Inhaltszusammenfassung zur Seite Nr. 1
™
Installation 30” Built-In Trivection
Instructions Wall Oven
JT930, JT980, ZET3038, ZET3058
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.com
BEFORE YOU BEGIN FOR YOUR SAFETY:
Read these instructions completely • Be sure your oven is installed properly by a
and carefully. qualified installer or service technician.
• Be sure the oven is securely installed in a
•
IMPORTANT — Save these
cabinet that is firmly attached to the house
instructions for local inspector’s use.
s
Inhaltszusammenfassung zur Seite Nr. 2
Installation Instructions PREPARE TO INSTALL THE OVEN TOOLS YOU WILL NEED PARTS INCLUDED Metal Bottom Trim Drill with 1/8” Bit Safety Glasses (Extension may be required) 12 Screws Plastic Bottom Trim Straight Edge or Square Adjustable Wrench OR (for 1-7/16” Nut) Pencil Phillips Screwdriver Level Metal Bottom Trim Assembly Tape Measure Gloves Hand or Sabre Saw MATERIALS YOU MAY NEED Strain Relief Junction Box Wire Nuts Clamp for 1/2” conduit 60” of String for Single Ovens 96” of String for Double
Inhaltszusammenfassung zur Seite Nr. 3
EASY INSTALLATION OF YOUR NEW 30" WALL OVEN B B B B B B B B B B B Be e e e e e e e e e e ef f f f f f f f f f f fo o o o o o o o o o o or r r r r r r r r r r re e e e e e e e e e e e y y y y y y y y y y y yo o o o o o o o o o o ou u u u u u u u u u u u b b b b b b b b b b b be e e e e e e e e e e eg g g g g g g g g g g giii i i ii i i ii in n n n n n n n n n n n- - - - - - - - - - - -R R R R R R R R R R R Re e e e e e e e e e e ea a a a a a a a a a a ad d d d d d d d d d d
Inhaltszusammenfassung zur Seite Nr. 4
Installation Instructions SINGLE BUILT-IN OVEN CUTOUT OPTIONS A WALL MOUNT—SINGLE BUILT-IN OVEN 2 CUTOUT OPTIONS FOR SINGLE OPTION (CONT.) BUILT-IN OVENS NOTE: If the cabinet does not have a front Skip to Step 3 for Double Built-In Oven models. frame and the sides are less than 3/4” thick, There are 4 installation options for single built-in ovens. shim both sides equally to establish the Choose the appropriate one for your application: cutout width. If the cabinet does not have a solid bottom,
Inhaltszusammenfassung zur Seite Nr. 5
Installation Instructions B WALL MOUNT—SINGLE BUILT-IN OVEN C WALL MOUNT—SINGLE BUILT-IN OVEN BELOW AN ADVANTIUM OVEN OPTION ABOVE A WARMING DRAWER OPTION 24” 23 1/2” Min. 30” Min. inside Construct Construct solid bottom solid bottom min. 3/8” min. 3/8” plywood plywood supported by 2 x 4 or 1 Advantium x 2 runners, Oven cutout all four sides cutout 2” Min. 2” Min. Oven cutout Warming drawer cutout A • When installed over a single wall oven, allow at least 2” between the two openings. Bottom of
Inhaltszusammenfassung zur Seite Nr. 6
Installation Instructions SINGLE BUILT-IN OVEN CUTOUT OPTIONS (CONT.) D UNDER COUNTER—SINGLE BUILT-IN OVEN OPTION 3 1/2” 7” 25” Required Junction Box Area Top and/or side fillers may be necessary if unit is positioned between 28 1/2” Min. existing cabinets. Be 28 5/8” Max. sure they are attached 6” Allow 1” overlap securely, since they will 36” Typical top of oven and anchor the oven in the Countertop 27 1/4” Min. 11/16” overlap cabinet. Height 12” 27 5/16” Max. side edges of cutout 24” 3/4” Sup
Inhaltszusammenfassung zur Seite Nr. 7
Installation Instructions DOUBLE BUILT-IN OVEN CUTOUT 3 CUTOUT FOR DOUBLE BUILT-IN 3 CUTOUT FOR DOUBLE BUILT-IN OVEN OVEN (CONT.) Cutout Width If the cabinet does not have a solid bottom, 28 1/2” Min 7” from side cutout 28 5/8” Max. two braces or runners must be installed level with the bottom of the cutout to support the All corners weight of the oven. For double ovens, the must be cut runners and braces must support 375 lbs. square The solid bottom or runners must be level with the bottom of t
Inhaltszusammenfassung zur Seite Nr. 8
Installation Instructions REMOVE THE LOWER OVEN DOOR ON DOUBLE WALL OVEN MODELS ONLY To prevent damage 4 ON DOUBLE WALL OVEN to the door and to MODELS, REMOVE THE LOWER prevent excessive microwave exposure, DOOR ONLY (CONT.): do NOT remove the door on the D Close door to the door removal position, single wall oven or the upper oven which is halfway between the broil stop door on the double wall oven. position and fully closed. NOTE: The oven door is heavy. You may need help lifting the door hi
