Resumen del contenido incluido en la página 1
OPERATOR’S MANUAL
MODEL STC48V-26BS
MODEL STC52V-23BV
MODEL STC61V-23BV
THIS MANUAL CONTAINS THE OPERATING
INSTRUCTIONS AND SAFETY INFORMA-
TION FOR YOUR SCAG MOWER. READING
THIS MANUAL CAN PROVIDE YOU WITH
ASSISTANCE IN MAINTENANCE AND AD-
JUSTMENT PROCEDURES TO KEEP YOUR
MOWER PERFORMING TO MAXIMUM EFFI-
CIENCY. THE SPECIFIC MODELS THAT THIS
BOOK COVERS ARE CONTAINED ON THE
INSIDE COVER. BEFORE OPERATING YOUR
MACHINE, PLEASE READ ALL THE INFOR-
MATION ENCLOSED.
© 2006 PART NO. 03195
SCAG P
Resumen del contenido incluido en la página 2
WARNING: FAILURE TO FOLLOW SAFE OPERATING PRACTICES MAY RESULT IN SERIOUS INJURY. * Keep all shields in place, especially the grass discharge chute. * Before performing any maintenance or service, stop the machine and remove the spark plug wire and ignition key. * If a mechanism becomes clogged, stop the engine before cleaning. * Keep hands, feet and clothing away from power-driven parts. * Read this manual completely as well as other manuals that came with your mower. * Keep others
Resumen del contenido incluido en la página 3
TABLE OF CONTENTS SUBJECT PAGE Section 1 - General Information 1.1 Introduction .............................................................................................................................1 1.2 Directional Reference.............................................................................................................1 1.3 Servicing the Engine and Drive Train Components ................................................................1 1.3 Symbols .....................
Resumen del contenido incluido en la página 4
TABLE OF CONTENTS (CONT'D) SUBJECT PAGE Section 6 - Adjustments 6.1 Parking Brake Adjustment .................................................................................................... 22 6.2 Travel Adjustments............................................................................................................... 23 6.3 Throttle Control and Choke Adjustments ............................................................................. 24 6.4 Belt Adjustment ......................
Resumen del contenido incluido en la página 5
Section 1 GENERAL INFORMATION Scag approved attachments and accessories: 1.1 INTRODUCTION GC-STC-V, GC-STWC-61V (p/n 9057, p/n 9058) GC-STC-CSV, GC-STWC-CS61V (p/n 9061, p/n 9062) Your mower was built to the highest standards in the industry. Mulch Plate (p/n 9286, 9287, 9288) However, the prolonged life and maximum efficiency of Hurricane Mulch (p/n 9283, 9284, 9285) your mower depends on you following the operating, STC Hitch (p/n 9241) maintenance and adjustment instructions in this manual.
Resumen del contenido incluido en la página 6
ISO Symbols CE Mark SYMBOL DESCRIPTION SYMBOL DESCRIPTION Choke Transmission Parking Brake Spinning Blade 48071S On/Start Spring Tension on Idler Off/Stop Oil Falling Hazard Thrown Object Hazard WARNING FALLING HAZARD USE ONLY SCAG APPROVED RIDING ATTACHMENTS 481109 SEE OPERATOR'S MANUAL 2
Resumen del contenido incluido en la página 7
SYMBOL DESCRIPTION SYMBOL DESCRIPTION Slow Fast Cutting Element - Basic symbol Continuously Variable - Linear Cutting Element - Engage Pinch Point 481039S Hourmeter/Elapsed Operating Hours Cutting Element - Disengage Read Operator's Manual Thown Object Hazard Keep Bystanders Away 3
Resumen del contenido incluido en la página 8
Section 2 SAFETY INFORMATION 2.1 INTRODUCTION Your mower is only as safe as the operator. The signal word “DANGER” denotes that an extremely Carelessness or operator error may result in serious hazardous situation exists on or near the machine that bodily injury or death. Hazard control and accident could result in high probability of death or irrepairable prevention are dependent upon the awareness, concern, injury if proper precautions are not taken. prudence, and proper training of the perso
Resumen del contenido incluido en la página 9
Section 2 7. If the operator(s) or mechanic(s) cannot read English 12. DO NOT add fuel to a running or hot engine. Allow or Spanish, it is the owner's responsibility to explain the engine to cool for several minutes before adding this material to them. fuel. Never fuel indoors or enclosed trailers. 8. DO NOT wear loose fitting clothing. Loose 13. Keep flammable objects (cigarettes, matches, etc.), clothing, jewelry or long hair could get tangled in open flames and sparks away from the fuel ta
Resumen del contenido incluido en la página 10
Section 2 10. Disengage power to cutter deck before crossing roads, 2.4 OPERATION CONSIDERATIONS walks or gravel drives. (CONT'D) 11. Mow only in daylight or good artificial light. 2. Reduce speed and exercise extreme caution on slopes and in sharp turns to prevent tipping or loss of control. Be especially cautious when changing 12. NEVER raise the deck with the blades engaged. directions on slopes. 13. Take all possible precautions when leaving the machine 3. To prevent tipping or loss of cont
Resumen del contenido incluido en la página 11
