Resumen del contenido incluido en la página 1
Resumen del contenido incluido en la página 2
1. Safety Guidelines Caution: Always use a power cable is properly grounded. Please use the AC cords listed below for each area: USA ..................... UL Canada ................ CSA/cUL FCC Information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
Resumen del contenido incluido en la página 3
IMPORTANT SAFEGUARDS Important Safeguards Before using your TV, please read these instructions completely, and keep this manual for future reference. Carefully observe and comply with all warnings, cautions and instructions placed on the unit or described in the operating instructions or service manual. The User Manual uses the following symbols to ensure a safe operation and prevent any damage to operators or properties: WARNING----- Ignorance or inappropriate use may cause dam
Resumen del contenido incluido en la página 4
Never use a damaged power cord: Heavy objects, heat, or tensile force may damage the power cord and cause fire or electric shock. Never block or cover the slots or openings in the TV cabinet back, bottom, and sides. Never place the TV: - on a bed, sofa, rug, or similar surface; - too close to drapes, curtains, or walls; or - in a confined space such as bookcase, built-in cabinet, or any other place with poor ventilation. The slots and openings are provided to protect the TV from overheating
Resumen del contenido incluido en la página 5
IMPORTANT SAFEGUARDS The power cable should be kept away from heat sources: The heat produced by any heat source may melt the covering of the power cable. Unplug the connector Hold the power connector when removing the power cable: Pulling the power cable itself may damage the wires inside the cable and cause fire or electric shock. Do not touch the connector with wet hands: To avoid risk of electric shock. ATTENTION Insert batteries in accordance with instructions: Insert the batteries with co
Resumen del contenido incluido en la página 6
Others: 1). The LCD panel on this TV is manufactured using an extremely high level of precision technology; however, an occasional pixel (dot of light) may display constantly on the screen. This is a structural property of LCD technology and is not a sign of malfunction. Such pixels are not visible when the picture is viewed from a normal viewing distance. 2). LCD (Liquid Crystal Display) may cause interference in image, sound, etc. of the other electronics that receive ele
Resumen del contenido incluido en la página 7
CONTENTS IMPORTANT SAFEGUARDS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that product heat. 9. Do not def
Resumen del contenido incluido en la página 8
Contents Important Safeguards ......................................................................................2 1. Before use ...................................................................................................8 1.1 Open the Package ......................................................................................8 1.2 Installation ...................................................................................................8 2. Product Features ................
Resumen del contenido incluido en la página 9
PRODUCT FEATURES ACCESSORIES BEFORE USE 1. Before use The product is a 32” XGA (XGA resolution) LCD TV. It has passed the UL and cUL safety certifications, and is an ideal product for personal and commercial use. The product is a precise electronic product. Users should read the following instructions carefully to maximize the performance and life span of the product: 1.1 Open the Package - The product is packaged in a carton together with other standard accessories. Any optional
Resumen del contenido incluido en la página 10
2. Product Features The 32˝ LCD TV provides quality image displays and is suitable for a variety of multi media applications: 1. Available input signals - The standard PC module provides VGA (D-SUB 15 PIN), and DVI (with HDCP) input connectors. The product supports PC mode image resolutions up to (1280 x 1024@60Hz) with a vertical frequency of 60 Hz. - The Video module provides composite video (RCA), S-video (DIN 4 PIN) and component video (RCA) input connectors. It suppo
Resumen del contenido incluido en la página 11
NAMES AND FUNCTIONS OF PARTS----FRONT VIEW----REAR VIEW 4. Names and Functions of Parts 4.1 Front View Sketch map IR POWER VOL. CH. SOURCE MENU STANDBY Push the power switch (O: Off, I: On). (IR) Infrared Receiver: Receives IR signals from the remote control. (Power on / Standby) LED: Press (Power) to turn on and off. Indicator on (Red) Standby mode Indicator on (Green) Power on mode The functions of the buttons are described as f
