Resumen del contenido incluido en la página 1
Operator’s Manual
Twin Rear Bagger Kit
Models
190-670-100
and
190-678-100
IMPORTANT: Read safety rules and instructions carefully
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered,
brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state
laws (if any). If a spark arrester is used, it should be maintained in effective working order by th
Resumen del contenido incluido en la página 2
TABLE OF CONTENTS Content Page Important Safe Operation Practices................................................................... 3 Loose Parts ....................................................................................................... 6 Assembly & Operation ....................................................................................... 7 Parts List............................................................................................................ 10 Warranty......
Resumen del contenido incluido en la página 3
SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol—heed its warning. WARNING: The Battery and Engine Exhaust contains chemicals known to the State of C
Resumen del contenido incluido en la página 4
27. Use only accessories and attachments approved for this dump cart, lawn roller, etc.) on slopes greater than 5 machine by the machine manufacturer. Read, degrees. When going down hill, the extra weight tends to understand and follow all instructions provided with the push the tractor and may cause you to loose control. (e.g. accessory or attachment. tractor may speed up, braking and steering ability are 28. Data indicates that operators, age 60 years and above, reduced, attachment may j
Resumen del contenido incluido en la página 5
or trailer bed with a plastic liner. Always place complete stop within approximately (5) five seconds after containers on the ground away from your vehicle operating the blade disengagement control. If the blades before filling. do not stop within the this time frame, your unit should be c. When practical, remove gas-powered equipment serviced professionally by an authorized dealer. from the truck or trailer and refuel it on the ground. 4. Check brake operation frequently as it is subjected
Resumen del contenido incluido en la página 6
SECTION 2: LOOSE PARTS The grass catcher kit is shipped with following loose parts in the carton. Please remove all loose parts from the carton before discarding it. Compare with Figure 1 to check that no parts are missingfrom the kit or have been misplaced during unpacking. Chute Tube Grasscatcher Cover Assembly Support Tube (attached to cover) Mounting Bracket Grass Bag Discharge Chute Assemblies Assembly Clevis Pin & Hairpin Clip For decks with grasscatcher pin not pre-installed G B
Resumen del contenido incluido en la página 7
SECTION 3: ASSEMBLY & OPERATION NOTE: References to LEFT, RIGHT , FRONT and IMPORTANT:There are two holes in the clevis pin. Be REAR of the tractor are from the operator’s position. sure to insert the hairpin clip in the upper hole to Before assembly, place the tractor on a firm and properly secure the bracket assembly to the hitch plate. level surface, disengage the PTO, stop the tractor Attaching the Grasscatcher Cover and Bags engine and set the parking brake. Slide the support tube d
Resumen del contenido incluido en la página 8
Attach the grass bags using the slots shown in Chute Deflector Figure 5. Close the grasscatcher cover. Attaching the Discharge Chute Raise the deck to its highest position. On older models: Remove the clip, if already installed on the deck next to the discharge chute opening, by removing the lock nut, spring washer A and hex bolt that secure it. See Figure 6A. C Hex Lock Cutting Nut B A Deck B C Spring Pin Retainer Strap Washer Clip Figure 7 Place the deck at its lowest position.
Resumen del contenido incluido en la página 9
NOTE: The hex flange nut has a right-handed thread Attaching Blades (Model 190-678 only) pattern. Do NOT attempt to force the nut in the incorrect Remove the blades from your tractor’s cutting deck as direction. Doing so may damage the nut and create a follows. safety hazard. Remove the cutting deck from beneath the tractor, Attach the new blades from the bagger kit as follows: (refer to Deck Removal in the Maintenance section of Install the new blades packed with the bagger. Be your tra
Resumen del contenido incluido en la página 10
SECTION 4: PARTS LIST 17 16 8 14 19 11 6 25 2 7 4 24 3 9 1 18 12 13 11 5 10 5 10 26 23 15 27 20* 21* * Model 190-678 only 10
Resumen del contenido incluido en la página 11
Model 190-678-100 Ref. No. Part No. Description 16587D Support Bracket 1. 16592 Support Assembly: Grasscatcher Cover 2. 3. 664-04017 Cover Assembly: Grasscatcher 710-0751 Hex bolt: 1/4-20 x .620 4. 710-3008 Hex Bolt 5/16-18 x 0.75 5. 6. 710-3015 Hex Bolt 1/4-20 x 0.75 711-0309A Clevis Pin 7. 711-1421 Clevis Pin 9. 10. 712-3004A Flange Lock Nut 712-3027 Lock Nut 1/4-20 11. 714-0117 Hairpin Clip 12. 13. 714-0145 Click Pin 723-04008 Chute Retainer Strap 14. 726-3040 Push Nut 15. 16. 731-04159 Disch
Resumen del contenido incluido en la página 12
MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by Cub Cadet d. Cub Cadet LLC does not extend any warranty for LLC with respect to new merchandise purchased and used in products sold or exported outside of the United States, the United States, its possessions and territories. its possesions and territories, except those sold through Cub Cadet LLC’s authorized channels of Cub Cadet LLC warrants this product against defects for a export distribution. period
