Résumé du contenu de la page N° 1
XT-5871
USER'S MANUAL
Features
• 0.28 mm Dot Pitch
• 1280 x 1024, Non-Interlaced
• 120 Hz Refresh Rate
• Power Saving Operation (VESA DPMS)
• Anti-Glare Screen
• Full Screen Display
• Digital Controls
• Low Radiation
• Plug and Play
• Three-Year Warranty
Part #MAN119 Rev. 1.0 CX1566
Résumé du contenu de la page N° 2
Table of Contents Section 1 General Information ................................................... 2 Section 2 Installation .................................................................. 3 Section 3 Monitor Controls and LEDs ........................................ 4 Section 4 Troubleshooting ......................................................... 5 Appendix A Specifications ............................................................. 6 Appendix B Video Cable Pinout .....................
Résumé du contenu de la page N° 3
Section 1 - General Information Congratulations on purchasing a MaxTech 15-inch high resolution color monitor. The monitor uses one of the finest CRTs available in the industry. The 0.28 mm dot pitch non-glare tube provides a crisp and vivid color display for all popular applications. The monitor complies with the MRP-I standard to reduce electro- magnetic emissions. Advanced electronics and digital controls make it the perfect monitor for applications ranging from home computing to business pre
Résumé du contenu de la page N° 4
Figure 2-1 Connecting the Base 2.2 Connecting the Cable • Plug the 15-pin male connector on the video cable into the output connector on the rear of your computer system. The video output connector on your computer may be either in a location similar to Figure 2-2 or on an expansion board. Secure the cable to the computer using the thumbscrews on the 15- pin connector. • Attach the power cord to the monitor and plug it into an AC outlet. • The monitor is now ready for use. Figure 2-2 Monitor Con
Résumé du contenu de la page N° 5
Section 3 - Monitor Controls and LEDs Figure 3-1 Controls and LEDs 1 2 3 4 5 6 78 9 10 11 12 13 14 4
Résumé du contenu de la page N° 6
1. Master Power (On rear): Push to provide power to the monitor. This switch should be left ON for daily operation. Use the front panel On/Off control (5) to turn the monitor display on and off. 2. Adjust: Press plus (+) to increase the setting for the selected control (9 through 14). Press minus (-) to decrease the setting. 3. Brightness Control: Adjusts the display brightness. 4. Contrast Control: Adjusts the contrast of the display. 5. ON/OFF: Press this switch to turn the monitor display on,
Résumé du contenu de la page N° 7
Image is not centered • Adjust Vertical Position and Horizontal Position controls. Appendix A - Specifications Picture Tube Size 15-inch diagonal Dot pitch 0.28mm Horizontal Freq 30-66KHz Vertical Freq. 50-120 Hz Resolution (Max.) 1280 x 1024 Video Dot Rate 100 MHz Data Area 10.2 in. x 7.7 in. Maximum Refresh Rates Resolution Refresh (Vertical) Frequency 640 x 480 120Hz 800 x 600 100 Hz 1024 x 768 75 Hz 1280 x 1024 60 Hz Input voltage 110~240VAC, 50/60 Hz Front controls On/Off, Brightness, Contr
Résumé du contenu de la page N° 8
Appendix B - Video Cable Pinout Figure B-1 Pin Layout and Pin Assignment Chart PIN SIGNAL PIN SIGNAL 1 Red 9 No Pin 2 Green 10 Ground 6 11 1 3 Blue 11 Ground 4 No Pin 12 SDA 5 Ground 13 Hor. Synch. 10 15 5 6 Red Return 14 Vert. Synch 7 Green Return 15 Data Clock (SCL) 8 Blue Return Appendix C - Power Saving Modes (DPMS) VESA Display Power Management Signaling (DPMS) defines a method for a computer to signal the monitor to reduce its power consumption when idle. DPMS features must be supported by
Résumé du contenu de la page N° 9
material and workmanship for three years from the date of purchase. Except as specified below, this warranty covers all defects in material or workmanship in this product. The following are not covered by the warranty: 1. Any product which is not distributed in North America by MAXTECH or which is not purchased in North America from an authorized MAXTECH Dealer. 2.Any product on which the serial number has been defaced, modified or removed. 3. Damage, deterioration or malfunction resulting from:
Résumé du contenu de la page N° 10
voided if the product has been abused, misused, modified, or repaired by an unauthorized service center. LIMITATION OF IMPLIED WARRANTIES All implied warranties, including warranties of merchantability and fitness for a particular purpose, are limited in duration to the length of this warranty. EXCLUSION OF DAMAGES MAXTECH'S liability for any defective product is limited to the repair or replace- ment of the product, at our option. MAXTECH shall not be liable for: 1. Damage to other property cau
Résumé du contenu de la page N° 11
Notice: Shielded cables, if any, must be used in order to comply with the emission limits. Any change or modification not expressly approved by the Grantee of the equipment authorization could void the user’s authority to operate the equipment. Canadian DOC Compliance Statement This equipment does not exceed Class B limits for radio noise emissions for a digital apparatus, set out in the Radio Interference Regulations of the Canadian Department of Communications. Operation in a residential area
