ページ1に含まれる内容の要旨
CASCADING FOUNTAIN
Model 93442
ASSEMBLY AND OPERATING INSTRUCTIONS
Diagrams within this manual may not be drawn proportionally.
Due to continuing improvements, actual product may differ slightly from the product described herein.
®
Distributed exclusively by Harbor Freight Tools .
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
Read this material before using this product.
Failure to do so can result in serious injury.
SaVe THi
ページ2に含まれる内容の要旨
PRODUCT SPECIFICATIONS Item Description Electrical Requirements 120 VAC / 60Hz / 0.04 AMPs Power Cord: 6’-3” / 18AWG x 3 C Power Plug: 3-Prong Water Pump Self-Priming with Intake Filter / 1/4” Outlet Nipple Large Bowl Size 13-1/4” Diameter x 4-1/2” High Small Bowl Size 6-1/4” Diameter x 2-7/8” High Jug Size 4-7/8” Diameter x 6” High Stand Frame Dimensions 11” Diameter x 16-3/4” High Overall Dimensions 15-5/8” Long x 17” Wide x 21-1/2” High Unit Weight 16.25 Pounds SAVE THIS MANUAL You will need
ページ3に含まれる内容の要旨
grounded in accordance with all codes and ordinances. Never remove the grounding prong or modify the plug in any way. Do not use any adapter plugs. Check with a qualified electrician if you are in doubt as to whether the outlet is properly grounded. If the product should electrically malfunction or break down, grounding provides a low resistance path to carry electricity away from the user. 5. Double insulated products are equipped with a polarized plug (one blade is
ページ4に含まれる内容の要旨
12. Use safety equipment. Wear eye protection when assembling this product. Non-skid safety shoes must be used for appropriate conditions. TOOL USE AND CARE 13. Disconnect the Power Cord Plug from the power source before making any adjustments, changing accessories, or storing the Fountain. Such preventive safety measures reduce the risk of starting the unit accidentally. 14. Store idle equipment out of reach of children and other untrained persons. Electrically pow
ページ5に含まれる内容の要旨
3. Maintain a safe environment. Keep the area well lit. Make sure there is ade- quate surrounding space. Always keep the area free of obstructions, grease, oil, trash, and other debris. Do not use an electrically powered product in areas near flammable chemicals, dusts, and vapors. 4. Never leave the Fountain unattended when it is plugged into an electrical outlet. Turn off the Fountain before leaving. 5. Carefully inspect the condition of the Fountain before use, and check the Fo
ページ6に含まれる内容の要旨
15. Always arrange a “drip loop” in the Power Cord connecting the Pump (9) to a 120 volt, grounded, electrical outlet. A drip loop is that part of the Power Cord below the level of the electrical outlet, or the connector if an extension cord is used, to prevent water traveling along the Power Cord and coming in contact with the outlet. If the Power Cord Plug or outlet does get wet, do not unplug the Power Cord Plug. Disconnect the fuse or circuit breaker that supplies power t
ページ7に含まれる内容の要旨
GROUNDED TOOLS: TOOLS WITH THREE PRONG PLUGS 1. Tools marked with “Grounding Required” have a three wire cord and three prong grounding plug. The plug must be connected to a properly grounded outlet. If the tool should electrically malfunction or break down, grounding provides a low resistance path to carry electricity away from the user, reducing the risk of electric shock. (See Figure B.) 2. The grounding prong in the plug is connected through the green wire inside the cord to the gro
ページ8に含まれる内容の要旨
EXTENSION CORDS 1. Grounded tools require a three wire extension cord. Double Insulated tools can use either a two or three wire extension cord. 2. As the distance from the supply outlet increases, you must use a heavier gauge extension cord. Using extension cords with inadequately sized wire causes a serious drop in voltage, resulting in loss of power and possible tool damage. (See Figure D.) 3. The smaller the gauge number of the wire, the greater the capacity of the cord.
ページ9に含まれる内容の要旨
SYMBOLOGY Double Insulated Canadian Standards Association Underwriters Laboratories, Inc. Volts Alternating Current V ~ Amperes A No Load Revolutions FIGURE E no xxxx/min. per Minute (RPM) UNPACKING When unpacking, check to make sure all the parts shown on the Parts List on page 13 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible. ASSEMBLY AND OPERATING INSTRUCTIONS NOTE: For additional i
ページ10に含まれる内容の要旨
5. Attach the Top Stand (4) to the Vertical Stand (2) and Middle Stand (3). (See Assy. Diagram.) 6. Carefully set the Large Bowl (5) on the Bottom Stand (1). (See Assy. Diagram.) 7. Carefully set three Small Bowls (6) on the Middle Stand (3) and Top Stand (4). (See Assy. Diagram.) 8. Carefully set the Jug (7) on the Top Stand (4). (See Assy. Diagram.) 9. Route the Hose (8) downward into the Large Bowl (5). (See Assy. Diagram.) 10. Set the Pump (9) in the middle of the Large Bowl (5). (Se
ページ11に含まれる内容の要旨
Operating Instructions: 1. Plug the Power Cord of the Pump (9) into the nearest 120 volt, grounded, electrical outlet, making sure to arrange a “drip loop” in the Cord. The Pump will now run continuously until it is unplugged from its electrical outlet. (See Figure G.) POWER CORD 120 VOLT, GROUNDED, ELECTRICAL OUTLET DRIP LOOP FIGURE G (WATER) 2. Allow sufficient time for the Pump (9) to move water upward into the Jug (7). Once the Jug is filled to overflowing, the water will begi
ページ12に含まれる内容の要旨
5. When storing, make sure to store the Fountain in a clean, dry, safe location out of reach of children. 6. CAUTION! All maintenance, service, or repairs not mentioned in this manual must only be performed by a qualified service technician. GROUNDING WARNING! Improperly connecting the grounding wire can result in the risk of electric shock. Check with a qualified electrician if you are in doubt as to whether the outlet is properly grounded. Do not modify the power cord plug provi
ページ13に含まれる内容の要旨
PARTS LIST AND ASSEMBLY DIAGRAM Part # Description Qty. Part # Description Qty. 1 Bottom Stand 1 6 Small Bowl 3 2 Vertical Stand 1 7 Jug 1 3 Middle Stand 1 8 Hose 1 4 Top Stand 1 9 Pump 1 5 Large Bowl 1 7 4 6 8 6 2 3 6 9 5 1 NOTE: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. SKU 93442 For technical questions, please call 1-800-444-3353 PAGE 13
ページ14に含まれる内容の要旨
REV 09c SKU 93442 For technical questions, please call 1-800-444-3353 PAGE 14
