Résumé du contenu de la page N° 1
Use & Care Guide
Manual de Uso y Cuidado
English / Español
Models/Modelos: 148.16156210/148.16157210
Items / Artículos: 640-03838924-3 / 640-03838925-0
Kenmore®
Liquid Propane Gas Grill
Parilla a gas de propane liquido
P/N S3218AN-Manual
Sears Brands Management Corporation
Hoffman Estates, IL 60179 U.S.A.
www.kenmore.com
www.sears.com
www.kmart.com
TM
Résumé du contenu de la page N° 2
Installation Safety Precautions • Use grill, as purchased, only with LP (propane) gas and the regulator/valve assembly supplied. A conversion kit must be purchased for use with natural gas. If you smell gas: • Grill installation must conform with local codes, or in their absence of local codes, with either the National Fuel Gas 1. Shut off gas to the appliance. Code, ANSI Z223.1/ NFPA 54, Natural Gas and Propane 2. Extinguish any open flame. Installation Code, CSA B149
Résumé du contenu de la page N° 3
For Sears professional installation of home appliances, garage TABLE OF CONTENTS door openers, water heaters, and other major home items, in ® the U.S.A. call 1-800-4-MY-HOME For Your Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . 2 Grill Service Center. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 WARRANTY Product Record Information . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety Symbols. . . . . . . . . . . . . . . . . . .
Résumé du contenu de la page N° 4
USE AND CARE LP Cylinder • The LP cylinder used with your grill must meet the following requirements: ` • Use LP cylinders only with these required measurements: 12" (30.5cm) (diameter) x 18" (45.7 cm) (tall) with 20 lb. (9 kg.) capacity maximum. • NEVER store a spare LP cylinder under or near • LP cylinders must be constructed and marked in accordance with specifications for LP cylinders of the U.S. Department of the grill appliance or in an enclosed area. Transportat
Résumé du contenu de la page N° 5
LP Tank Exchange Connecting Regulator To The LP Tank •Many retailers that sell grills offer you the option of replacing 1. LP tank must be properly secured onto grill. (Refer to your empty LP tank through an exchange service. Use only assembly section.) those reputable exchange companies that inspect, precision 2. Turn all control knobs to the OFF position. fill, test and certify their cylinders. Exchange your tank only 3. Turn LP tank OFF by turning OPD hand wheel clockwise to for an OPD
Résumé du contenu de la page N° 6
Leak Testing Valves, Hose and Regulator 1. Turn all grill control knobs to OFF. 2. Be sure regulator is tightly connected to LP tank. 3. Completely open LP tank valve by turning OPD hand wheel counterclockwise. If you hear a rushing sound, turn gas off Hold coupling nut and regulator immediately. There is a major leak at the connection. as shown for proper connection Correct before proceeding by calling Sears for to LP tank valve. ® replacement parts at 1-800-4-MY-
Résumé du contenu de la page N° 7
Safety Tips Before opening LP cylinder valve, check the coupling nut for tightness. When grill is not in use, turn off all control knobs and LP For Safe Use of Your Grill and to Avoid Serious cylinder valve. Injury: Never move grill while in operation or still hot. • Do not let children operate or play near grill. Use long-handled barbecue utensils and oven mitts to • Keep grill area clear and free from materials that avoid burns and splatters. Maximum load for
Résumé du contenu de la page N° 8
5. If ignition does not occur in 5 seconds, turn the burner control off, wait 5 minutes for gas to clear away, and repeat the lighting procedure. 6. To light other burners, repeat step 4. NOTE: If ignitor does not work, follow Match Lighting instructions. Turn controls and gas source or tank OFF when Burner Flame Check not in use. •Remove cooking grates and heat diffusers. Light burners, rotate knobs from HIGH to LOW. You should see a smaller flame in L
Résumé du contenu de la page N° 9
Do not use citrisol, abrasive cleaners, degreasers or a Storing Your Grill concentrated grill cleaner on plastic parts. Damage to and •Clean cooking grates. failure of parts can result. •Store in dry location. •Porcelain surfaces: Because of glass-like composition, most •When LP cylinder is connected to grill, store outdoors in a residue can be wiped away with baking soda/water solution or wellventilated space and out of reach of children. specially formulated cleaner. Use nonabrasi
Résumé du contenu de la page N° 10
VERY IMPORTANT: Burner tubes must reengage valve openings. Food Safety Food safety is a very important part of enjoying the outdoor cooking experience. To keep food safe from harmful bacteria, follow these four basic steps: Clean: Wash hands, utensils, and surfaces with hot soapy water before and after handling raw meat and poultry. Separate: Separate raw meats and poultry from ready-to-eat foods to avoid cross contamination. Use a clean platter and Correct burner-to-valve en
Résumé du contenu de la page N° 11
Gas Requirements Care and Maintenance Time Table Chart LP Gas If your grill is for LP Gas, the regulator supplied is set for Frequency Based Grill Item Cleaning Method on Normal Use an 11-in. water column (WC) and is for use with LP gas Painted surface Twice yearly Car wax only. The factory-supplied regulator and hose must be Stainless surface Twice yearly Stainless cleaner used with a 20-lb. LP gas tank. All grates After each use Burn off and wipe Wire brush/ Stainless gra
Résumé du contenu de la page N° 12
Transformer Connection Instruction Push the transformer power cord through the opening in the grill cart rear panel as shown, and plug it into an extension cord. To operate light, press the Main Light switch on the control panel to ON or OFF. For your convenience, this grill comes equipped with a UL approved transformer for outdoor use that provides low voltage to power 10-watt grill light featured with this model. Power Cord
Résumé du contenu de la page N° 13
1. Make sure that the Main Light switch on the control 4. Pull out the light bulb and replace with a new bulb. panel is pressed to OFF, and that transformer power cord is disconnected from power source. Bulb 2. Use a screwdriver to loosen the screw holding the lens in place. While loosening the screw, hold the lens in place so that it does not fall and break. Lens Screw 5. Reverse the instruction from “steps” 3-1for installation. 1. To pro
Résumé du contenu de la page N° 14
Operating Instructions: Natural Gas Conversion Kit 1. To connect, push back socket sleeve. Sleeve Socket Plug Your grill can be converted to natural gas. The conversion must be performed by a qualified gas technician. The following listed Natural Gas Conversion Kit (sold separately) and 1.33 mm nozzle (provided with grill) are required for the conversion. Natural gas conversion kit 2. Insert plug and release sleeve. Kenmore Model # 10478 (Manufacturer Part No.
