ページ1に含まれる内容の要旨
INSTRUCTION BOOKLET
DISHWASHER
ZT 617
ページ2に含まれる内容の要旨
CONTENTS Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 3 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 4 Positioning, levelling, water supply connections, water outlet connection . . . . . . . . . . . . . . . . . . . . . . . .page 4 The electrical connections . . . . . . . . . .
ページ3に含まれる内容の要旨
WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety. You MUST read them carefully before installing or using
ページ4に含まれる内容の要旨
INSTALLATION Remove all packaging before positioning the To make this easier, the machine. hose itself may be turned to the left or the right. In either Positioning case, be sure to incorporate the strainer (A) supplied If possible, position the machine next to a water tap with the machine into the and a drain. joint. See picture. The dishwasher features fill and drain hoses which can be turned either to the left or the right to suit the CA06 installation . Caution: the retaining ring must be
ページ5に含まれる内容の要旨
A replacement cover/carrier must be obtained from The electrical connections your local Zanussi Service Force Centre whose WARNING: THIS APPLIANCE MUST BE EARTHED. address is listed in the Customer Care Booklet which accompanies your instruction manual. The manufacturer declines any liability should this safety measure not be observed. This appliance complies with the follow- ing E.E.C. Directives: - 73/23 of 19.2.73 (Low Voltage Directive) and sub- If the plug that is fitted to your appliance
ページ6に含まれる内容の要旨
USE Control panel 3 1 2 4 5 6 7 8 9 10 11 THE CONTROLS 1. ON/OFF button The controls are located on top of the door. When se- ON lecting a programme, the door needs to be partially Press this button to preset the dishwasher to accept opened. settings (selection of wash programmes, drying Audible signals indicate which operations the dishwasher options, delayed start, etc.). is performing. The salt pilot light (3) and the rinse aid light (2) comes on if salt or rinse aid are low and the Sho
ページ7に含まれる内容の要旨
5. PROGRAMME SELECTION button 10. DELAY START button To select the required programme, press this button The start of the programme can be delayed by a mini- until the number corresponding to the chosen pro- mum of 1 hour, up to a maximum 9 hours. gramme appears in the digital display (4) (see wash How to set DELAY START programme guide). To start the programme, simply close the dishwasher door. A long audible signal By pressing the button, will appear on the digital (about one second) informs
ページ8に含まれる内容の要旨
Important The Water Softener Salt MUST be used regularly from level 1 upward. Water contains varying amounts of lime and mineral salts depending on the area in which you live: these If your water is «level 0» it is already soft and therefore are deposited on the dishes leaving white marks. there is no need to use salt. The higher the content of these salts, the harder your water will be. The «hardness» level is measured on 3 Filling with Salt equivalent scales: French Degrees, German Degrees o
ページ9に含まれる内容の要旨
1 2 1 3 2 4 3 To help you to correctly Rinse Aid D dose the right amount of This liquid gives the dishes a shiny finish and detergent, inside the con- improves drying. It is automatically added during the tainer there are two refer- hot rinse. The dispenser, which is positioned inside ence marks. the door, holds about 110 ml of rinse aid, which is - MIN = 15 ml sufficient for 16-40 dishwashing programmes, - MAX = 30 ml depending upon the dosage setting. DE07 Filling with Rinse Aid After fill
ページ10に含まれる内容の要旨
The cutlery basket is in Loading your Machine two parts which can be Before placing dishes in the machine, remove any separated to give greater scraps of food from the plates (small bones, loading flexibility. To separate toothpicks, fish bones, scraps of meat and vegetables, the two parts, slide them hori- fruit skins etc.) to avoid clogging the filters and zontally in opposite directions consequently reducing performance. and pull them apart. To re- assemble, reverse the proce- Open the doo
ページ11に含まれる内容の要旨
Caution Adjusting the Height of the Upper Basket When loading the dishes, If washing very large plates (over 27 cm and up to 31 ensure that you do not cm in diameter) you can load them in the lower cover the water inlet basket after moving the upper basket to the higher funnel in the middle of the position as follows: upper basket. - pull out the basket; - grasp it on the two sides and pull it upwards until US04 the mechanism is en- gaged and the basket is stable. Before closing the door, ens
