Résumé du contenu de la page N° 1
NEC LCD Series
®
MultiSync
MultiSync
™
™
LCD1525V
LCD1525V
User’s Manual
User’s Manual
78134641.wpc 1 5/4/99, 5:37 PM
You can
register your
product online at
www.nectech.com/
productregistration
Résumé du contenu de la page N° 2
Index Warning 1 Contents 2 Quick Start 3-5 Controls 6-7 Recommended Use 8-9 Specifications 10 Features 11 Troubleshooting 12 References 13 Limited Warranty 14 TCO’99 15-16 Avertissement 17 Contenu 18 Mise en marche rapide 19-21 Commandes 22-23 Usage recommandé 24-25 Fiche technique 26 Fonctions 27 Dépannage 28 Références 29 Garantie limitée 30 TCO’99 31-32 78134641.wpc 2 5/4/99, 5:37 PM
Résumé du contenu de la page N° 3
WARNING TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. ALSO, DO NOT USE THIS UNIT'S POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS UNLESS THE PRONGS CAN BE FULLY INSERTED. REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE COMPONENTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. CAUTION RISK OF ELECTRIC SHOCK • DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS IN
Résumé du contenu de la page N° 4
® ® MultiSync MultiSync LCD1525V LCD1525V User’s Manual User’s Manual MultiSync LCD 1525V Contents You can register your product online at www.nectech.com/productregistration ® Your new NEC Technologies MultiSync LCD monitor box* should contain the following: ™ • MultiSync LCD1525V monitor with tilt base • Power Cord • AC Adapter • Video Signal Cable • User’s Manual MultiSync LCD1525V monitor with Video Signal Cable and AC Adapter Power Cord User’s Manual * Remember to save your original box and
Résumé du contenu de la page N° 5
Quick Start ® To attach the MultiSync LCD monitor to your system, follow these instructions: 1. Turn off the power to your computer. 2. For the PC: Connect the 15-pin mini D-SUB of the appropriate signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws. ™ For the Mac: Connect the MultiSync LCD1525V Macintosh cable adapter to the computer (Figure B.1). Attach the 15-pin mini D-SUB end of the appropriate signal cable to the MultiSync LCD1525V Macintosh cab
Résumé du contenu de la page N° 6
MultiS Quick Start cont. Figure C.1 Clip A Clip B Figure D.1 Power Switch Figure E.1 4 78134641.wpc 6 5/4/99, 5:37 PM
Résumé du contenu de la page N° 7
5 78134641.wpc 7 5/4/99, 5:38 PM
Résumé du contenu de la page N° 8
Controls ™ OSM (On-Screen-Manager) Controls The OSM controls on the front of the monitor function as follows: Control Main Menu Sub-Menu EXIT Exits the OSM controls. Exits to the OSM controls main menu. CONTROL / Moves the highlighted Moves the highlighted area area up/down to select up/down to select one of the one of the controls. controls. CONTROL / Moves the highlighted Moves the bar left/right area left/right to to increase or decrease select control menus. the adjustment. PROCEED Ha
Résumé du contenu de la page N° 9
Controls ® AccuColor Control System Five color presets select the desired color setting. If a setting is adjusted, the name of the setting will change to Custom. Color Gain (Red, Green, Blue): Increases or decreases Red, Green or Blue color depending upon which is selected. The change in color will appear on screen and the direction (increase or decrease) will be shown by the color bars. Tools Language: OSM control menus are available in seven languages. ™ OSM Position: You can choose where you
Résumé du contenu de la page N° 10
Recommended Use Safety Precautions and Maintenance FOR OPTIMUM PERFORMANCE, PLEASE NOTE THE FOLLOWING WHEN SETTING UP AND USING ® THE MULTISYNC LCD COLOR MONITOR: • DO NOT OPEN THE MONITOR. There are no user serviceable parts inside and opening or removing covers may expose you to dangerous shock hazards or other risks. Refer all servicing to qualified service personnel. • Do not spill any liquids into the cabinet or use your monitor near water. • Do not insert objects of any kind into the cabin
Résumé du contenu de la page N° 11
