Résumé du contenu de la page N° 1
FF 5000 SERIES
Revolving mixer with separate handshower
Installation guide
Résumé du contenu de la page N° 2
G 1399.XX G 1402.XX G 13396.XX G R0239.XX G 1156 G 28900.XX G R1190 G R0185 G 1697 G 1635 G 1404 G 1403 PARTS LIST G 1156 Cartridge G R0239.XX Ring cap G 13396.XX Handle G 1399.XX Aerator G 1402.XX Side spray G 28900.XX Hook for side spray G R0185 Fastening set (rubber washer, metal washer, nut) G 1697 Priority water flow system G 1403 Flexible hose of the side spray G 1404 Flexible hose G 1635 Counter weight Fastening set (rubber washer, triangular flange, metal washer, nut, allen key G R1190 2
Résumé du contenu de la page N° 3
Faucet installation Please remove all components from package and inspect prior to installation (see itemized table and picture). NOTE: Call us immediately if you see inconsistencies. (1-800-626-5771) or visit www.frankeksd.com TABLE OF CONTENT 1 Faucet 2 Flexible hose of the side spray 3 Hook for side spray 4 Side spray 5 Priority water flow system 6 Fastening set (rubber washer, metal washer, nut) 7 Fastening set (rubber washer, triangular flange, metal washer, nut, allen key 2,5mm) 8 Counter
Résumé du contenu de la page N° 4
Install faucet to the sink or countertop Set the faucet into place on the sink as indicated in the figure. NOTE: the rubber O-ring should be sitting on top of the countertop and between the faucet body. DO NOT use putty or other sealant at this location. 4 ENGLISH
Résumé du contenu de la page N° 5
Install faucet to the sink or countertop - follows 1 2 5 3 6 7 4 Install the fastening components to the faucet’s threaded shank in the following sequence: round gasket (1), triangular flange (2), metal washer (3) and threaded nut (4) (the triangular flange can be omitted if the sink/countertop is too thick). Install the fastening items of the spray head holder in the following sequence: the flat rubber washer (5), the metal washer (6) and the threaded nut (7). 5 ENGLISH
Résumé du contenu de la page N° 6
Assembly of side spray and connecting of the priority water flow system A filter washer B 3 2 ~ 40 cm 1 Proceed to the connection of the flexible hose of the side spray (A) and the priority water flow system (B - follow the phases indicated). Interposing the holding gaskets within the connections as indicated in the figure. Fix the lead counter weight to the flexible hose of the side spray at a distance of approx. 40 cm from the connection to the outlet pipe. 6 ENGLISH
Résumé du contenu de la page N° 7
Connect the supply lines Arrow BLU COLD water Arrow RED HOT water Connect the hot and cold supply lines. Do not allow the supply tubes to twist or bend sharply. Leave the valves closed. - Move the faucet handle by rotating it onwards so that it opens in the full hot position and open the hot supply for 15 seconds. Close the hot supply. - Move the faucet handle by rotating it backwards so that it opens in the full cold position and open the cold supply for 15 seconds. Clo- se the cold
Résumé du contenu de la page N° 8
Replacing the cartridge B B A A Allen key 2.5 mm 28 mm wrench G G F E D C F E D C Before starting, shut off the water supply to the faucet and move the faucet handle to the off position. Use a 2.5 mm Allen key to loosen the set screw (A) which is accessible from the back of the handle. Lift the handle (B) from the cartridge (F). Find the small notch at the base of the chrome ring cap and carefully pry up against this to remove the cap (C). Remove the brass retaining ring (E) using a 28 mm w
Résumé du contenu de la page N° 9
Cleaning of the aerator 1 2 It is recommended that you periodically clean the aerator of your fau- cet. To do so, unscrew the aerator holder from its own seat. Simply using a toothbrush, or something similar, rub the filter under the wa- ter, removing the impurities and any build up. Screw the areator back into place. Cleaning of the side spray Any deposits which may accumulate on the nozzle can be removed by simply running a finger over the rubber extrusions and then run- ning the water for a
Résumé du contenu de la page N° 10
General maintenance Clean aerator periodically. Do not use harsh detergents, solvents, chemical agents, metallic sponges, etc. that could harm the surface. Clean only with a soft sponge and soapy water. Clean and then dry properly the faucet in case of very hard or calcare- ous water, whose deposits cold damage the surface. 10 ENGLISH
Résumé du contenu de la page N° 11
Limited lifetime warranty Franke Consumer Products, Inc., Kitchen Systems Division extends the following warranty to the origi- nal purchaser of its faucets effective January 1, 2003. All faucets installed in a private residence will carry a limited lifetime warranty on all mechanical parts to be free of manufacturing defects in material and workmanship under normal usage. All chrome finishes carry a limited lifetime warranty; all other finishes are warranted for five (5) years form the origina
