Instruction d'utilisation NEC PlasmaSync PX-42VP4DP-A

Résumé du contenu de la page N° 1

PlasmaSync Plasma Monitor
Model Information
For the operation of your plasma monitor,
refer to “Operation Manual”.
NEC Solutions (America), Inc.

Résumé du contenu de la page N° 2

2

Résumé du contenu de la page N° 3

Important Information Warning NOTE: Not for use in a computer room as defined in the Standard When you connect a computer to this monitor, use an RGB for the Protection of Electronic Computer/ Data Processing cable including the ferrite core on both ends of the cable. Equipment ANSI/NFPA 75. And regarding DVI and power cable, attach the supplied ferrite cores. If you do not do this, this monitor will not This equipment has been tested and found to comply with conform to mandatory FCC standards.

Résumé du contenu de la page N° 4

Recommandations importantes Avertissement REMARQUE: Ne pas utiliser dans une salle d’ordinateurs telle que définie Pour raccorder un ordinateur à ce moniteur, procéder à dans la Norme pour la protection des ordinateurs l’aide d’un câble RGB à âme de ferrite aux deux électroniques/appareils de traitement des données ANSI/ extrémités. Sur les câbles DVI et les câbles d’alimentation NFPA75. électrique, fixer les âmes de ferrite fournies aux extrémités. Si vous ne le faîtes, le moniteur ne sera pas

Résumé du contenu de la page N° 5

Specifications  42VP4PA/42VP4DP-A 1.18" Screen Size 36.3"(H)
20.4"(V) inches 2.32" (30) 40" (1018) 921(H)
518(V) mm (59) diagonal 42" 42VP4PA: Installed AR (Anti-Reflection) Filter 36.3" (921) 42VP4DP-A: Installed AG (Anti-Glare) Filter Aspect Ratio 16 : 9 Resolution 853(H)
480(V) pixels Pixel Pitch 0.04"(H)
0.04"(V) inches 1.08(H)
1.08(V) mm Color Reproduction 256 levels, 16,770,000 colors Signals 3.5" Synchronization Range Horizontal : 15.5 to 110 kHz (89) (automatic : step scan) Vertical : 5

Résumé du contenu de la page N° 6

6

Résumé du contenu de la page N° 7

Table of Signals Supported  42Wide VGA Supported resolution 2, 4 • When the screen mode is NORMAL, each signal is converted to a 640 dots
480 lines signal (42Wide VGA). (Except for * * ) 3 • When the screen mode is FULL, each signal is converted to a 853 dots
480 lines signal (42Wide VGA). (Except for * ) Computer input signals supported by this system Sync Polarity Presence Screen mode Vertical Horizontal RGB Dots
lines Model 5 Memory frequency frequency Horizontal Vertical Horizonta

Résumé du contenu de la page N° 8

*1 Only when using a graphic accelerator board that is capable of displaying 852
480. *2 Display only 400 lines (42Wide VGA) with the screen center of the vertical orientation located at the center. *3 The picture is displayed in the original resolution. The picture will be compressed for other signals. *4 Aspect ratio is 5:4. This signal is converted to the following signal (42Wide VGA: 600 dots
480 lines). *5 Normally the RGB select mode suite for the input signals is set automatically. If th