Section 2 2.5 ROLL-OVER PROTECTION SYSTEM 3. Check the buckle and latch for proper operation and determine if the latch plate is exessively worn, deformed, or of the buckle is damaged or cracked. See Figure 2-1. WARNING: INSPECT BUCKLE & LATCH Seat belt must be securely fastened during operation. Failure to do so could cause serious injury or loss of life. This mower has been designed for good traction and stability INSPECT WEBBING under normal mowing conditions. However, caution must be used wh
Resumen del contenido incluido en la página 12
Section 2 11. Use jack stands to support components when 2.6 MAINTENANCE CONSIDERATIONS & required. STORAGE 12. Carefully release pressure from components with 1. Never make adjustments to the machine with the stored energy. engine running unless specifically instructed to do so. If the engine is running, keep hands, feet, and clothing away from moving parts. WARNING: 2. Disengage drives, lower implement, set parking Hydraulic fluid is under high pressure. Keep brake, stop engine and rem
Resumen del contenido incluido en la página 13
Section 2 2.7 SAFETY AND INSTRUCTIONAL DECALS 483402 483407 481568 483406 483397 483411 482291 483425 483023 482709 483300 2007 STC &STWC Safety Decals 9
Resumen del contenido incluido en la página 14
Section 3 SPECIFICATIONS 3.1 ENGINE General Type .............................................................................. Heavy Duty Industrial/Commercial Gasoline Brand ......................................................................................... Briggs & Statton Horsepower ............................................................................... 23 HP (Spec.#) (Scag Model STC61V-23BV, STC52V-23BV) 26 HP (Spec.# ) (Scag Model STC48V-26BS) Cylinders 2 with Cast Iron Sleev
Resumen del contenido incluido en la página 15
Section 3 -NOTE- 3.3 TRACTOR (CONT'D) The machine will travel at 10 mph for Travel Speed: transport purposes. For best cutting Forward ................................................................................. 0-10 MPH performance the forward travel speed Reverse .................................................................................. 0-5 MPH should be adjusted depending upon the cutting conditions. 3.4 CUTTER DECK Type: ........................
Resumen del contenido incluido en la página 16
Section 4 OPERATING INSTRUCTIONS 1. Ignition Switch (Figure 4-1). Used to start the engine and has three positions; OFF, ON, and CAUTION: START. Do not attempt to operate this mower unless you have read this manual. Learn the location and 2. Mower Deck Switch (Figure 4-1). Used to purpose of all controls and instruments before you engage and disengage the mower drive system. operate this mower. Pulling up on the switch will engage the deck drive. Pushing down on the switch will disengage the
Resumen del contenido incluido en la página 17
Section 4 DUMP VALVE 5. Hourmeter (Figure 4-1). Indicates the number of CONTROL LEVERS hours the engine has been operated. It operates whenever the ignition key switch is in the ON position. Has preset maintenance reminders for engine and hydraulic system oil changes. Will start flashing scheduled maintenance 2 hours before preset time and continue flashing until 2 hours after. Automatically resets. 6. Fuse Holders (Figure 4-1). Two 20-amp fuses STC 2001 DVC protect the mower’s electrical sys
Resumen del contenido incluido en la página 18
Section 4 6. Turn the ignition key to the START position and 4.3 INITIAL RUN-IN PROCEDURES (First release the key as soon as the engine starts. Do not Day of Use or Approximately 20 Hours) hold the key in the START position for more than 15 seconds at a time. Allow at least 60 seconds 1. Check all belts for proper alignment and wear at 2, 4 between each cranking attempt to prevent and 8 hours. overheating of the starter motor. Prolonged cranking can damage the starter motor and shorten
Resumen del contenido incluido en la página 19
Section 4 To steer the mower right while traveling forward, pull the To steer right while traveling in reverse, allow the right right steering control lever back. The further the lever is steering control lever to move forward. The further the pulled back, the quicker the mower will turn right. control is allowed to move forward, the quicker the mower will turn right. -NOTE- Smooth operation of the steering levers will To stop the reverse travel, allow the steering control produce smooth mower
Resumen del contenido incluido en la página 20
Section 4 3. To disengage the deck drive, push the switch in to the 4.8 PARKING THE MOWER disengage position. 1. Park the machine on a flat, level surface only. Do not 4. Always operate the engine at full throttle to properly park the machine on an incline. maintain cutting speed. If the engine starts to lug down, reduce the forward speed and allow the 2. Place the steering control levers in the neutral engine to operate at maximum RPM. position. 3. Disengage the cutter blades. 4.7 HILLSIDE OPE
