ページ1に含まれる内容の要旨
User manual
Dishwasher
ZDI 200
ページ2に含まれる内容の要旨
Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appli- ance. Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ 3 Unloading the dishwasher _ _ _ _ _ _ _ _ 16 Control panel _ _ _ _ _ _ _ _ _
ページ3に含まれる内容の要旨
Safety information • Under no circumstances should you attempt In the interest of your safety and to ensure the to repair the machine yourself. Repairs car- correct use, before installing and first using the ried out by inexperienced persons will cause appliance, read this user manual carefully, in- injury or serious malfunctioning. Contact cluding its hints and warnings. To avoid unnec- your local Service Force Centre. Always in- essary mistakes and accidents, it is important sist on genuine sp
ページ4に含まれる内容の要旨
or if the control panel, work top or plinth area Installation are damaged such that the inside of the ap- • Check your dishwasher for any transport pliance is freely accessible. Contact your damage. Never connect a damaged ma- local Service Force centre, in order to avoid chine. If your dishwasher is damaged con- hazard. tact your supplier. • All sides of the dishwasher must never be • All packaging must be removed before use. drilled to prevent damage to hydraulic and • Any electrical and plumb
ページ5に含まれる内容の要旨
Control panel 1 Programme selection buttons 2 Delay start button 3 Indicator lights 4 On/Off button 5 Function buttons the appliance MUST be in setting mode. Setting mode If a programme light is illuminated, the last The appliance is in setting mode when the On/ performed programme is still set. Off light is on and all programme lights are off. In this case the programme has to be cancelled: 1. Press and hold simultaneously function IMPORTANT! buttons B and C until all programme Always remember
ページ6に含まれる内容の要旨
Function buttons In addition to the dishwashing programme selection, the following functions can also be set with the help of these buttons. – the setting of the water softener, – the cancelling of a programme in progress. Programme selection buttons • Starting the washing programme: 1. Press the On/Off button. On/Off light turns on. 2. Press the button corresponding to the required programme, the corresponding light illuminates . The indicator light corresponding to the pro- gramme and the phas
ページ7に含まれる内容の要旨
IMPORTANT! It is possible to select a washing programme and the delay start also with the door slightly opened. In this case the start of the programme or the countdown will occur after the closure of the door. Until that moment it is possible to modify the set made. Indicator lights Wash Illuminates when the washing and rinsing phases are 1) running. Dry Illuminates when the drying phase is running. 1) End of programme Illuminates when the washing programme has ended. It also has added function
ページ8に含まれる内容の要旨
Washing programmes Programme Use Cycle description Intensive 70° Heavy soil. Prewash Crockery, cutlery, pots and pans Main wash 2 intermediate rinses Final rinse Dry Normal 65° Normal soil. Prewash Crockery and cutlery Main wash 2 intermediate rinses Final rinse Dry 65°A30' Light soil. Main wash Crockery and cutlery Final rinse 50° Normal soil. Prewash Crockery cutlery Main wash 1 intermediate rinse Final rinse Dry Rinse and Hold Any. Prewash Partial load (to be completed later in the day). Thi
ページ9に含まれる内容の要旨
1. Fill up the rinse aid dispenser with rinse aid. When using tablets that 2. Set the rinse aid dosage to position 2. integrate rinse aid, detergent, If you decide in future to use separated deter- salt function and other gents, we advise that you: additives: – Fill up the salt and rinse aid container. – Adjust the water hardness setting to the there is no need to fill up with special salt or rinse aid. highest level and perform 1 normal washing Check whether these detergents are suitable progra
ページ10に含まれる内容の要旨
Water hardness Adjusting the water hardness Use of salt setting °dH °TH mmol/l manually electronically 15 - 18 26 - 32 2,61 - 3,2 1 level 4 yes 11 - 14 19 - 25 1,9 - 2,5 1 level 3 yes 4 - 10 7 - 18 0,71 - 1,8 1 level 2 yes < 4 < 7 < 0,7 1 level 1 no The water softener must be set in both ways: manually, using the water hardness dial and electronically. Setting the water softener manually (see table) The water softener is factory set at position 2. Set switch to position 1 or 2 Setting the water
ページ11に含まれる内容の要旨
• The dishwasher must be switched off. • The End of programme light might flash 5 times, Switch on the dishwasher by pressing the On/Off for example. The flashing is repeated every 5 sec- button. onds. • Press and hold simultaneously function buttons B • To change the level, press function button A. Each and C until the lights of function buttons A , B and time the button is pressed the level increases. C start flashing. (Level 1 follows level 10). • Release the buttons and then press function
