Inhaltszusammenfassung zur Seite Nr. 1
R
P/I-XP55T2P4
Pentium Motherboard
USER'S MANUAL
Inhaltszusammenfassung zur Seite Nr. 2
USER'S NOTICE No part of this product, including the product and software may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any lan- guage in any form by any means without the express written permission of ASUSTeK COMPUTER INC. (hereinafter referred to as ASUS) except documentation kept by the purchaser for backup purposes. ASUS provides this manual "as is" without warranty of any kind, either express or implied, including but not limited to the implie
Inhaltszusammenfassung zur Seite Nr. 3
ASUS CONTACT INFORMATION ASUSTeK COMPUTER INC. Marketing Info: Address: 150 Li-Te Road, Peitou, Taipei, Taiwan, ROC Telephone: 886-2-894-3447 Fax: 886-2-894-3449 Email: info@asus.com.tw Technical Support: Fax: 886-2-895-9254 BBS: 886-2-896-4667 Email: tsd@asus.com.tw WWW: http://www.asus.com.tw/ Gopher: gopher.asus.com.tw FTP: ftp.asus.com.tw/pub/ASUS ASUS COMPUTER INTERNATIONAL Marketing Info: Address: 721 Charcot Avenue, San Jose, CA 95131, USA Telephone: 1-408-474-0567 Fax: 1-408-474-0568 Ema
Inhaltszusammenfassung zur Seite Nr. 4
CONTENTS I. INTRODUCTION........................................................1 How this manual is organized .......................................................... 1 Item Checklist .................................................................................. 1 Features of This Motherboard .......................................................... 2 II. FEATURES .................................................................2 Parts of the Motherboard ...............................
Inhaltszusammenfassung zur Seite Nr. 5
CONTENTS BIOS Features Setup ................................................................30 Details of BIOS Features Setup:......................................... 31 Chipset Features Setup ............................................................. 33 Power Management Setup........................................................ 36 Details of Power Management Setup: ................................ 37 PNP and PCI Setup .................................................................. 39
Inhaltszusammenfassung zur Seite Nr. 6
FCC & DOC COMPLIANCE Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provid
Inhaltszusammenfassung zur Seite Nr. 7
I. INTRODUCTION How this manual is organized This manual is divided into the following sections: I. Introduction: Manual information and checklist II. Features: Information and specifications III. Installation: Instructions on setting up the motherboard IV. BIOS Setup: BIOS software setup information V. ASUS DMI Utility: BIOS supported Desktop Management Interface VI. ASUS PCI-SC200: Installation of an optional SCSI card VII. ASUS I-A16C: Installation of an optional Audio card VIII. DOS/Win3.1x
Inhaltszusammenfassung zur Seite Nr. 8
II. FEATURES (Features) II. FEATURES Features of This Motherboard The ASUS P/I-XP55T2P4 is carefully designed for the demanding PC user who wants a great many features in a small package. This motherboard: • Easy Installation: Is equipped with BIOS that supports auto detection of hard drives and Plug and Play to make setup of hard drives and expansion cards virtually automatic. • Multi-Processor/Multi-Speed Support: Supports one Pentium (75-200MHz), Cyrix P166+ (Rev 2.7 or later), or AMD-K5
Inhaltszusammenfassung zur Seite Nr. 9
II. FEATURES • PCI Bus Master IDE Controller: Comes with an onboard PCI Bus Master IDE controller with two connectors that supports four IDE devices in two chan- nels, provides faster data transfer rates, and supports Enhanced IDE devices such as Tape Backup and CD-ROM drives. This controller supports PIO Modes 3 and 4 and Bus Master IDE DMA Mode 2. BIOS supports IDE CD-ROM or SCSI boot-up. • Optional IrDA: This motherboard supports an optional infrared port module for wireless interface. P
Inhaltszusammenfassung zur Seite Nr. 10
III. INSTALLATION (Map of Board) III. INSTALLATION Map of the ASUS Motherboard CPU Vcore Volt (2.5-2.9) 2.5 2.7 2.8 2.9 JP1 Res. CPU Volt (STD/VRE) 256KB/512KB Onboard L2 Cache CPU ZIF Socket 7 Bus Freq. Freq. Ratio JP12 JP9 JP10 JP13 L2 Cache (256/512) JP14 Memory Cached (64/512) JP15 SIMM Socket 4 (Bank 1) SIMM Socket 3 (Bank 1) SIMM Socket 2 (Bank 0) SIMM Socket 1 (Bank 0) PCI Slot 1 Universal Serial Bus JP16 Multi-I/O (En/Dis) PCI Slot 2 Super Multi-I/O PCI Slot 3 CR2032 MediaBus 2.0 3 V
Inhaltszusammenfassung zur Seite Nr. 11
III. INSTALLATION Jumpers 1) JP14 p. 7 Total Level 2 Cache Size Setting (256KB/512KB) 2) JP18 p. 7 Flash ROM Boot Block Program (Enable/Disable) 3) JP15 p. 8 Memory Cacheable Size (64MB/512MB) 4) JP16 p. 8 SMC37C669 Multi-I/O Selection (Enable/Disable) 5) JP17 p. 9 CMOS RAM (Operation/Clear CMOS Data) 6) JP19 p. 9 Battery Test Jumper (Operation/Test Mode) 7) JP9, JP10 p. 10 CPU External Clock (BUS) Frequency Selection 8) JP12, JP13 p. 10 CPU:BUS Frequency Ratio 9) JP1 p. 11 Single Power Plane Vo
