Manual de instrucciones de Dakota Digital MULTI GAUGE UTV-1200

Resumen del contenido incluido en la página 1

IMPORTANT NOTE!

This gauge has an hour meter and

odometer preset option available only
for the first 1.0 engine hour and 10 UTV-1200
miles (16km). See “ODO/HR
Multi Gauge for
PRESET” for instructions.
2008 Yamaha Rhino


Operation menu

Left switch functions
Pressing the left switch during normal gauge operation will move through the below commonly viewed functions
for convenience.

00000.0 Odometer
12:00A Clock (hold left switch to set)
Setting clock:
Left

Resumen del contenido incluido en la página 2

INSTALLATION: 1. Disconnect the battery to prevent possible damage to the electrical system or gauge during install. 2. Remove the stock gauge or indicator panel (see service manual for removal instructions). The UTV gauge will mount in this mounting location. 3. Remove the seats, console/engine cover, front engine cover, and center floor/front drive shaft cover (refer to service manual). This allows access to sensor locations on the engine and wire routing locations. 4. Oil sender ins

Resumen del contenido incluido en la página 3

SPEED Speed gauge menu UNIT Select unit for speed Toggle between MPH and KPH (select unit to use for calibration) AUTO Auto calibrate speed to a marked mile or kilometer Pulls up all values  on speed and speed pulses in odometer Press Right switch to finish cal and save value ADJUST Adjust speed cal while driving ADJUST Each press of left switch toggles direction of adjustment, right switch to save and exit SRV MI (SRV KM) Sets value of servi

Resumen del contenido incluido en la página 4

ADDITIONAL SETUP NOTES: SPEED – AUTO This setup option allows calibrating to a known mile or kilometer. By default, the speed is calibrated to use the Rhino Factory speed signal. Calibration should only be needed if the factory calibration is no longer correct due to changes to tires or gearing. 1. Start with vehicle at the beginning of the marked mile or kilometer and turn the key off. 2. Start engine while holding the left switch to enter setup. 3. Select speed option in setup and sel

Resumen del contenido incluido en la página 5

OPTION – DIM OUT The dim out option allows the dim output to be turned on or off. The dim output is used if you have installed other Dakota Digital gauges and would like this gauge to also control the dimming of these gauges. If the dim out option is turned on, 12v is sent out on the dim out wire when the gauge is dimming. In this mode, the gauge will be either in dim mode or full brightness mode. If no other gauges are to be dimmed, this option can be set to off. In this mode the gauge wi

Resumen del contenido incluido en la página 6

SERVICE AND REPAIR DAKOTA DIGITAL offers complete service and repair of its product line. In addition, technical consultation is available to help you work through any questions or problems you may be having installing one of our products. Please read through the Troubleshooting Guide. There, you will find the solution to most problems. Should you ever need to send the unit back for repairs, please call our technical support line, (605) 332-6513, to request a Return Merchandise Authori