ページ12に含まれる内容の要旨
WASHING PROGRAMMES Recommended quantity of detergent Degree of soil and Recommended Required Cycle Pro- in the SID in the Description type of load programme Pushbuttons gramme (Super Intensity dispenser Dispenser) Any. RINSE 1 cold rinse (to avoid PROGRAMMES Partial load (to be com- AND food scraps from SELECTION pleted later in the day). / / HOLD sticking to the dishes). 1 Heavy soil. INTENSIVE 2 level Prewash up to 50°C 1 level PROGRAMMES Crockery, cutlery, pots 70°C dessert dessert Main wa
ページ13に含まれる内容の要旨
Operating Sequence 7 Starting the wash programme 1 Check that the filters are clean Open the water tap. (see cleaning instructions) Close the dishwasher door. An audible signal lasting about 1 second informs you 2 Switch on at the main supply that the programme has started. If a delayed start has been selected, the dishwasher starts the countdown and the number of hours to go 3 Depress the ON/OFF pushbutton before the programme starts appears in the display. A In the display appears the numbe
ページ14に含まれる内容の要旨
MAINTENANCE AND CLEANING Cleaning the Central Filter Internal and External Cleaning (After each wash) You must ensure that the seals around the door, the Scraps of food can sometimes accumulate in the cen- detergent and rinse aid dispensers are cleaned tral filter (A) and should be periodically removed by regularly with a damp cloth. rinsing the filter under running water. We recommend the use of a specific dishwasher To remove the filter, simply cleaner every 3 months, or run a wash programm
ページ15に含まれる内容の要旨
Prolonged Periods of Non-Operation If you are not using the machine for any period of time you are advised to: unplug the appliance and turn off the water; fill the rinse aid dispenser; leave the door ajar to prevent the formation of unpleasant smells; leave the inside of the machine clean. Frost Precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the water inlet tap, disconnect the water inlet pipe and e
ページ16に含まれる内容の要旨
SERVICING Certain problems are due to lack of simple mainte- For washing or drying problems, please carry out nance or oversights and can be solved easily without the checks listed below: having to call out an engineer. Therefore before call- ing the Service, consult the check list here below. The dishes are not clean (poor wash); The following alarms, (A3, A5, A6, A1, A2, A7) flash in n The baskets are too full. the digital display window. The dishwasher fails to start or stops during operati
ページ17に含まれる内容の要旨
If, after the above checks the fault persists, call your Protection against flooding local Zanussi Service Centre, whose address can be To protect your dishwasher from water damage, it is found in the accompanying Customer Care Booklet, equipped with a flood protection system. and can also be found in your local telephone directo- ry under «Z». Please make sure you give the model It features an flood protection (float switch in the floor and serial number of the appliance. This information tray
ページ18に含まれる内容の要旨
596 600 BUILDING-IN Mounting of decor panel onto the door Building-in features The height of the panel depends on the height of the This dishwasher is designed to be fitted under a kitchen plinth of adjacent kitchen units (see kitchen plinth counter or sink. adjustment). In either case, it is essential that the recess dimensions indicated in the picture are followed. The panel must be fitted 596 max No further openings for venting of the dishwasher are with a handle, as the dish- required, but
ページ19に含まれる内容の要旨
Fixing to the adjacent units Levelling Insert the two fixing brackets Make sure that the dishwasher door closes properly, into the slots provided in the without rubbing on sides. Otherwise level the machine top front part of the by slightly screwing or unscrewing the two front feet dishwasher, as shown in the until perfect closure of the door is reached. figure. Kitchen plinth adjustment Secure the brackets to To allow correct opening of adjacent units using two the door it is sometimes 3,5 x
ページ20に含まれる内容の要旨
PEACE OF MIND FOR TWENTY FOUR MONTHS Zanussi guarantee conditions Exclusions This guarantee is in addition to your statutory and This guarantee does not cover: other legal rights. n Damage or calls resulting from transportation, We, Zanussi Ltd., undertake that if, within twenty four improper use or neglect, the replacement of any months of the date of the purchase, this ZANUSSI light bulbs or removable parts of glass or plastic. appliance or any part thereof is proved to be defective n Co
