ページ1に含まれる内容の要旨
GB
User manual 2
Dishwasher
ZSF2450
ページ2に含まれる内容の要旨
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Setting and starting a washing Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 programme _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Washing programmes _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 11 Use of the appliance _ _ _ _ _ _ _ _ _ _ _ _ _ 6 What to do if… _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 13 Setting the water softener _ _ _ _ _ _ _ _ _ _ 6 Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 14 Use o
ページ3に含まれる内容の要旨
• Do not use the appliance: Installation – if the mains cable or water hoses are dam- • Make sure that the appliance is not damaged aged, because of transport. Do not connect a dam- aged appliance. If necessary, contact the sup- – if the control panel, worktop or plinth area plier. are damaged, that you can get access to the inner side of the appliance. • Remove all packaging before first use. Contact your local Service Force Centre. • A qualified and competent person must do the • Do not drill
ページ4に含まれる内容の要旨
Indicator lights The indicator light comes on when the washing phase or the rinsing phase operates. The indicator light comes on when the drying phase operates. The indicator light comes on when the washing programme is completed. The indicator light comes on when it is necessary to fill the salt container. Refer to the chapter 'Use 1) of dishwasher salt'. The salt indicator light can stay on for some hours, but it does not have an unwanted effect on the operation of the appliance. The indicator
ページ5に含まれる内容の要旨
Washing programmes Degree of Programme Type of load Programme description soil Prewash Crockery, Main wash up to 70°C cutlery, Heavy soil 2 intermediate rinses pots and Final rinse pans Drying Prewash Crockery, Mixed nor- Main wash up to 45°C or 70°C cutlery, mal and 1 or 2 intermediate rinses 1) pots and light soil Final rinse pans Drying Prewash Main wash up to 55°C Normal Crockery 1 intermediate rinse 2) soil and cutlery Final rinse Drying Main wash up to 50°C Normal or Crockery 1 intermediat
ページ6に含まれる内容の要旨
Programme Programme duration Energy consumption Water consumption (in minutes) (in kWh) (in litres) 1) - 0,4 6,0 1) The digital display shows the programme duration. The pressure and temperature of the water, the variations of power supply and the quantity of dishes can change these values. Use of the appliance Refer to the following instructions for each step 5. Set the correct washing programme for the of procedure: type of load and soil. 1. Make a check if the water softener level is 6. Fill
ページ7に含まれる内容の要旨
3. Press and hold function buttons B and C until – The digital display shows the current level. the indicator lights of function buttons A, B Example: digital display shows = level 3. and C start to flash. 6. Press the function button A one time to in- 4. Release function buttons B and C. crease the water softener level by one step. 5. Press function button A. 7. Press the on/off button to save the opera- tion. – The indicator lights for function buttons B and C go off. – The indicator light fo
ページ8に含まれる内容の要旨
max 1 2 3 4 Caution! Do not fill the rinse aid dispenser with other products (e.g. dishwasher cleaning agent, liquid detergent). There is a risk of damage to the appliance. Adjusting the dosage of rinse aid The rinse aid dial is set at the factory at posi- tion 1. To increase or de- crease the dosage re- fer to 'What to do if...' Loading cutlery and dishes – Make sure that cutlery and dishes do not lie Helpful hints and tips inside one another. Caution! Only use the appliance for – Make sure t
ページ9に含まれる内容の要旨
Primary basket Arrange long and/or sharp items of cutlery hor- izontally in the primary basket. Be careful with Arrange the deep sharp items such as knives. dishes and large lids around the edge of the basket. Arrange the items to let water touch all surfaces. 1 Arrange items on and below the cup racks. 1 2 For longer items fold Use the cutlery grid. If Use the cutlery basket the cup racks up. for: the dimensions of the cutlery prevent use of • forks and spoons Cutlery basket the cutlery grid, r
ページ10に含まれる内容の要旨
It is not necessary to fill the salt container and the rinse aid dispenser. Do these steps when the drying results are A not satisfactory: 1. Fill the rinse aid dispenser with rinse aid. 2. Set the rinse aid dosage to position 2. Do these steps to use the detergent powder 5 6 again: 1. Fill the salt container and the rinse aid dis- Use of detergent tablets penser. Put the detergent tablet in the detergent dis- 2. Set the water softener to the highest level. penser (A). 3. Do a washing programme
ページ11に含まれる内容の要旨
2. Set a new washing programme . – When you cancel a delay start, you also Fill the detergent dispenser with detergent be- cancel the washing programme. fore you set a new washing programme. 2. Set a new washing programme. Interrupting a washing programme You can select the washing programme and Open the door. delay start also with the door closed. When you press a programme button you have only 3 • The programme stops. seconds to select a different washing programme Close the door. or a delay s
ページ12に含まれる内容の要旨
A B 1 2 1 2 Remove the filters A and B from the bottom of the appliance. 2 1 3 External cleaning 3 4 Fully clean the filters Clean the external surfaces of the appliance and below running water. control panel with a damp soft cloth. Only use neutral detergents. Do not use abrasive products, 1 scouring pads or solvents (acetone, trichloro- ethylene etc...). Frost precautions 2 Caution! Do not install the appliance where the temperature is below 0 °C. The manufacturer is not responsible for d
ページ13に含まれる内容の要旨
What to do if… The appliance does not start or stops during op- the problem yourself, contact your dealer or the eration. Service Force Centre. If there is a fault, first try to find a solution to the problem yourself. If you cannot find a solution to Fault code and malfunction Possible cause and solution • • The water tap is blocked or furred with limescale. digital display shows Clean the water tap. The dishwasher does not fill with water • The water tap is closed. Open the water tap. • The f
ページ14に含まれる内容の要旨
The cleaning results are not satisfactory The dishes are not clean • The selected washing programme is not applicable for the type of load and soil. • The basket is loaded incorrectly so that water cannot reach all surfaces. • Spray arm does not turn freely because of incorrect arrangement of the load. • The filters are dirty or not correctly installed. • The quantity of detergent is too little or missing. Limescales particles on the • The salt container is empty. dishes • The water softener is
ページ15に含まれる内容の要旨
Warning! To discard the appliance, follow household waste disposal service or the shop the procedure: where you purchased the product. • Pull the mains plug out of the socket. The packaging materials are environmentally • Cut off the mains cable and mains plug and friendly and can be recycled. The plastic compo- discard them. nents are identified by markings, e.g. >PE<, >PS<, • Discard the door catch. This prevents the chil- etc. Discard the packaging materials in the appli- dren to close thems
ページ16に含まれる内容の要旨
If the water inlet hose is too short, replace the connected to the mains socket, the water safety water inlet hose with an applicable, longer high- system operates when the dishwasher is off. pressure hose. Do not connect an extension hose. Two procedures are possible to install the water To suit the installation, it is possible to turn the drain hose : end of the hose that is connected to the dish- washer. Do these steps : 1 1. Loosen the retain- ing nut. 2. Turn the hose. 2 max. 75cm 3. Tighte
ページ17に含まれる内容の要旨
17
ページ18に含まれる内容の要旨
18
ページ19に含まれる内容の要旨
19
ページ20に含まれる内容の要旨
To buy accessories, consumables and spare parts at our online shop please visit: www.zanussi-electrolux.co.uk www.zanussi.com 156986160-00-012009
