ページ1に含まれる内容の要旨
Installation Manual with Service Replacement Parts
Door-type
Dishwasher
Models:
MD-1000HT
Pumped rinse high temperature sanitizing
w/built-in stainless steel electric booster
MD-1000LT
Pumped rinse low temperature sanitizing
w/3 built-in chemical dispensing pumps
MD-1000HT
Dishwasher serial no.
MD-1000LT
Issue Date: 3.14.06
Manual P/N 114156 rev.—
www.moyerdiebel.com
For machines beginning with S/N D2466 and above
File: DTMVC0214.6
P.O. Box 4183 2674 N. Service Road, Jordan Station
Pri
ページ2に含まれる内容の要旨
For future reference, record your dishwasher information in the box below. Model Number__________________________ Serial Number_______________________ Voltage________________Hertz_____________ Phase__________________ Moyer Diebel Service Agent __________________________________ Tel:______________________ Moyer Diebel Parts Distributor _________________________________ Tel:______________________ For all models: The data plate mounts to the right-hand, side of the top-mounted control cabinet.
ページ3に含まれる内容の要旨
Revisions to this manual _____________________ Revisions to this manual This is where we record changes to the manual. A revision might be a part number change, new instructions, or information that was not available at the time of printing. We reserve the right to make changes to this manual without notice and without incurring any liability by making the changes. Dishwasher owners may request a revised manual, at no charge, by calling 1 (800) 858-4477 in the USA or 1 (800) 263-5798) in
ページ4に含まれる内容の要旨
Dear Owner: Thank-you for choosing our dishwasher. We appreciate your business. This manual covers two models: MD-1000HT Pumped rinse high temperature door -type dishwasher with standard built-in booster in 40° F/22° C rise or an optional 70° F/39° C rise booster. MD-1000LT Pumped rinse low temperature chemical sanitizing door-type dishwasher with built-in chemical dispensing pumps for detergent, rinse-aid, and sanitizer. The installation, and initial start-up of your dishwasher must be perf
ページ5に含まれる内容の要旨
Table of Contents _____________ Table of Contents Revisions to this manual_______________________________________________ iii Limited Warranty ___________________________________________________ vi Installation Guide MD-1000HT: High temperature Door-type Dishwasher _________ pg.2 Unpack and Place Water Connection Drain Connection Electrical Connection Ventilation Chemical Dispensers _____________________________________________________ Initial Start-up ___________________________________
ページ6に含まれる内容の要旨
Limited Warranty Limited Warranty Moyer Diebel, P.O. Box 4183, Winston-Salem, North Carolina 27115, and P. O. Box 301, 2674 North Service Road, Jordan Station, Ontario, Canada L0R 1S0 warrants machines, and parts, as set out below. Warranty of Machines: Moyer Diebel warrants all new machines of its manufacture bearing the name “Moyer Diebel” and installed within the United States and Canada to be free from defects in material and workman- ship for a period of one (1) year after the date of in
ページ7に含まれる内容の要旨
Installation Guide _____________ Installation Guide Unpack and Place MD-1000HT 1. Check the corrugated box that protected the dishwasher during shipment for punched holes or impact marks. 2. Inspect the shipping pallet for splintered or broken boards. 3. Inspect the exterior of the dishwasher while still mounted on the pallet for signs of damage. 4. Contact the freight company immediately if damage is found and save all packing for inspection to verify your damage claim. 5. Report the damage t
ページ8に含まれる内容の要旨
MD-1000HT • Unpack and Place Installation Guide _____________ Unpack and Place MD-1000HT 1. The installation of your dishwasher must be performed by qualified service personnel. 2. Problems due to improper installation are not covered by the Warranty. 3. Compare the utilities at the installation site with the specifications listed on each model's specification sheets ( See Appendix A at the end of this manual) 4. The dishwasher data plate is located on the left, rear-corner of the top-mounted
ページ9に含まれる内容の要旨
wall MD-1000HT • Unpack and Place _____________ Installation Guide Unpack and Place MD-1000HT 1. All dishwashers ship in the straight-through configuation. 2. Relocate the tracks and remove the wall-side door link components to convert the dishwasher for corner operation. 1 2 Move Part 2 Move Part 1 3 Remove Interior Door Bracket 4 Remove Door Linkage 5 Adjust Door Spring Tension 3 1 2 wall
ページ10に含まれる内容の要旨
MD-1000HT • Unpack and Place Installation Guide _____________ Unpack and Place MD-1000HT 1. Compare the dishwasher and site utility connections. 2. Level the dishwasher by adjusting the bullet feet. 3. Raise the doors and check the door clearance to the ceiling. 4. Move the dishwasher to its permanent location. Note: Installers must follow applicable sanitation, safety, plumbing, and electrical codes and regulations; and work in accordance with best practices for dishwasher installation. Util
