ページ1に含まれる内容の要旨
920FJTRPD
Installation Instructions for
1.8
Torpedo Pendant
700FJTRPN_
PENDANTS-LOW VOLTAGE
GENERAL PRODUCT INFORMATION:
This product is ETL listed and suitable only for indoor dry
locations and approved for use at any height above the
finished floor.
This product is patented (U.S. PAT. 6,183,297).
Adjust The Fixture Height
1A 1C
1/16 ALLEN WRENCH
#6-32 SET SCREW
5
1
1
Back out (do not remove) the #6-32 set screw on tip of 4 Cut the coaxial cable to the desired length.
the connector with the p
ページ2に含まれる内容の要旨
1E 1H WRINKLE ON OUTER WRAPPED WIRE 7 11 INNER WIRE STOPS HERE 11 7 Keep pushing the coaxial cable into the connector while Pull the coaxial cable toward the fixture to smooth the rotating the connector to ease feeding the inner wire wrinkles. into the tip of the connector. The outer wrapped wire will start wrinkling while being inserted another 1/2" into the connector. 1F 1/16 ALLEN WRENCH INNER WIRE 9 8 SIGHT HOLE 8 Look into the sight hole on the top of the connector to make sure that the
ページ3に含まれる内容の要旨
Replacing the Lamp CAUTION: To reduce the risk of a burn or electric 2B shock during relamping, disconnect the power to the fixture. NOTE: Use only your fingers and a soft cloth to GROOVED replace the lamp. SHADE HOLDER 3 ACCESSORY Round, Cone, Dichroic, Martini, Firebird, or Prism Glass Shield; Belladonna; Bell; Tinkerbell; Lil Egypt; MR16 LAMP 2 Meteorite; Moonlet; or Droplet accessory are the compatible accessories for the Torpedo pendant. Use MAX 50 Watt, MR16 Front Cover Halogen 2
ページ4に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS Halogen Lamp General Information To reduce the risk of fire, electrical shock, exposure to – A new halogen lamp may smoke slightly when it is used for the first time. This is perfectly normal; the protective excessive UV radiation, or injury to person: coating is simply being vaporized. – Use this fixture indoors only. – Do not look directly at the lighted lamp. Two Tips For Prolonging Halogen – Do not remain in light if skin feels warm. Lamp Life – Risk
