Manual de instrucciones de Miele CVA 4075 EN-CA

Resumen del contenido incluido en la página 1

Installation Instructions
CVA 4075 en-CA


Installation, repair and maintenance work should be performed by
a Miele authorized service technician in accordance with national
and local safety regulations and the provided installation instructions.

Resumen del contenido incluido en la página 2

Plumbing Connection to the water The machine must be connected to supply the water supply in accordance with ^ Disconnect the machine from the local and national regulations. electrical supply. The water being used should have the drinking water standards of the ^ Remove the water connection cover respective country where the at the lower rear side of the coffee machine is used. machine. ^ Screw the supplied brass – All units and systems used to deliver compression fitting, with the ¾" end, the

Resumen del contenido incluido en la página 3

Electrical connection Important Ensure that power is not supplied to The coffee system comes equipped the machine while installation or witha6ft (1.8 m) power cord with a maintenance work is performed. NEMA 5-15P molded plug for connection to a 120 V, 15 A, 60 Hz All electrical work should be power supply. performed by a qualified electrician in strict accordance with national and local safety regulations. Installation, repairs and other work by unqualified persons could be dangerous. The manufa

Resumen del contenido incluido en la página 4

Installation Installation options The coffee system is designed to be built into cabinetry. A combination with other Miele built in appliances is possible. If the machine is installed in combination with other appliances, it should be installed with a protective base between the appliance and the unit (exception: installation with a built-in plate warmer). A special display cabinet is also available from your dealer or Miele, as an installation option. 59

Resumen del contenido incluido en la página 5

Installation Installation ^ If your cabinet has 3/4" (19 mm) side walls, drill four holes for the Make sure power is not supplied to mounting. the appliance while installation or ^ Center the unit and turn the screws a maintenance work is performed. little bit in and then out again. Disconnect the power supply to the work area by unplugging the unit, ^ Take the unit out of the niche and drill tripping the circuit breaker or four holes at the screw markings removing the fuse. The coffee (1/16" [2

Resumen del contenido incluido en la página 6

Installation Adjusting the door hinges The door hinges can be adjusted if the door cannot be opened easily. ^ To adjust the door sideways, a, turn screw a. ^ To adjust the door to the front or back, b, turn screw b. 61

Resumen del contenido incluido en la página 7

Alteration rights reserved / 2707 M.-Nr. 06 984 320 / 03 with convertible water connection CVA 4075 For the most updated manual see the Miele website.