Manual de instrucciones de Seagate CHEETAH X15 36LP ST318432LW/LC

Resumen del contenido incluido en la página 1

Installation instructions
1. Set the SCSI ID
Determine which SCSI IDs are already being used in the system and then
Cheetah X15 36LP Installation Guide
assign this disc drive a SCSI ID that isn’t already being used. Use the J6
ST336752LW/LC, ST318452LW/LC, ST336732LW/LC,
connector located on the front of the drive to set the SCSI ID (see Figure 1).
and ST318432LW/LC SCSI interface disc drives
 If you have an LC model drive, the host normally sets the ID over the I/O
Publication Number: 100139

Resumen del contenido incluido en la página 2

7. Format the drive LW Models J2 Drive with Pin 1 The drive has been low level formatted at the factory. You do not need to HDA up, PCB Single-ended I/O down, viewed perform another low level format on this drive unless you decide to perform from front Pin 1 HDA Forces single-ended operation. certain diagnostics through the host adapter. If you do decide to perform a Allows the host to select either (default) single-ended or LVD operation. low level format, do not abort the format as this is