ページ1に含まれる内容の要旨
INSTALLATION INSTRUCTIONS
LAT-NR291
LED Tail Lights for 1969 Firebird.
MAN# 650201
Kit Includes:
Installation:
1. Remove the original bulb sockets.
2. Remove the tail light housing hardware so the housing can be removed from the car. Remove
the housings from the vehicle carefully so the body gaskets are not damaged.
3. Next remove the lens to gain access to the housing. There are four screws that hold the lens in
place, remove the screws and separate the lens ca
ページ2に含まれる内容の要旨
6. Pass the wires through the housing where the original bulb and socket were. Set the LED assemblies into the housing so the studs extend out the hole in the bottom of the housing. 7. Feed the wires through the larger hole in the mounting plate. Guide the mounting plate to the bottom of the housing. The flat side of the mounting plate should be down and the side with the slight raised center should go up toward the housing. This will align the mount in the original housing.
ページ3に含まれる内容の要旨
12. Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the wires from LED assembly to appropriate length once mounted, making sure wires are routed cleanly and securely. 13. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED assembly to the existing vehicle harness. Insert appropriate wire from vehicle harness and mating LED assembly wire into a connector and crimp following instructions below. *For the bes