Manual de instrucciones de Seagate ST336607LC/LW

Resumen del contenido incluido en la página 1

 The host system’s SCSI controller usually uses SCSI ID 7.
 If you have an LC model drive, the host normally sets the ID over the I/O
interface, so you don’t need to worry about this step.
Cheetah 10K.6 SCSI Installation Guide
 If you have an LW model drive, some systems provide a cable designed
ST3146807LW/LC, ST373307LW/LC, ST336607LC/LW
to connect to the J5 jumper block on the drive to remotely set the ID. You
can connect this cable to J5 and use the host-provided remote switch to
Publicat

Resumen del contenido incluido en la página 2

Caution. Formatting a drive erases all user data. Be sure that you under- J2 Drive with Pin 1 stand this principle before formatting any hard disc drive. It is not HDA up, PCB down, viewed necessary to format a drive that previously has been used to from front Pin 1 Reserved Positions HDA store data, unless your intention is to erase all user data. ® Delay Motor Start option (valid Seagate is not responsible for lost user data. only if the Enable Motor Start J6 jumper is not connected) Chee