Manual de instrucciones de Grizzly POWER FEED H8370

Resumen del contenido incluido en la página 1

MODEL H8370
POWER FEED
FOR MILL/DRILLS
INSTRUCTIONS
Specifications
�
Motor ................................................. 110V 60Hz
Speed ............................................... 4–200 RPM
�
Maximum Torque .................................440 in./lb.
�
Bevel Gear to Drive Gear Ratio ..................... 4:1
Inventory �
Refer to Figure 1 and the table below to inventory
the contents of the shipping box.
�
�
�
�
REF PART # DESCRIPTION
1 PH8370001 MOUNTING ASSEMBLY
Figure 1. Model H8370

Resumen del contenido incluido en la página 2

D. Speed Dial: Controls the speed that the table Functional Overview moves—turn the dial clockwise to increase The Model H8370 power feed is designed to the speed. install on the left side of a mill/drill table to pro- vide powered longitudinal movement of the table. E. Power Lamp: Lights when the power feed is Refer to Figures 2–3 and the descriptions below turned ON. to become familiar with the functional parts of the power feed system. F. Limit Stops: Activate the limit switch. Secure

Resumen del contenido incluido en la página 3

4. Separate the two pieces of the mounting 9. Connect the electrical plugs of the mounting assembly, then place the table bracket over bracket and power feed. the lip of the table trough, as shown in Figure 5. 10. Position the assembly from Step 8 onto the table bracket so that the teeth of the drive gear and the leadscrew gear mesh exact- Table ly, then tighten the mounting bracket cap Bracket screws and the table bracket hex bolts (see Figures 7–8). Drive Gear Figure 5. Table bracket mou

Resumen del contenido incluido en la página 4

11. Remove the backing from the adhesive tape 14. Make sure the ON/OFF switch is in the OFF on the gear safety cover flanges, then mount position, then connect the power feed unit to the cover on the assembly, as shown in a grounded 110V power source. Figure 9. Electrocution or fire could result if machine is not grounded and installed in Gear compliance with electrical Safety codes. Compliance MUST Cover be verified by a qualified electrician! Maintenance Clean and lubricate the power f