ページ1に含まれる内容の要旨
INTRODUCTION
This 900 MHz digital hybrid wireless speaker system uses latest wireless technology
that enables you to enjoy music and TV sound anywhere inside or outside your home.
SPK-VELO-001
You can simply connect the system to any audio source such as Radio, TV, VCR,
Hi-Fi and CD/MP3/VCD/DVD player. Without complicated wiring and installation with
your Audio/Video equipment and rear channel amplifier, the system enables you to
900MHz Digital Hybrid Wireless
enjoy thrilling, life
ページ2に含まれる内容の要旨
COMPONENT IDENTIFICATION INSTALLATION TRANSMITTER TRANSMITTER Antenna 1. Insert the antenna tube into the antenna wire. Signal On Indicator (blue) Power On Indicator (red) SPEAKER RECEIVERS 2. Connect the supplied AC/DC power adaptor to an electrical wall outlet. 3. Plug the AC/DC power adaptor in the DC jack located on the rear of the transmitter. 4. When the AC adapter is plugged in, the red POWER LED illuminates. If the red POWER LED does not illumina
ページ3に含まれる内容の要旨
OPERATION 1. Turn on the audio source (TV or audio component) to which the transmitter is connected with. The blue signal LED on the transmitter will light up. 2. Select the channel 1 or 2 of the transmitter for best performance in your location. 3. Turn on the ON/OFF button on the speakers (the ON/OFF button on the remote control unit cannot be used as a primary device to switch on the speakers). Press the “AUTO TUNE” button to get the best tuning reception in the speakers. When
ページ4に含まれる内容の要旨
then turn off, or simply press the ON/OFF button on the remote control unit. If you use the remote control unit to turn off the speakers, the speakers will be at stand-by mode for 5 minutes and the LED will change from blue to yellow. You can switch on the speakers again by using the remote control unit during the stand-by time. If there is no signal from the remote control unit in 5 minutes, the speakers will automatically power off. WARNING: The Power adapters are for ind
ページ5に含まれる内容の要旨
TROUBLE SHOOTING TECHNICAL SPECIFICATIONS NO SOUND Transmission Mode : UHF - Ensure the AC/DC adaptor is fully inserted into the AC outlet and the Carrier Frequency : 900 MHz Digital Hybrid power connection input on the transmitter. Operation Voltage : Transmitter, DC 12V 150mA - Ensure the speakers are switch ON. Speakers, 6 X ‘C’ size Alkaline batteries or DC - Speaker’s battery capacity is too low, replace with new batteries or 9V 1A adaptor connect the AC/DC adaptors to the
ページ6に含まれる内容の要旨
NOTE: This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that inter