Inhaltszusammenfassung zur Seite Nr. 12
III. INSTALLATION (Jumpers) III. INSTALLATION Installation Steps Before using your computer, you must complete the following steps: 1. Set Jumpers on the Motherboard 2. Install DRAM and SRAM Modules 3. Install the Central Processing Unit (CPU) 4. Install Expansion Cards 5. Connect Ribbon Cables, Cabinet Wires, and Power Supply 6. Setup the BIOS Software 1. Jumpers Several hardware settings are made through the use of jumper caps to connect jumper pins (JP) on the motherboard. See "Map of the M
Inhaltszusammenfassung zur Seite Nr. 13
JP14 JP14 III. INSTALLATION Jumper Settings 1. Total Level 2 Cache Size Setting (JP14) This jumper sets the total amount of L2 cache that is present. If you have both onboard cache chips (see "Map of Motherboard" for locations) and a Cache Expansion Slot, then you have 256KB. If you only have onboard cache chips, then you have 512KB. An "ASUS" or "COAST" cache module can be used to upgrade the 256KB version to 512KB. If there is no onboard cache, you may install a cache module of either 256
Inhaltszusammenfassung zur Seite Nr. 14
JP16 JP15 JP16 JP15 III. INSTALLATION (Jumpers) III. INSTALLATION 3. Memory Cacheable Size (JP15) The default of 64MB uses only the onboard TAG SRAM which allows cacheable memory up to 64MB. If you install DRAM above 64MB and wish to allow cacheable memory above 64MB, you need to install a TAG SRAM upgrade or use a cache module with an extended TAG SRAM (such as 256KB ASUS CM1 Rev 3.0 with 2 TAG SRAM's) but not both and set this jumper to 512MB. See page 12 for TAG SRAM upgrade and page 14 fo
Inhaltszusammenfassung zur Seite Nr. 15
III. INSTALLATION 5. CMOS RAM (JP17) This clears the user-entered information stored in the CMOS RAM of the Real Time Clock such as hard disk information and passwords. To clear the CMOS data: (1) Turn off the PC, (2) Set jumper to "Clear," (3) Power on the PC, (4) Turn off the PC, (5) Set jumper to "Operation," (6) Power on the PC, (7) Hold down during bootup and enter BIOS setup to re-enter user information. Selections JP17 Operation [1-2] (Default) Clear CMOS Data [2-3] (momenta
Inhaltszusammenfassung zur Seite Nr. 16
JP12 JP9 JP13 JP10 JP12 JP9 JP13 JP10 JP12 JP9 JP13 JP10 JP12 JP9 JP13 JP10 III. INSTALLATION (Jumpers) III. INSTALLATION 7. CPU External Clock (BUS) Frequency Selection (JP9, JP10) These jumpers tells the clock generator what frequency to send to the CPU to allow the selection of the CPU’s External frequency (or BUS Clock). The BUS Clock times the BUS Ratio equals the CPU's Internal frequency (the advertised CPU speed). 8. CPU to BUS Frequency Ratio (JP12, JP13) These jumpers set the freque
Inhaltszusammenfassung zur Seite Nr. 17
2.5V 2.7V 2.8V 2.9V Res. III. INSTALLATION 9-10. Single/Dual Power Plane CPU Voltage Regulator Selections The following jumpers set the voltage supplied to the CPU. Determine whether your CPU has a Single Power Plane or Dual Power Planes and then the volt- age that it uses. When a single power plane CPU is installed, the dual power plane selections will be automatically disabled. When a dual power plane CPU is installed, the single power plane selections will be automatically disabled. You ma
Inhaltszusammenfassung zur Seite Nr. 18
III. INSTALLATION (Memory) III. INSTALLATION 2. System Memory (DRAM & SRAM) This motherboard supports four 72-pin SIMMs of 4MB, 8MB, 16MB, 32MB, or 64MB to form a memory size between 8MB to 256MB. The DRAM can be either 60ns or 70ns Fast Page Mode (Asymmetric or Symmetric) or EDO. To support ECC, you must use true (opposed to phantom parity generated by logic chips) 36-bit parity-type DRAM (e.g. 8 chips + 4 parity chips) in pairs for all modules. Mixing 32-bit non-parity DRAM (e.g. 8 chips)
Inhaltszusammenfassung zur Seite Nr. 19
III. INSTALLATION DRAM Memory Installation Procedures: 1. The SIMM memory modules will only fit in one orientation as shown because of a "Plastic Safety Tab" on one end of the SIMM sockets which requires the "Notched End" of the SIMM memory modules. 1234 Notched End Bank 0 Bank 1 72 Pin SIMM DRAM Sockets & Module 2. Press the memory module firmly into place starting from a 45 degree angle making sure that all the contacts are aligned with the sockets. 3. With your finger tips, rock the memory mo
Inhaltszusammenfassung zur Seite Nr. 20
III. INSTALLATION (SRAM Cache) III. INSTALLATION Static RAM (SRAM) for Level 2 (External) Cache The motherboard you purchase may have either 0KB, 256KB, or 512KB onboard. If you have both onboard cache chips (see "Map of Motherboard" for locations) and a Cache Expansion Slot, then you have 256KB. If you only have onboard cache chips, then you have 512KB. An "ASUS" or "COAST" cache module can be used to upgrade the 256KB version to 512KB. If there is no onboard cache, you may install a cache
