ページ1に含まれる内容の要旨
D
DEUTSCH
COMBI
8211-3442-04
45
45S
45SE
ページ2に含まれる内容の要旨
S SVENSKA A B 1. 2. 3. 4. 3 2 4 1 FULL ADD 6. LS45 0,15 l. 6 5 5. 7. ES40 3 ADD FULL ADD FULL
ページ3に含まれる内容の要旨
S SVENSKA 3x 3x 8. LS45 9. ES40 G I* 10. 11. A A F A 12. 13. LS45 F 14. ES40 15. LS45 4 STOP
ページ4に含まれる内容の要旨
S SVENSKA 16. ES40 17. Left 18. Right 19. LS45 20. ES40 0,75 mm 21. 22. 23. 24. 5
ページ5に含まれる内容の要旨
S SVENSKA 25. 26. 45 Nm 27. 28. P S 29. 6
ページ6に含まれる内容の要旨
GB ENGLISH SYMBOLS ASSEMBLING The following symbols are displayed on the ma- HANDLEBAR chine in order to remind you about the safety pre- Fold up the handle. By tightly screwing the lower cautions and attention necessary when using the part of the handle into the steering sockets’ lower or machine. upper holes (A or B), the steering height can be The symbols mean: adapted to suit the operator (fig. 1). Warning! Read the Instruction Book and Tighten the locking knobs to fix the upper part of the
ページ7に含まれる内容の要旨
GB ENGLISH 2. COLLECTION STARTING THE ENGINE Assemble the enclosed grass collector (fig. 5). 1. Place the lawn mower on flat, firm ground. Do Open the cover, remove the plug and this time not start in high grass. hook the collector in place onto the back of the ma- 2. Make sure the spark plug lead is connected to chine. the spark plug. During cutting, the grass is collected in the collec- 3. Move the throttle control (*) to the full throttle tor. Empty the grass on the compost heap or spread pos
ページ8に含まれる内容の要旨
GB ENGLISH 2. If the lawn mower is left unattended to, remove If grass has dried on to the cutterhead casing it can the lead from the spark plug. Also remove the be removed by scraping. If necessary, give the un- starter key (*). derside a touch of paint to prevent rusting. If the start/stop loop no longer works, Clean the silencer and the surrounding stop the engine by removing the lead area regularly to remove grass, dirt and from the spark plug. Immediately take flammable waste products. the
ページ9に含まれる内容の要旨
GB ENGLISH CHANGING OIL BATTERY (*) Replace the oil when the engine is warm Electrolyte in the battery is toxic and and the fuel tank is empty. Take care corrosive. It can cause serious corrosion while draining as the oil is hot, this is to damage etc. Avoid all contact with skin, prevent burns. eyes and clothing. Change the oil the first time after 5 hours of oper- In normal use during the season, the battery is ation, and subsequently after every 50 hours of op- charged by the engine. If the e
ページ10に含まれる内容の要旨
GB ENGLISH Always check the blade(s) after an impact. First disconnect the ignition cable. If the blade system has been damaged the defective parts must be changed. Always use genuine spare parts. To change blades, loosen the blade bolt. Mount the new blade so that it sits in the same way as the old one and tighten the blade bolt (fig. 27). Tightening torque: 45 Nm. When replacing the blade, the blade bolt should also be replaced. The guarantee does not cover damage to the blade, blade holder or