Résumé du contenu de la page N° 15
PARTS LIST Manufacturer Manufacturer Key Qty Description Key Qty Description Part # Part # 43 1 SWITCH E3520-00-8015 1 1 HOOD HANDLE 3218LT-00-4300 2 2 HANDLE BASE S3218ANR-00-4001 44 1 REAR BURNER BEZEL L3218-00-3002 3 1 HOOD S3218ANR-00-4100 45 1 REAR BURNER KNOB L3218-00-3001 4 1 TEMPERATURE GAUGE 2818-2T-A300 46 1 IGNITION WIRE S3218ANR-00-8001 47-1 1 CONTROL BOX S3218ANB-00-3101 5 1 WASHER E3518-00-4009 6 5 R-PIN GB/T 91-2000 47-2 1 CONTROL BOX S3218ANR-00-3101 7 3
Résumé du contenu de la page N° 16
PARTS DIAGRAM 3 6 7 8 4 ○ 5 ○ ○ ○ ○ ○ 2 ○ 1 ○ 9 ○ 15 16 ○ 14 13 12 ○ ○ ○ ○ 10 11 ○ ○ 21 19 20 18 ○ ○ 22 23 ○ ○ ○ ○ 17-2 17-1 24 ○ 25 ○ 26 27 ○ ○ 28 ○ 29 ○ 30 ○ 47-2 47-1 31-1 31-2 32 ○ 33 ○ 46 45 42 ○ 44 43 41 ○ ○ 40 ○ ○ ○ ○ 39 38 37 ○ ○ ○ 36 ○ 49 48 ○ ○ 50 51 ○ 52 ○ 35 34 ○ 53 ○ ○ ○ 54 ○ 55 ○ 69 ○ 56 ○ 57 ○ 68 ○ 65-1 60 67-1 63 62 61 ○ 59 64 58 66 ○ ○ ○ ○ ○ ○ ○ 65-2 67-2 16
Résumé du contenu de la page N° 17
UNPACKING After removing all parts and hardware pack from the top of the shipping box, and when the only part showing is the grill head, use a box cutting knife to slice down the sides of the box. Be careful of staples along shipping box edges. Remove the corner supports from the box and the styrofoam side pieces from the grill head. With the aid of an assistant, rest grill head on one of the styrofoam side pieces to protect grease tray. Allow grill head to rest on cardboard until placin
Résumé du contenu de la page N° 18
Attach Rear Panel to Bottom Panel with 4 screws as shown. 1/4-20 x 5/8″Screw Qty. 4 Rear Panel Bottom Panel Attach side panels to bottom panel as shown. For each side panel, there are three screws for the rear panel and three for the bottom panel. Insert the three bottom panel screws first.. Rear Panel Left Panel 1/4-20 x 5/8″Screw Qty. 12 Right Panel Bottom Panel 18
Résumé du contenu de la page N° 19
Attach the side panel brackets to the side panels and bottom panel with 3 screws each as shown. Left Panel Bottom Panel 1/4-20 x 5/8″Screw Qty. 6 Right Panel Side Panel Bracket Slide the tank ring bracket onto the end of the tank ring as shown. Attach the bracket to the rear panel with 2 screws as shown. Tank Ring Tank Ring Bracket 1/4-20 x 5/8″Screw Rear Panel Qty. 2 19
Résumé du contenu de la page N° 20
Attach front beam to side panels with 2 screws on each side as shown. Left Panel 1/4-20 x 5/8″Screw Qty. 4 Right Panel Front Beam Remove the cap and the nut from the igniter. Secure the igniter and the igniter protective box to side panel with the nut. Then, reassemble the cap to the igniter. Igniter Igniter protective box Cap Nut 20
