ページ1に含まれる内容の要旨
INSTALLATION INSTRUCTIONS
LAT-NR130
LED Tail Lights for 1965 Nova
MAN#650176
Kit Includes:
Installation:
1. Remove the tail light lens.
2. Remove the light bulb.
3. Remove the original bulb connector from the back side of the housing.
4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is
recommended.
5. Remove the screw and aluminum back plate from the new LED assembly.
ページ2に含まれる内容の要旨
6. Insert the new LED assembly through the hole where the original bulb and connector were. Use caution when feeding the wires through to avoid damaging the wire insulation. 7. Feed the wires through the large hole on the back plate. The flat side of the back plate should be toward the outside and the side with the slightly raised center should go in toward the housing. Guide the back plate onto the back side of the housing. 8. Secure the back plate with the supplied #6 screw and loc
ページ3に含まれる内容の要旨
10. Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the wires from LED assembly to appropriate length once mounted, making sure wires are routed cleanly and securely. 11. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED assembly to the existing vehicle harness. Insert appropriate wire from vehicle harness and mating LED assembly wire into a connector and crimp following instructions below. *For the bes