Résumé du contenu de la page N° 1
Installation Instructions / Warranty
Citterio
39115XX1
Résumé du contenu de la page N° 2
Citterio Wall-Mount Lavatory Trim 39115XX1 ��� ��� Technical Data Maximum incoming water pressure 145 psi Recommended incoming pressure 14.5 - 7 psi o o Recommended hot water temperature 10 F - 140 F* Flow rate . gpm The hot and cold supplies must be of equal pressure for proper operation of the faucet. *Know and follow all applicable local codes when setting the temperature of the water heater. Installation Considerations · Rough-in 38111181 (purchased separately) must be installed and the
Résumé du contenu de la page N° 3
Installation Instructions Turn off The aw Ter a T The ysuppl before beginning The T ins alla Tion . · Remove the caps from the plaster shields. Cut the plaster shields 1 mm (1/16”) from the surface of the finished wall. Seal around the plaster shields with a suitable, non-staining, waterproof bathroom sealant. · Use a 7 mm deep socket wrench to remove the flush insert. · Use a 17 mm deep socket wrench to remove the plug from the spout port. · Install the cartridge and anti twist devic
Résumé du contenu de la page N° 4
· Install the springs and cup washers in the valve body. Install the cartridge assembly. · Install the handle. Tighten the set screw using the enclosed mm allen wrench. · Measure the distance from the surface of the finished wall to the end of the handle. 4
Résumé du contenu de la page N° 5
If the distance is 3 1/4” – 3 7/8”, select the two “A” sleeves (1-1/4” long). If the distance is 3 7/8” – 4 3/8”, select the two “B” sleeves (7/8” long) If the distance is 4 3/8”, select the two “C” sleeves (1/” long) · Screw the escutcheon retainers to the ends of the two sleeves. 5
Résumé du contenu de la page N° 6
· Measure the distance from the outside surface of the finished wall to the spout port (“X”). Add ” to X · Measure the threaded end of the spout. Using proper tools and safety practices, cut the spout so that the threaded portion is X + ” long. x + 2” · Wrap the threads on the spout connector with TM several layers of a good quality Teflon tape. Screw the spout connector into the rough. · Place the face plate against the wall. Screw the sleeve/escutcheon retainer assemblies thro
Résumé du contenu de la page N° 7
· Use the service key to tighten the escutcheon retainers against the plate. · Lightly coat the threads on the flanges with the included lubricant. Screw the flanges onto the retainers. · Push the cap over the handle assembly. Push the spout over the connector and tighten the set screw. 7
Résumé du contenu de la page N° 8
User Instructions Lift the handle to turn the faucet on. Pivot the handle to the left for warmer water, to the right for cooler water. Push the handle down to turn the water off. 11 Replacement Parts A B C 9 6 5 1 3 1 1 flange 96908XXX 13 handle 3909XXX 3 flange for handle 9691XXX 4 4 flange for spout 97695XXX 10 5 face plate 96914XXX 6 cartridge 96339000 8 7 aerator 13085000 8 spout 9739XXX 7 9 anti-twist device 9780000 14 10 spout connector 978000 11 fixing set 97971000 1 n
Résumé du contenu de la page N° 9
Cleaning Recommendation for Hansgrohe Products Modern faucetry and shower products utilize a combination of materials to comply with the needs of the market with regard to design and functionality. To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper treatment is not covered under the Hansgrohe warranty. Cleaning Materials for Faucets and Showers · To remove lime scale, use only products made specifically for that purpose. Always follow the manufactur
Résumé du contenu de la page N° 10
Limited Lifetime Consumer Warranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or Canada. WHO IS COVERED BY THE WARRANTY This warranty extends to the original consumer purchaser only. This warranty is non-transferable. WHAT IS COVERED BY THE WARRANTY This warran
Résumé du contenu de la page N° 11
TO OBTAIN WARRANTY PARTS OR INFORMATION Contact your Hansgrohe retailer, or contact Technical Service at: Hansgrohe Inc. 149 Bluegrass Lakes Parkway Alpharetta GA 30004 Toll-free (800) 334-0455. In requesting warranty service, you will need to provide 1. The sales receipt or other evidence of the date and place of purchase. . A description of the problem. 3. Delivery of the product or the defective part, postage prepaid and carefully packed and insured, to Hansgrohe Inc. 149 Bluegrass Lakes
Résumé du contenu de la page N° 12
Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004 Tel. 770 360-9880 • Fax 770 360 9887 www.hansgrohe-USA.com US - Installation Instructions • Part No. 90575801 • Revised 4/007