Recommended Use CORRECT PLACEMENT AND ADJUSTMENT OF THE MONITOR CAN REDUCE EYE, SHOULDER AND NECK FATIGUE. CHECK THE FOLLOWING WHEN YOU POSITION THE MONITOR: • For optimum performance, allow 20 minutes for warm-up. • Adjust the monitor height so that the top of the screen is at or slightly below eye level. Your eyes should look slightly downward when viewing the middle of the screen. • Position your monitor no closer than 16 inches and no further away than 28 inches from your eyes. The optimal d
Résumé du contenu de la page N° 12
Specifications ® ™ Monitor MultiSync LCD1525V Notes Specifications Monitor LCD Module Diagonal: 15.1 inch Active matrix; thin film transistor (TFT) Viewable Image Size: 15.1 inch liquid crystal display (LCD); 0.30 mm dot 2 Native Resolution (Pixel Count): 1024 x 768 pitch; 200cd/m white luminence; 200:1 contrast ratio, typical Input Signal Video: ANALOG 0.7 Vp-p/75 Ohms Sync: Separate sync. TTL Level Horizontal sync. Positive/Negative Vertical sync. Positive/Negative Display Colors Analog input:
Résumé du contenu de la page N° 13
Features Wider Compatibility: Because the MultiSync LCD monitor is analog through and through, it does not require special analog to digital display or interface cards but can accept RGB input directly. Reduced Footprint: Provides the ideal solution for environments requiring superior image quality but with size and weight limitations. The monitor’s small footprint and low weight allow it to be moved or transported easily from one location to another. ® AccuColor Control System: Allows you to ad
Résumé du contenu de la page N° 14
Troubleshooting No picture • The signal cable should be completely connected to the display card/computer. • The display card should be completely seated in its slot. • Power Switch and computer power switch should be in the ON position. • Check to make sure that a supported mode has been selected on the display card or system being used. (Please consult display card or system manual to change graphics mode.) • Check the monitor and your display card with respect to compatibility and recommended
Résumé du contenu de la page N° 15
References • BBS (978) 742-8706 NEC Technologies’ Remote Bulletin Board System is an electronic service accessible with your system and a modem. Communication parameters are: 300/1200/2400/9600/14.4k/28.8k/33.6k bps, no parity, 8-data bits, 1 stop bit • Customer Service/ Technical Support (800) 632-4662 Fax (978) 635-7049 • Electronic Channels: Internet e-mail: tech-support@nectech.com Internet ftp site: ftp.nectech.com World Wide Web: http://www.nectech.com Product Registration: http://www.
Résumé du contenu de la page N° 16
Limited Warranty NEC Technologies, Inc. (hereinafter “NECTECH”), warrants this Product to be free from defects in material and workmanship and, subject to the conditions set forth below, agrees to repair or replace (at NECTECH’s sole option) any part of the enclosed unit which proves defective for a period of three (3) years from the date of first consumer purchase. Spare parts are warranted for ninety (90) days. Replacement parts or units may be new or refurbished and will meet specifications o
Résumé du contenu de la page N° 17
TCO’99 Congratulations! You have just purchased a TCO’99 approved and labeled product! Your choice has provided you with a product devel- oped for professional use. Your purchase has also contributed to reducing the burden on the environment and also to the further development of environmentally adapted electronics products. Why do we have environmentally labelled computers? In many countries, environmental labelling has become an established method for encourag- ing the adaptation of goods and
Résumé du contenu de la page N° 18
TCO’99 cont. accumulative* processes. Flame retardants have been found in human blood and researchers fear that disturbances in foetus development may occur. TCO’99 demand requires that plastic components weighing more than 25 grams must not contain flame retardants with organically bound chlorine and bromine. Flame retardants are allowed in the printed circuit boards since no substitutes are available. Lead** Lead can be found in picture tubes, display screens, solders and capacitors. Lead dama
