Manual de instrucciones de Stiga TURBO 55 S ROLLER

Resumen del contenido incluido en la página 1

STIGA TURBO
55 S ROLLER
48 S ROLLER
8211-0324-02

Resumen del contenido incluido en la página 2

S SVENSKA 1 2 2 3 1 3 4 A B 5 6 7 8 2

Resumen del contenido incluido en la página 3

S SVENSKA 9 10 11 12 13 14 Honda Briggs & Stratton 0,15 l. FULL/MAX ADD/MIN 15 16 Briggs & Stratton G I* B* 3 ADD FULL

Resumen del contenido incluido en la página 4

S SVENSKA 17 18 Honda X Y 19 20 21 Briggs & Stratton XTE 22 Honda GCV 23 24 4

Resumen del contenido incluido en la página 5

S SVENSKA 25 26 T 27 40 Nm 5

Resumen del contenido incluido en la página 6

GB ENGLISH SYMBOLS ASSEMBLY The following symbols appear on the machine. LOOSE PARTS IN THE BOX They are there to remind you of the care and 1 ignition key (*) attentionrequiredinuse. 1 battery charger (*) This is what the symbols mean: 1 socket wrench 2nutcaps Warning! Read the Instruction Book and + Instruction books Safety Manual before using the machine. FLAP Install the flap according to fig. 1-2. Warning! Keep onlookers away. Beware of objects being flung out. 1. Insert the shaft into the

Resumen del contenido incluido en la página 7

GB ENGLISH CHECK THE OIL LEVEL VARIATOR CONTROL Check before using the machine that the oil level is When the mower is delivered, the variator cable is between ‘FULL/MAX’ and ‘ADD/MIN’ on the set so that the transmission cannot be damaged. dipstick. The cable may need tightening, see under heading “ADJUSTING VARIATOR CABLE“ in the Remove and wipe off the dipstick (fig. 13, 14). section “MAINTENANCE“. Slide it down completely and tighten it. Unscrew and pull it up again. Read off the oil level. I

Resumen del contenido incluido en la página 8

GB ENGLISH 5. Press the Start/Stop loopG towards the handle. Keep hands and feet away from the NOTE! The Start/Stop loopG must be kept rotating blade. Never put your hand or pressed in to prevent the engine stopping (fig. foot under the blade casing or in the 16). grass ejector while the engine is running. 6a Manual start: Grasp the starter handle and start the engine by pulling briskly on the starter cord. STOPPING THE ENGINE 6b Electric start (*): Start the engine by turning the Theenginemay b

Resumen del contenido incluido en la página 9

GB ENGLISH Do not set the cutting height so low that the OIL CHANGE blade comes into contact with uneven ground. Change the oil when the engine is warm The mower has single-lever control for adjusting and the fuel tank is empty. In order to the cutting height. Pull the lever out, and set the prevent burns, take care while draining cutting height to one of the positions best suited to as the oil is hot. your lawn (fig. 19). Change the oil the first time after 5 hours of operation, and subsequentl

Resumen del contenido incluido en la página 10

GB ENGLISH Change the spark plug if the electrodes are 1. When the clutch loop is released, it should be excessively burnt or if the plug is damaged. The possible to push the mower without any engine manufacturers’ recommendations are as resistance. If this is not the case, screw in the follows: nipple T until the mower can be pushed (fig. 26). Briggs & Stratton: Champion J19LM (RJ19LM), Spark gap 0.76 mm. 2. When the clutch loop is pressedinapprox.2cm Honda: NGK BPR6ES, (position 1), there shou

Resumen del contenido incluido en la página 11

GB ENGLISH To replace the blade, undo the screw (fig. 27). Fit the new blade so that the stamped logo is turned up facing the blade holder (not facing the grass). Reinstall as illustrated. Tighten the screw properly. Tightening torque 40 Nm. When replacing the blade, the blade screw should also be replaced. The guarantee does not cover damage to the blade, blade holder or engine caused by running into obstacles. When replacing the blade, blade holder and blade screw, always use genuine spare par

Resumen del contenido incluido en la página 12

MO WI NG A H E A D GGP Sweden AB · Box 1006 · SE-573 28 TRANÅS www.stiga.com