Résumé du contenu de la page N° 1
GILSJ JN MIXERS
5 1/2 CU. FT.
CONCRETE MIXER
MODEL: 59015C
OPERATOR’S GUIDE & PARTS MANUAL
GILSJ JN MIXERS
4343 Easton Road · St. Joseph, MO 64503
BY
816-233-4840 · 800-253-3676
Fax 816-233-4624 · 888-253-3676
E-Mail: cleform@ccp.com
Web Address: www.cleform.com
Résumé du contenu de la page N° 2
INTRODUCTION This operator’s manual has been prepared to provide the information you need to correctly operate and maintain your unit. Read it carefully and keep it for future reference. Should you ever need repair parts or service, contact your authorized parts and service dealer. Be sure safety precautions are observed. Read and Follow all safety and operating instructions in this Operator’s manual. The replacement of any part on this product by other than the manufacturer’s authorized repl
Résumé du contenu de la page N° 3
1-SAFETY PRECAUTIONS THE FOLLOWING PRECAUTIONS ARE SUGGESTED TO HELP PREVENT ACCIDENTS. A CAREFUL OPERATOR IS THE BEST OPERATOR. MOST ACCIDENTS CAN BE AVOIDED BY OBSERVING CERTAIN PRECAUTIONS. READ AND TAKE THE FOLLOWING PRECAUTIONS BEFORE OPERATING THIS EQUIPMENT TO HELP PREVENT ACCIDENTS. EQUIPMENT SHOULD BE OPERATED ONLY BY THOSE WHO ARE RESPONSIBLE AND INSTRUCTED TO DO SO. § Read all mixer and electric motor/engine instructions before operation. § Use a grounded, three wire plug-in for all
Résumé du contenu de la page N° 4
2-OPERATION DRUM SPEED The mixer drum should revolve between 20 and 25 R.P.M.’s for best results in mixing concrete. To obtain this speed using a 1725/1800 R.P.M. electric motor, use a 2” diameter “A” section V-pulley. If using a 6 to 1 speed reduction 3 H.P. gasoline engine, use a 6 ¼” diameter “A” section V-pulley. GETTING READY FOR MIXING Lay out forms for your concrete floor, patio, driveway, sidewalk, etc. The quality of concrete is directly related to the quality of the cement paste. The
Résumé du contenu de la page N° 5
LOADING THE MIXER Start the mixer. Refer to motor/engine instructions. After drum has started rotating, pour about half of the water in the drum. NOTE: The drum my leak slightly when first used. This will stop after a few batches. Add aggregate (gravel) first then cement and last sand. UNLOADING THE MIXER Refer to Fig. 1 Allow the entire mixture to mix for one full minute. Do not stop mixer from rotating. Hold the tilt handle and unlock the stop lever. Dump concrete to either side by tilti
Résumé du contenu de la page N° 6
3-LUBRICATION & STORAGE Each day before operating, lubricate at the following points: Engine/Motor – Refer to engine/motor operating instructions for all maintenance and lubrication instructions and requirements. GREASE FITTINGS: Refer to Fig. 2 Clean off grease fitting before greasing. Use pressure type grease gun. Grease lightly with general purpose grease (2 to 3 pumps). § Drum Shaft Bearings (where used) § Drive shaft Bearings § Tilt Wheel Shaft Bearings (where used) § Brake Lever Shaft (w
Résumé du contenu de la page N° 7
4-REPLACEMENT DECALS #217728: Decal, Safety Instructions #5706: Decal, Gilson Name Plate #38257: Decal, Drum Rotation 6
Résumé du contenu de la page N° 8
7
Résumé du contenu de la page N° 9
CONCRETE MIXER PARTS LIST ITEM NO. PART NO. DESCRIPTION QTY. 1 1102 Grease Fitting 1 2 1183 Grip 1 3 19866 Bearing Cap 1 4 19902 Drum Assembly 1 5 19911 Blade Assembly 2 6 19913 Paddle Assembly 2 7 19914 Drum Shaft Assembly 1 8 214858 Belt Guard Cover 1 9 214907 Belt Guard Assembly 1 10 245948 Frame Assembly 1 11 245949 Yoke Assembly 1 12 245952 Tilt Handle 1 13 245956 Bushing Spacer 2 14 245977 Yoke Lock Tube 1 15 245978 Yoke Lock Assembly 1 16 245980 Pivot Tube 2 17 29209 Pulley 1 18 4959 Bush
Résumé du contenu de la page N° 10
MIXERS ONE-YEAR WARRANTY This product is warranted to the original purchaser only, to be free of defects in material and workmanship under normal use, for one year from purchase date. Cleform Tool Corp. shall without charge for parts and labor, repair or replace such parts which are found to be defective. All transportation charges for replacement parts must be borne by the purchaser. For warranty service, the product must be delivered, with proof of purchase date, to the dealer of original pur
Résumé du contenu de la page N° 11
ALL IMPLIED WARRANTIES, INCLUDING THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO ONE YEAR FROM DATE OF PURCHASE BY THE ORIGINAL RETAIL CUSTOMER AND TO THE EXTENT PERMITTED BY LAW ANY AND ALL IMPLIED WARRANTIES ARE EXCLUDED AND DISCLAIMED AFTER THE EXPIRATION OF SUCH PERIOD. Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitations of incidental or consequential damages, so the above limitations or exclusions may not
Résumé du contenu de la page N° 12
11
