Manual de instrucciones de Stiga VILLA 107 M

Resumen del contenido incluido en la página 1

STIGA VILLA
92 M
107 M
8211-3037-03

Resumen del contenido incluido en la página 2

1. 2. A C B 3. 4. 5. 6. A+5 A B+5 B 7. 8. 2

Resumen del contenido incluido en la página 3

9. 10. R L L+R Z X Y V W 11. 12. 3

Resumen del contenido incluido en la página 4

GB ENGLISH 2. Remove the locking pin and the outermost flat SYMBOLS washer from the machine’s steering knuckle. The following symbols can be found on the 3. Thread one deck arm onto the steering knuckle. machine to remind you of the care and attention Place the flat washer on the steering knuckle and that are required during use. secure with the locking pin. Repeat on the other The symbols mean: side (fig. 2). Warning! 4. Force the V-belt onto the machine’s pulley A Read the instruction manual a

Resumen del contenido incluido en la página 5

GB ENGLISH 5. After setting, tighten the screws properly. cutting deck can be folded up: 1. Set the cutting height setting to the maximum cutting height. USE 2. Lift the rear edge of the deck with one hand (fig. CUTTING HEIGHT 9). The cutting height can be varied between a number 3. Push up the catch and release the rear edge of the of fixed positions, from 30 to 85 mm. deck (fig. 9). Item no. 13-2934: 4. Repeat the procedure on the other side. The cutting height is continuously variable from 5.

Resumen del contenido incluido en la página 6

GB ENGLISH Nm. In the event of a powerful collision, the blades may be bent out. Undo the locking nut X and fold back the blade. Install a new original break bolt V. Tighten the locking nuts X and Z. POSITIVE DRIVE BELT Both blades are powered inside the deck by a positive drive belt. If one of the blades has struck a solid object (e.g. a stone), the belt tension may be altered. This can lead to the positive drive belt ‘over-meshing’ which, in the long term, can damage the blades. Following a po