ページ1に含まれる内容の要旨
0410
GH SERIES
Apartment Intercom System
QuikStart Installation Guide
ATTENTION:
This is an abbreviated Installation Manual, addressing Wiring and Programming of the GH System only.
The complete GH System Installation and Operation Manual is located on the CD that comes with the
GH-BC Bus Control Unit. Access the PDF file from the CD and print the entire manual if a hard copy is
needed. If installing a digital entry system, the program for loading names and numbers for each tenant
is also
ページ2に含まれる内容の要旨
0210 GH Series Installation Manual Supplement Programming Guide for Assigning Tenant Station ID Numbers IMPORTANT: Follow these instructions carefully when programming the GH entrance panel to call tenant stations. Ensure that all units are installed and wired properly. If your system includes the GH-NS name scroll module, program the resident information (tenant names and room numbers) before assigning the ID’s. 1. Turn the power switch on the GH-BC to the ON position. 2. At the Entrance Pane
ページ3に含まれる内容の要旨
Correcting or changing an ID setting: In order to correct a programming error, the entrance station(s) and the tenant station(s) must be cleared of their incorrect program data, then programmed again correctly. Follow these steps to clear: 1. Put the system into programming mode using the procedure described on page 1, step 3. 2. At the tenant station, press and hold the door release button and bell button simultaneously until a beep is emitted from the unit (should take about 3
ページ4に含まれる内容の要旨
= PS-2420UL - 4 -
ページ5に含まれる内容の要旨
- 5 -
ページ6に含まれる内容の要旨
= PS-2420UL - 6 -
ページ7に含まれる内容の要旨
Please refer to the GH installation manual for complete wiring information on GH Expanded system. - 7 -
ページ8に含まれる内容の要旨
- 8 -
ページ9に含まれる内容の要旨
- 9 -
ページ10に含まれる内容の要旨
- 10 -
ページ11に含まれる内容の要旨
- 11 -
ページ12に含まれる内容の要旨
- 12 -
ページ13に含まれる内容の要旨
- 13 -
ページ14に含まれる内容の要旨
= PS-2420UL = PS-2420UL - 14 -
ページ15に含まれる内容の要旨
- 15 -
ページ16に含まれる内容の要旨
- 16 -
ページ17に含まれる内容の要旨
- 17 -
ページ18に含まれる内容の要旨
- 18 -
ページ19に含まれる内容の要旨
- 19 -
ページ20に含まれる内容の要旨
- 20 -