ページ11に含まれる内容の要旨
MD-1000HT • Electrical Connection _________________ Installation Guide Electrical Connection MD-1000HT Warning: The dishwasher must be electrically grounded according to all local codes and regulations governing the installation of electrical service. Warning: Disconnect the main electric supply and place a tag at the fuse or disconnect switch indicating that work is being performed on that circuit. 1. Locate the control cabinet keys on the rear of the control cabinet. 2. Remove 1 key to unlo
ページ12に含まれる内容の要旨
MD-1000HT • Water Connection Installation Guide _____________ Water Connection MD-1000HT 1. Locate the built-in stainless steel booster on the left-side of the dishwasher. Note: The existing hot water supply lines to the dishwasher must be 3/4" NPT or larger. To the best of your ability inspect, and verify that all supply piping meets the 3/4" NPT requirement. Note: The installing plumber must connect a water supply line to the dishwasher that is equal to or greater than 3/4" NPT in size and
ページ13に含まれる内容の要旨
Blank Page This Page Intentionally Left Blank 7
ページ14に含まれる内容の要旨
MD-1000HT • Drain Connection Installation Guide _____________ Drain Connection MD-1000HT Continued from page 7 1. Locate the dishwasher drain connection underneath the machine frame. 2. Install a drain line conforming to local plumbing and health regulations. Drain: 1-7/8" stainless steel, slip-fit hose connection Max flow: 15 US gal/min. 13.5 Imperial gal/min 57liters/min. Ventilation MD-1000HT 1. The factory has no requirements for vent hoods; but, local codes and regulations in your are
ページ15に含まれる内容の要旨
MD-1000HT • Chemical Dispensers _______________ Installation Guide Chemical Dispensers MD-1000HT 1. The MD-1000HT high temperature dishwasher sanitizes with 180-195° F/82-91° C hot final rinse water. 2. Do not connect a sanitizer chemical dispenser to the MD-1000HT. 3. You may wish to contact a chemical supplier to supply the chemical dispensers and chemicals for liquid detergent and liquid rinse-aid. (Consult your local listings). 4. The chemical supplier must adjust their dispensers to pro
ページ16に含まれる内容の要旨
MD-1000HT • Chemical Dispensers Installation Guide _____________ Chemical Dispensers MD-1000HT Continued from page 9 115VAC Power Connections for Chemical Dispensers FOR QUALIFIED INSTALLERS ONLY Warning: Chemical dispensers must be electrically grounded in compliance with applicable electric codes. Warning: Disconnect the main electric supply and place a tag at the fuse or disconnect switch indicating that work is being performed on that circuit.
ページ17に含まれる内容の要旨
MD-1000HT • Chemical Dispensers _________________ Installation Guide Chemical Dispensers MD-1000HT 4. The diagrams below are taken from the electrical s chematic and are shown to help you locate and focus on the steps necessary to connect the your dispensing pumps to the dishwasher. L1 L2 L2 GND 12 3 208VAC/3PH/60/3 Main terminal block Detergent dispensing pump & cycle Rinse-aid dispensing pump & cycle and ground lug Timer cam No.6 with timer microswitch timer cam No.7 with timer microswi
ページ18に含まれる内容の要旨
MD-1000HT • Chemical Dispensers Installation Guide _____________ Chemical Dispensers MD-1000HT Continued from page 11 5. The main terminal board is the termination point for the incoming power and earth ground which is also called the chassis ground. 6. Chemical dispensers (not supplied by Factory) should be grounded to chassis if possible. 7. The detergent signal and the rinse-aid signal terminals for your chemical dispensing pumps are provided on the common terminal of each Timer Cam micros
ページ19に含まれる内容の要旨
MD-1000HT • Chemical Dispensers ________________ Installation Guide Chemical Dispensers MD-1000HT Caution: The NEUTRAL RETURN (#2 white wires) and Chassis Ground are not the same point electrically. Improper wiring to these points may result in unusual voltage readings and damage to the dishwasher's electrical circuits.STOP WORKING ON THE DISHWASHER AT ONCE, if you do not know the difference between a neutral return and chassis ground. Note: You may void the dishwasher warranty if you conne
ページ20に含まれる内容の要旨
MD-1000HT • Chemical Dispensers Installation Guide _____________ Chemical Dispensers MD-1000HT Priming the chemical dispensers (Factory dispensers only) 1. Factory dispensers are optional equipment; however, an automatic dispenser must be installed by someone in lieu of the factory. OUT OUT IN IN 2. The dispensers are mounted on From the right-hand side of the lower To wash tank Chemical injection points wash tank. Containers 3. Chemical pick-up tubes are inserted into their respective c