Resumen del contenido incluido en la página 12
4.2 Rear View Sketch map Use the included power cord and connect to an earthed 100-240V, 50/60Hz AC outlet. Signal input and other terminals: . DVI(HDCP) Audio INPUT: Connect to the audio L and R output jacks of a device with DVI Audio output. . ANT In: Connect antenna or cable 75 Ohm coaxial Aerial to receive TV/CABLE signal. . DVI(HDCP) INPUT: Connect to the digital video output jack of a device with DVI output. . VGA Audio INPUT: Connect the audio terminal to the
Resumen del contenido incluido en la página 13
REMOTE CONTROL 4.3 Remote Control Power ( ): Press to turn on and off. Mute ( ): Press to mute the sound. Press again or press VOL+ / VOL- to restore the sound. 0~9 Number Buttons: Press 0~9 to select a channel; the channel changes after 2 seconds. PIP POS: Press to change the PIP window position under PIP mode. SOURCE: Press to select the signal source, such as TV, AV, S-Video, Component 1, Component 2, DVI or VGA. SLEEP: Press repeatedly unti
Resumen del contenido incluido en la página 14
Add/Erase: Press to add or delete favorite channel. SOUND: Press repeatedly to cycle through the sound mode: Normal, News, Cinema, Flat and User. PIC SIZE: Press repeatedly to cycle through the picture size that best corresponds your viewing requirements: Normal, Full, Wide1, Wide2, Wide3, 4:3, No scale, and Panoramic . When in POP mode available picture sizes are: Full, 4:3 and Normal. P.MODE: Press repeatedly to cycle through the picture mo
Resumen del contenido incluido en la página 15
CONNECT ACCESSORY DEVICES REMOTE CONTROL Range of Remote Control Sketch map 20° 20° 30° 30° - Ensure the remote control is pointed towards the remote control window on the display unit. - No obstacles should be placed between the remote control and the remote control window. - The effective receiving range for the signal is within 5-8 meters from the front of the remote control window, and 30° to the left or right side and 20° above or below the control window. Care For Remote Co
Resumen del contenido incluido en la página 16
5. Connect Accessory Devices Connecting a DVD player or other equipment Switch off TV and external equipment before connecting cables. 1. Connect a DVD player or other equipment’s Component Video Out Red (Y,Cb,Cr / Y,Pb,Pr) to the TV’s Green Blue corresponding Component In (Y,Cb,Cr / White Red Y,Pb,Pr) jacks on COMP1 or COMP2. 2. Connect a DVD player’s Audio Out to the TV Component L/R jacks. 3. Press POWER to turn on the TV. Turn on external equipment also. 4. Press SOURCE to s
Resumen del contenido incluido en la página 17
CONNECT ACCESSORY DEVICES Connecting the DVD or VCR player devices Switch off TV and external equipment before connecting cables. 1. Connect a DVD or VCR player’s Video Out to the TV’s Video In jack by a Video cable. 2. Connect a DVD or VCR player’s S-VIDEO Red Yellow Out to the TV’s S-VIDEO In jack by a White S-VIDEO cable. 3. Connect a DVD or VCR player’s Audio Out to the TV’s L/R jacks by a Audio cable, in this stage, the S-VIDEO and VIDEO is sharing this L/R Audio
Resumen del contenido incluido en la página 18
Connecting AUDIO OUTPUT jacks to a stereo amplifier Switch off TV and external equipment before connecting cables. 1. Connect the TV Audio Output (R/L) to the White Red stereo amplifier In (R/L). 2. Press POWER to turn on the TV. Turn on external equipment also. Connecting directly to cable or an Stereo Amplifier antenna When using 75 Ω coaxial Aerial: Connect directly to the RF terminal of the tuner. VHF Antenna 1m above UHF Antenna Mixer RF(VHF/UHF) terminal Special Antenna 75 Ω Coaxia
Resumen del contenido incluido en la página 19
POWER ON, OFF SELECTION OF INPUT MODE OTHER FUNCTION 6. Basic Operation 6.1 Power ON/OFF: The Display is in Standby mode POWER - Press the POWER on the remote control or Standby on the control panel to turn on the unit. The power indicator changes from red to green. - Press the POWER on the remote control or Standby on the control panel again to return the display to standby mode. SOURCE The power indicator changes from green to red. Note: Press CH +/- on t
Resumen del contenido incluido en la página 20
Note: - If you don’t want do add/erase this channel to/from the list of favorite, press this button again. - For addition, it will be put at last of the favorite list and the first channel in favorite list will overflow in case of the list is full. SLEEP: - Press repeadtedly until it displays the time in minutes (5 Min, 10 Min, 15 Min, 30 Min, 60Min, 90 Min, 120 Min and OFF) that you want the TV to remain on before shutting off. Note: When in one minute before shutting off. A
