ページ1に含まれる内容の要旨
Owner’s Manual
Model 1812 Plus
Residential Telephone Intercom / Access Control System
DoorKing, Inc.
120 Glasgow Avenue
Inglewood, California 90301
U.S.A.
Phone: 310-645-0023
Fax: 310-641-1586
www.doorking.com
P/N 1812-161 REV E, 1/10
Copyright 2009 DoorKing, Inc. All rights reserved.
ページ2に含まれる内容の要旨
Page 2 1812-161-E-1-10
ページ3に含まれる内容の要旨
Use this manual with the following models only. 1812-Plus Residential Telephone Intercom / Access Control System with circuit board 1971-010. DoorKing, Inc. reserves the right to make changes in the products described in this manual without notice and without obligation of DoorKing, Inc. to notify any persons of any such revisions or changes. Additionally, DoorKing, Inc. makes no representations or warranties with respect to this manual. This manual is copyrighted, all rights reserved
ページ4に含まれる内容の要旨
Table of Contents Preface Important Notices......................................................................................................................................................6 General Information ..................................................................................................................................................7 Features ............................................................................................................................
ページ5に含まれる内容の要旨
2.4 Devices 2.4.1 Simple Access Code Programming .........................................................................................30 2.4.2 Access Code Programming .....................................................................................................30 2.4.3 Delete Access Codes...............................................................................................................30 2.4.4 Delete All Access Codes.....................................................
ページ6に含まれる内容の要旨
Important Notices FCC – United States This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to Part 15 of the FCC Rules and Regulations. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause ha
ページ7に含まれる内容の要旨
General Information • Prior to beginning the installation of the telephone entry system, we suggest that you become familiar with the instructions, illustrations, and wiring guidelines in this manual. This will help insure that you installation is performed in an efficient and professional manner. • The proper installation of the telephone entry panel is an extremely important and integral part of the overall access control system. Check all local building ordinances and building codes p
ページ8に含まれる内容の要旨
Features • Unique telephone communication system allows homeowners to use their telephone as an intercom to speak to a guest at a front door or gate, and to control access to their property. • Unique distinctive ring. • Unit connects directly to the homeowners existing telephone line. No additional monthly expense for a second telephone line. • Built in call waiting assures that incoming calls or guest calls are not missed. • Call Forwarding. • Up to 27 preprogrammed dial-out telephone
ページ9に含まれる内容の要旨
SECTION 1 - INSTALLATION Installation of the 1812 Plus Telephone Entry System involves the installation of the hardware and by- pass switch, and the wiring of these components. If used to control a vehicular gate with an automatic gate operator, the telephone entry system must be mounted a minimum of ten (10) feet away from the gate and gate operator, or in such a way that a person cannot operate the entry system and/or touch the gate or gate operator at the same time. 1.1 Mount
ページ10に含まれる内容の要旨
1.2 Mount the By-Pass Switch The 1812’s by-pass switch provides a method to remove the 1812 from the telephone line and reconnect the homeowner’s telephone to the telephone system. The By-Pass switch IS NOT optional – it must be installed as part of the 1812 system. All telephone wiring for the 1812 must pass through the by-pass switch. Wire the by-pass switch per the wiring instructions in this manual. Mount the by-pass switch in a location that is easily accessible by the homeowner.
