Manual de instrucciones de Snapper Mount Mower

Resumen del contenido incluido en la página 1

SET-UP INSTRUCTIONS & PRE-OPERATION CHECKLIST
SNAPPER ZERO TURNING Z-RIDER with MID MOUNT MOWER

INTRODUCTION: These instructions cover the set-up of the Snapper Mid Mount Z-Rider Mower. Complete each
of the following steps carefully. Review and complete each item as instructed on the Pre-Operation checklist.
The Snapper Product Registration card must be filled out and sent to Customer Service department at Snapper
when completed.

IMPORTANT: The battery for this unit is maintenance-free

Resumen del contenido incluido en la página 2

E. Place 1” blocks under the front and rear edge of the mower deck. BLACK (NEGATIVE) CABLE RED (POSITIVE) CABLE F. Move deck lift lever and set the mower deck to a lower cutting position until deck rests on the 1” blocks. G. Loosen the nuts and bolts that secure both front deck support chains. Adjust chains until tight and retighten bolts and nuts. Torque to 70 ft. lbs. H. Loosen the nuts that secure both rear deck support eyebolts. Adjust to remove slack from both rear

Resumen del contenido incluido en la página 3

K. Check fluid level in reservoirs. Add SAE 20W50 automotive oil as required to bring fluid level to 1- LOOSEN BOLTS. ADJUSTMENT SLIDE PLATE TO 1/2” from top of filler neck. Do Not overfill. PLATE MAKE MACHINE L. Install and tighten filler cap. TRACK STRAIGHT HYDRAULIC RESERVOIRS LEFT SIDE MOTION CONTROL LEVER FIGURE 4 FIGURE 5 STEP 10: HYDRAULIC SYSTEM, PURGING When initially putting hydraulic system into se

Resumen del contenido incluido en la página 4

PRE-OPERATION CHECKLIST Snapper has completed initial adjustments and performed operational tests prior to shipping the machine. Due to the possible effects of shipping, handling and storage, Snapper intends for all of the following items to be verified and necessary final adjustments made at time of setup. It remains good practice and is strongly recommended that all the items also be checked prior to placing the machine into service. It is very important that setup is verified and all op