardware until the software support has been installed. 1. Insert the CD into your computer’s CD-ROM drive. The CD should automatically run the installation program. If the installer does not start, browse to the CD root folder and double click on “setup.exe”. 2. The installer will ask you which language is to be used, please choose the appropriate one. 3. On the first screen of the installer proper, click . 4. The License Agreement w

Inhaltszusammenfassung zur Seite Nr. 3

26. Select the Debug build configuration in the left hand drop down list on the toolbar. 27. Click on the “Build” icon to compile, assemble and link the project. 4. Programming and Debug 28. Ensure the “SessionR8C_E8a_SYSTEM” session in the right hand drop down list on the toolbar is selected. 29. Click the button on the debug toolbar. 30. The “Emulator mode” dialog will be shown. Select the correct MCU group and device type (e.g. R8C/27 Group and R5F21276 fo

Inhaltszusammenfassung zur Seite Nr. 4

37. Right click on the download module listed in the left hand pane and select “Download”. The code will be downloaded to the microcontroller. This may take several seconds. 38. Click the button. The code will run and you will see the LEDs flash on the board. 39. Click the button. The code will stop and the source code will be opened at the current program counter. 5. Next Step After you have completed this quick start procedure, please review the tutoria