Inhaltszusammenfassung zur Seite Nr. 9
Installation Instructions ELECTRICAL CONNECTIONS ELECTRICAL REQUIREMENTS ATTENTION INSTALLER This appliance must be supplied with the All electric wall ovens must be hard wired proper voltage and frequency, and connected (direct wired) into an approved junction box. to an individual, properly grounded branch A plug and receptacle is NOT permitted on circuit, protected by a circuit breaker or fuse these products. having amperage as noted on rating plate. DO NOT shorten the flexible conduit. The
Inhaltszusammenfassung zur Seite Nr. 10
Installation Instructions ELECTRICAL CONNECTIONS (CONT.) 5 TURN OFF ELECTRICITY 7 NEW CONSTRUCTION AND FOUR-CONDUCTOR BRANCH Turn off the circuit breaker or remove fuses to the oven branch circuit. CIRCUIT CONNECTION • When installing in new construction, or • When installing in a mobile home, or • When installing in a recreational vehicle, or CONNECT CONDUIT 6 • When local codes do not permit grounding With the oven supported on a table or through neutral: platform in front of the cabinet openi
Inhaltszusammenfassung zur Seite Nr. 11
Installation Instructions 8 THREE-CONDUCTOR BRANCH CIRCUIT CONNECTION When connecting to a three-conductor branch circuit, if local codes permit: Connect the bare oven ground conductor A with the crimped neutral (white) lead to the branch circuit neutral (white or gray in color), using a wire nut. Ground and Neutral Wires Junction Box Cover Connect the oven red lead to the branch B circuit red lead in accordance with local codes, using a wire nut. Connect the oven black lead to the C branch circ
Inhaltszusammenfassung zur Seite Nr. 12
Installation Instructions SECURE THE OVEN IN THE OPENING 9 SLIDE THE OVEN INTO THE 10 DRILL THE PILOT HOLES AND OPENING MOUNT THE OVEN A Loop (do not tie) the correct length of NOTE: Before drilling the pilot holes, make string around the conduit before the sure the oven is pushed as far back into the oven is slid into place. This will keep the opening as it will go, is level and is centered. conduit from falling improperly behind Drill six 1/8” pilot holes through the A the oven. For the single
Inhaltszusammenfassung zur Seite Nr. 13
Installation Instructions To install a single metal bottom trim assembly (on some models), see Step 11. To install a metal bottom trim with a plastic bottom trim (on some models), see Steps 11 and 12. INSTALL THE METAL 11 12 INSTALL THE PLASTIC BOTTOM BOTTOM TRIM TRIM (ON SOME MODELS) A With oven installed, take the bottom trim A Make sure flat side is up on the plastic and center it on the bottom front edge of bottom trim. the cabinet opening. Find the key slot on the back of the trim. B B Usi
Inhaltszusammenfassung zur Seite Nr. 14
Installation Instructions REPLACE THE LOWER OVEN DOOR ON DOUBLE WALL OVEN MODELS 13 ON DOUBLE WALL OVEN MODELS, REPLACE THE LOWER DOOR: A Firmly grasp both sides of the door at the top. Hinge arm Bottom edge of slot Indentation B With the door at the same angle as the removal position, seat the indentation of the hinge arm into the bottom edge of the hinge slot. The notch in the hinge arm must be fully seated into the bottom of the slot. Fully open the door. If the door will not C fully open
Inhaltszusammenfassung zur Seite Nr. 15
Installation Instructions FINAL CHECKLISTS 14 PRE-TEST CHECKLIST 15 OPERATION CHECKLIST A Remove all protective film. A Remove all items from the inside of the oven. Check to be sure that all wiring is B secure and not pinched or in contact Check that conduit is securely connected B with moving parts. to the junction box. Check that the bottom trim is installed Turn on the power to the oven. (Refer C C properly (see Steps 11 and 12). to your Owner’s Manual.) Verify that the bake and broil func
Inhaltszusammenfassung zur Seite Nr. 16
Printed in the United States 16