ページ11に含まれる内容の要旨
1.3 Dimensions Surface Mount 10.0 5.25 2.5 .875 1 2 3 4 5 6 7 8 9 * 0 # 5.0 2.875 .875 Dia 1.31 1.25 Surface Mount Curved 11.0 6.25 2.5 .875 1 2 3 4 5 6 7 8 9 0 # 5.5 .875 1812-161-E-1-10 Page 11 6.125 6.75 3.375 3.0 2.5 2.5
ページ12に含まれる内容の要旨
Flush Mount Rough-in Box 10.25 4.5 1.25 Dia 5.0 2.625 Flush Mount 4.25 1 2 3 4 5 6 7 8 9 * 0 # 12.0 .875 Dia 5.0 2.5 10.0 Page 12 1812-161-E-1-10 3.5 7.5 9.25 3.5 6.25 7.25
ページ13に含まれる内容の要旨
Wall Mount 10.75 3.5 2.5 1.125 1 2 3 4 5 6 7 8 9 0 # * 1812-161-E-1-10 Page 13 7.375 2.5
ページ14に含まれる内容の要旨
1.4 Telephone Line Wiring Be sure to observe electrical safety when working with phone lines. Phone lines carry electricity and the ring voltage can deliver a substantial jolt. The best policy is to disconnect the house phone from the phone company Network Interface Device (also known as ‘Demarcation Device’) before working on the wiring. In most residential homes, the phone cable contains four wires; green, red, black, yellow. The green and red are twisted to make one pair and the bl
ページ15に含まれる内容の要旨
TELEPHONE LINE WIRING WIRE SIZE MAX DISTANCE IN FEET 24 AWG 800 22 AWG 1600 20 AWG 2200 18 AWG 3600 1.5 Power Wiring Do not run telephone lines and high voltage lines in the same conduit. Separate high voltage and telephone line conduits by at least six (6) inches. POWER WIRING WIRE SIZE MAX DISTANCE IN FEET 18 AWG 100 16 AWG 200 The 1812 Plus system operates on 16.5 VAC. Do not power this device with 24 volt AC power. Use the supplied power transformer, 16 VAC, 20 VA (or
ページ16に含まれる内容の要旨
1.7 Wiring for a Single Unit – Telephone Mode ENTRY BY-PASS 1 B House Phones White/Blue White/Blue DOORKING Phone Phone Phone From Phone 1875-010 Jack Jack Jack Blue/White Blue/White Company 3 White/Orange C.O. PH IN PH OUT HOME Orange/White 123 456 78 C GND 2 7 7 By-Pass A Switch 1 3 Master 2 Code Vehicular Gate 3 Operator 4 5 6 7 7 8 9 10 Mic 11 Keypad Vol 12 6 13 14 15 16 Mag Lock 16.5 VAC 17 Power 20 VA 6 18 Speaker Vol 5 4 Pedestrian 123456 789 1011 Gate / Door Mount the by-pass switc
ページ17に含まれる内容の要旨
1.8 Wiring for Multiple Units – Telephone Mode ENTRY BY-PASS 1 B House Phones White/Blue White/Blue DOORKING Phone Phone Phone From Phone 1875-010 Jack Jack Jack Blue/White Blue/White Company 3 White/Orange C.O. PH IN PH OUT HOME Orange/White 123 456 78 C GND 7 7 2 By-Pass A Switch 1 Master 3 2 Code Vehicular Gate 3 Operator 4 5 7 6 7 8 9 10 1st 1812 Mic 11 Keypad Vol 12 6 13 14 15 16 Mag Lock 16.5 VAC 17 Power 20 VA 6 18 Speaker Vol 5 4 Pedestrian 123456 789 1011 Gate / Door 2 1 Master 2
ページ18に含まれる内容の要旨
1.9 Wiring for Single Unit – Intercom Mode Phone Jack 1 Master 2 A Code Vehicular Gate 3 Operator 4 1 5 6 7 5 8 9 10 11 Mic Keypad Vol 12 4 13 14 15 16 Mag Lock 16.5 VAC 17 Power 20 VA 4 18 Speaker Vol 3 2 Pedestrian 123456 789 1011 Gate / Door Use only twisted pair telephone wire that is rated for direct underground burial. DO NOT When connected directly to a single telephone or an un- use wire that is intended for indoor applications. Recommend Cat5e Gel Filled A used C.O. port on a PB
ページ19に含まれる内容の要旨
1.10 Wiring for Multiple Units – Intercom Mode Phone Jack 1 Master 2 A Code Vehicular Gate 3 Operator 4 1 5 6 7 5 8 9 10 Mic 11 Keypad 1st 1812 Vol 12 4 13 14 15 16 Mag Lock 16.5 VAC 17 Power 20 VA 4 18 Speaker Vol 3 2 Pedestrian 123456 789 1011 Gate / Door 1 1 Master 1 2 Code Vehicular Gate 3 Operator 4 5 6 B 7 5 8 9 10 nd 2 1812 11 Mic Keypad Vol 12 4 13 14 15 16 16.5 VAC Mag Lock 17 20 VA Power 4 18 Speaker Vol 3 2 Pedestrian 123456 789 1011 Gate / Door Use only twisted pair telephone wi
ページ20に含まれる内容の要旨
1.11 Main Terminal Description Terminal Description 1 Phone In (Negative) 2 Phone In (Positive) 3 Ground 4 Phone Out (Positive) 5 Phone Out (Negative) 6 Not Used. Switch Input Relay 1. A switch closure across terminals 7 & 9 will activate relay 1 for 7 its programmed strike time. Switch Input Relay 2. A switch closure across terminals 8 & 9 will activate relay 2 for 8 its programmed strike time. 9 - 12 VDC Battery Negative. Also common for terminals 7 & 8. 10 + 12 VDC Bat
