Résumé du contenu de la page N° 1
XT4888
14 INCH
COLOR MONITOR
USER'S
MANUAL
Features:
• 1024 x 768, Non-Interlaced
• .28 mm Dot Pitch
• 72 Hz Refresh Rate (VGA/SVGA)
• Power Saving Operation (VESA DPMS)
• Non-Glare Screen
• Full Screen Display
• Easy Access Front Controls
• Unlimited Palette of Colors
Part #MAN075 Rev 1.0 M1448
Résumé du contenu de la page N° 2
Table of Contents Section 1 - General Information ........................................2 Section 2 - Installation .......................................................3 Section 3 - Monitor Controls and LEDs .............................4 Section 4 - Troubleshooting...............................................5 Appendix A - Specifications...............................................5 Appendix B - Video Cable Pinout ......................................6 Appendix C - Two Year Warranty ..
Résumé du contenu de la page N° 3
Section 1 - General Information Congratulations on purchasing a MaxTech 14-inch Color Monitor. The monitor has one of the finest CRTs available in the industry, providing a full range of video display resolutions and complies with the MPR-I standard to reduce electromagnetic emissions. The monitor has a 0.28 mm dot pitch display with a 65 MHz video bandwidth. It supports video resolutions ranging from 640 x 350 to 1024 x 768 (non-interlaced). The monitor can be used with video cards supporting V
Résumé du contenu de la page N° 4
are re-enabled the monitor returns to normal operation. Section 2 - Installation 2.1 Attaching the Base Figure 2-1 Connecting the Base • Carefully place the monitor on its side or top. • Insert the hooks on the swivel base into the slots in the bottom of the monitor. Push down and forward on the base until it snaps into place. • Place the display upright in an ap- propriate location. 2.2 Connecting the Cable • Make sure that power to the monitor and the computer is off. • Connect the cable from
Résumé du contenu de la page N° 5
Section 3 - Monitor Controls and LEDs Figure 3-1 Controls and LEDs A B 1 C 2 34 5 6 7 8 9 1.Power Indicator: LEDs A, B, and C indicate the state of the Monitor. • LEDs A, B and C On – Normal operations. • LEDs B and C On – DPMS (Display Power Management Signaling) “SUSPEND” mode. The monitor enters SUSPEND mode when the computer turns off the Vertical Sync. signal. The monitor is in power- saving mode and uses only 25 W. • LED C On – DPMS “OFF” mode. The monitor enters OFF mode when the computer
Résumé du contenu de la page N° 6
Section 4 - Troubleshooting No picture, power indicators A, B, C off • Check AC cord is plugged into outlet and monitor. • Turn on the power switch. No picture, power indicators A, B, C on. • Check that video cable is connected completely. • Adjust brightness and contrast controls. • Turn the computer on. No picture, power indicator A off, indicators B and C on. • Monitor is in DPMS “SUSPEND” mode. Press a key or move the mouse. No picture, power indicators A and B off, indicator C on. • Monitor
Résumé du contenu de la page N° 7
Pincushion distortion <=2mm High voltage regulation H<=4mm, V<=4mm(0-25FL) Low radiation* MPR-I specification Front controls Power, Brightness, Contrast, Horizontal-Size, Hori- zontal-Position, Vertical-Size, Vertical-Position, Pincushion Power saving Display Power Management Signaling (DPMS) SUSPEND mode 25W (Max.) OFF mode 5W (Max.) Input voltage 100~240VAC, 50/60 Hz Power consumption 85W maximum Operating Temperature 0°~40°C Environment Humidity 20~90% Altitude 0~10,000ft. Connector 15 Pin D-
Résumé du contenu de la page N° 8
Appendix C - Two Year Warranty MaxTech warrants to the original buyer of this product against defects in material and workmanship for two years from the date of purchase. Except as specified below, this warranty covers all defects in material or workmanship in this product. The following are not covered by the warranty: 1. Any product which is not distributed in North America by MaxTech or which is not purchased in North America from an authorized MaxTech Dealer. 2. Any product on which the seri
Résumé du contenu de la page N° 9
damages based upon inconvenience, loss of use of the product, loss of time, commercial loss; or 2. Any other damages, whether incidental, consequential or otherwise. Some states do not allow limitations on how long an implied warranty lasts and/or do not allow the exclusion or limitation of incidental or consequen- tial damages, so the above limitations and exclusions may not apply to you. HOW STATE LAW RELATES TO THE WARRANTY This warranty gives you specific legal rights, and you may also have
Résumé du contenu de la page N° 10
dépassant les limites applicables aux appareils numériques de la class B prescrites dans le Règlement sur le broullage radioélectrique édicté par le ministère des Communications du Canada Disclaimer, Copyright, And Other Notices The information contained in this manual has been validated at the time of this manual's production. The manufacturer reserves the right to make any changes and improvements in the product described in this manual at any time and without notice. Consequently, the manufac
