Ingersoll-Rand 2940の取扱説明書

ページ1に含まれる内容の要旨

04584447
Edition 3
October 2009
Air Impact Wrench
2934 and 2940 Series (D handle)
Parts Information
Save These Instructions

ページ2に含まれる内容の要旨

2934 and 2940 Series (D handle) Air Impact Wrench Exploded Diagram (Dwg. TPA1333-3) 2 04584447_ed3 47 43 46 34A 45 48 34 44 20 33 Spline Drive Anvil Assembly 37 22 27G 36 27F 26A 49 25 27 19 38 39 1 37 55 42 23 27 35 36 54 2 53 16 6 26 15 30 29 41 18 27D 27C 17 27B 7 40 27A 21 51 5 50 41 13 9 28 52 8 24 32 31 10 27E 12 11 Outside Trigger Handle

ページ3に含まれる内容の要旨

2934 and 2940 Series (D handle) Air Impact Wrench Parts List Item Part Description Part Number Item Part Description Part Number 1 Inside Trigger Handle Assembly 2934-A92A * Oversize Hammer Case Bushing 2 Grease Fitting 130SR-188 .005” oversize 293-641-5 5 Trigger 834-93A .010” oversize 2934-641-10 6 Trigger Pin 534-265 .015” oversize 2934-641-15 7 Throttle Valve Plunger 2934-302 † 35 Hammer Case Gasket 2934-36 8 Throttle Valve Assembly 2934-A50 36 Hammer Case Cap Screw (4) 834-638 † • 9 Throttl

ページ4に含まれる内容の要旨

Model 2934B9 Air Impact Wrench with No. 2934A90 Angle Attachment 110 107 106 105 101 104 100 102 116 108 117 119 103 115 112 111 118 107 114 113 115 109 (Dwg. TPC357-1) The 2934 Series Air Impact Wrench can be furnished with a 1” square drive 2934A90 Angle Attachment and when so furnished is designated as 2934B9. Following are the parts used only in the 2934B9. All parts not listed are the same as for a 2934 Series Air Impact Wrench with Inside Trigger Handle, Side Spade Handle and a 1” square

ページ5に含まれる内容の要旨

Notes:

ページ6に含まれる内容の要旨

Notes:

ページ7に含まれる内容の要旨

Notes:

ページ8に含まれる内容の要旨

www.ingersollrandproducts.com © 2009 Ingersoll Rand Company