ページ1に含まれる内容の要旨
A-DNT-00- 12()
Additional Information for
Using Sony Wall-Mount Bracket (SU-WL700)
Compatible TV models for this Wall-Mount Bracket information:
KDL-52NX807/KDL-52NX800/KDL-46NX807/KDL-46NX800/KDL-46NX705/
KDL-40NX705/KDL-46NX700/KDL-40NX700
For product protection and safety reasons, Sony strongly recommends that you use the
Wall-Mount Bracket model designed for your TV and that the wall-mounting of your TV
is performed by Sony dealers or licensed contractors.
To Customers
Please provide
ページ2に含まれる内容の要旨
Installing the Wall-Mount Bracket Install the Base Bracket and Mounting Bracket. 1 Open the Wall-Mount Bracket package and check for all the required parts along with the Instructions. 2 Decide where you want to install your TV. Refer to the TV installation dimensions table. Dimension Table Screen center point Unit: inches (mm) Model Name Display Screen center Length for each mounting angle dimensions dimensions Angle (0°) Angle (20°) 3 17 5 3 3 1 KDL- 49 / 31 / 16 / 3 15 / 29
ページ3に含まれる内容の要旨
4 Detach the Table-Top Stand from the TV, if necessary. Remove the bottom cover and terminal cover first before detaching the Table-Top Stand. Terminal cover Bottom cover Remove the screws guided by the arrow marks of the TV. ✍ • D o not remove the Table-Top Stand for any reason other than to install corresponding accessories on the TV. • W hen removing the Table-Top Stand from the TV, lay the TV face down on a stable work surface that is larger than the TV. • To prevent damaging the surface
ページ4に含まれる内容の要旨
6 Place the Spacers. (KDL-52NX80 * only) Remove the four screws, and be sure to store them in a safe place, keeping them away from children. Plac e the four spacers (supplied). * In the actual model names, the “ ” indicates numbers and/or characters specific to each model. 7 Attach the Mounting Bracket to the rear of the TV temporarily. Temporarily tighten the top of the Mounting Bracket using two screws (+PSW M6 × 6). Screw Mounting Bracket Mounting Bracket Additional Information f
ページ5に含まれる内容の要旨
8 Attach the Lock Bracket to the bottom of the Mounting Bracket. Temporarily move the bottom of the Mounting Bracket outwards. ✍ • If the bottom of the Mounting Bracket does not move, loosen the screws (return to step 7). Insert the pins of the Mounting Bracket through the holes of the Lock Bracket. Return the Mounting Bracket to their original position to attach the Lock Bracket. Lock Bracket 9 Secure the Mounting Bracket to the rear of the TV. When using an electric screwdriver,
ページ6に含まれる内容の要旨
10 Adjust the angle of the Mounting Bracket. Use the supplied hexagon wrench. When installing the Display parallel to the wall (0 degrees), adjustment of the Mounting Bracket angle (procedures and below) is not necessary. Remove the two angle adjusting screws from the Mounting Bracket. Secure the screws to the corresponding holes for the desired angle (“ ,” “,” “0,” “” o r “0”). Hexagon wrench ✍ • B e sure that both the left and right sides are set to the same angle, and
