Manual de instrucciones de Harbor Freight Tools 96141

Resumen del contenido incluido en la página 1

16 LED spotLight
with hanD crank
Model 96141
assEMbL y anD opEration instructions
Due to continuing improvements, actual product may differ slightly from the product described herein.
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
t o prEVEnt sErious injury, rEaD anD unDErstanD
aLL warnings anD instructions bEforE usE.
© ®
Copyright 2007 by Harbor Freight Tools . All rights reserved. No portion of this
manual or any artwork c

Resumen del contenido incluido en la página 2

spEcifications Light Source 16, 12000 MCD LED’s Body: Silver Polypropylene plastic, Lens Bumper: black rubber, Construction Rear Bumper: black rubber, Handle: black polypropylene plastic with black rubber grip, Trigger: black plastic AC/DC Adapter Input 120 V~, 60 Hz, 7 W AC/DC Adapter Output 9 VDC, 300 mA 3FM 2.8, constant voltage charge, Rechargeable Battery cycle use: 7.2-7.5V, standby use: 6.75-6.9V Green (charged) LED Indicators Red (charging) Charging Time 12 Hours Approximate Run Time Hig

Resumen del contenido incluido en la página 3

2. k eep bystanders, children, and visitors away while using this product. Distrac- tions can cause you to lose control. 3. stay alert. watch what you are doing, and use common sense when operat- ing the spotlight. Do not use this product while tired or under the influence of drugs, alcohol, or medication. A moment of inattention while operating this product may result in serious personal injury. 4. Do not force the product. use the correct product for your application. The correct pro

Resumen del contenido incluido en la página 4

opEration 1. The Spotlight can be charged in three different ways by cranking the Handle, using the 120 V~ Adapter, or using the Cigarette Plug Adapter. 2. The Green LED will indicate when the battery is fully charged. A red LED will indi- cate that the battery is charging. charging with the cranking handle Figure 1 Handle Charge Indicator LED’s 1. Pull out the Handle as shown in Figure 1. 2. Grasp the Handle and crank it continuously clockwise. The red LED will stay on while the Spotlight i

Resumen del contenido incluido en la página 5

using the 120 V ac/Dc adapter 1. Insert the plug end into the charge receptacle on the Spotlight. 2. Plug the 120V AC/DC Adapter into a 120V receptacle. 3. Allow the Spotlight to charge until the green LED comes on. 4. Remove the 120V AC/DC Adapter electrical plug from the outlet, and disconnect from the Spotlight. running the spotlight 1. The Spotlight will run for approximately 28 hours on a fully charged battery while in LOW mode, and approximately 12 hours on a fully charged battery whi

Resumen del contenido incluido en la página 6

3. protect the spotlight from rough use. It is susceptible to damage from being dropped, struck or other abuse. 4. protect the spotlight from exposure to water or corrosive materials. It should be kept clean and dry. Occasional cleaning with a clean rag will extend its life and good appearance. 5. Lock it up and store in a dry location to inhibit rust. Keep out of the reach of children. 6. before discarding this product, remove the battery and dispose of it properly in accordance wit