ページ12に含まれる内容の要旨
IMPORTANT! Immediately start a complete programme. IMPORTANT! Water will overflow from the container as salt is add- ed. Remove any trace of salt. Replace the cap tightly turning it clockwise until it stops with a click. IMPORTANT! Top up the special salt when the light on the control panel illuminates. Filling with rinse aid Open the lid. Fill up with rinse aid. The Clean up any rinse aid maximum level for filling which overflows. Close is indicated by "max" the lid and press until it locks. IM
ページ13に含まれる内容の要旨
Adjusting the dosage of rinse aid Increase the dose if there are drops of water or Reduce the dose if there are whitish streaks on lime spots on the dishes after washing. the dishes or a bluish film on glassware or knife blades. Open the lid. Set the dosage level. Close the lid and press (The dose is factory set in until it locks. position 4). Loading cutlery and dishes – Dishes and items of cutlery must not lie Sponges, household cloths and any object that inside one another, or cover each othe
ページ14に含まれる内容の要旨
For washing in the dishwasher the following cutlery and dishes are not suitable: are of limited suitability: • Cutlery with wooden, horn, china or mother-of- • Only wash stoneware in the dishwasher if it is spe- pearls handles. cially marked as being dishwasher-safe by the manufacturer. • Plastic items that are not heat resistant. • Glazed patterns may fade if machine washed fre- • Older cutlery with glued parts that are not temper- quently. ature resistant. • Silver and aluminium parts have a t
ページ15に含まれる内容の要旨
Load upper basket. Light For taller items, the cup If plates are to be loaded in the upper basket: load items (plastic bowls etc.) racks can be folded up- them starting from the rear positions; tilting them must be loaded in the up- wards. slightly forwards and avoiding the front positions per basket and arranged near the door. so they do not move. Adjusting the height of the upper basket If washing very large plates you can load them in the lower basket after moving the upper bas- ket to the hi
ページ16に含まれる内容の要旨
Use of detergent IMPORTANT! Observe the manufacturer’s dosing and stor- age recommendations. Only use detergents suitable for dishwashers. Open the lid. Fill in the detergent in Observe the dosing lev- compartment A. els. For programmes with When using detergent Close the lid. prewash add an addition- tablets: place detergent al detergent dose in com- tablets in compartment partmentB. A. Unloading the dishwasher • Hot dishes are sensitive to knocks. • Water may appear on the sides and the door
ページ17に含まれる内容の要旨
Care and cleaning Cleaning the filters IMPORTANT! NEVER use the dishwasher without filters. In- correct repositioning and fitting of the filters will produce poor washing results. Clean filters A, B and C Turn the handle about 1/4 Remove filter A from the thoroughly under running turn anticlockwise and base of the washing water. remove filters B and C. compartment. Put the flat filter A back in Replace the filters and the base of the washing lock by turning the handle compartment and ensure c
ページ18に含まれる内容の要旨
abrasive products, scouring pads or solvent Frost precautions (acetone, trichloroethylene etc....). Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoid- Internal cleaning able, empty the machine, close the appliance Ensure that the seals around the door, the de- door, disconnect the water inlet pipe and empty tergent and rinse aid dispensers are cleaned it. regularly with a damp cloth. We recommend every 3 months to run the wash Moving the machine progr
ページ19に含まれる内容の要旨
caused by inappropriate waste handling of this local city office, your household waste disposal product. For more detailed information about service or the shop where you purchased the recycling of this product, please contact your product. Something not working The dishwasher will not start or stops during Switch off the dishwasher, open the door and operation. Certain problems are due to the lack carry out the following suggested corrective ac- of simple maintenance or oversights, which can ti
ページ20に含まれる内容の要旨
Fault code and malfunction Possible cause and solution • The programme does not start. • The dishwasher door has not been properly closed. Close the door. • The main plug is not plugged in. Insert the mains plug. • The fuse has blown in the household fuse box. Replace the fuse. Once these checks have been carried out; This information can be found on the rating close the dishwasher’s door and switch on the plate located on the side of the dishwasher appliance. Press the button of the programme d
