ページ1に含まれる内容の要旨
STIGA
MULTICLIP
46
46 EURO
PRO 46
8211-0223-09
ページ2に含まれる内容の要旨
S SVENSKA 12 34 1. 2. A 3. PRO 46 4. PRO 46 FULL ADD 5. 6. Briggs & Stratton G B* G 7. Honda 8. EURO 2 ADD FULL STOP
ページ3に含まれる内容の要旨
S SVENSKA 3x 9. Briggs & Stratton 10. Honda 11. 12. Briggs & Stratton Briggs & Stratton : 0,76 mm 0,75 mm Honda: 0,7-0,8 mm 13. Honda 14. 40 Nm 40 Nm 15a. 15b. 3
ページ4に含まれる内容の要旨
GB ENGLISH PRO 46 SYMBOLS Raise the upper part of the handle and place it be- hind the machine. Fold up the lower part of the The following symbols can be found on the ma- handle and tighten the locking wheels A (fig. 3). chine to remind you of the care and attention that Then attach the upper part of the handle. There is are required during use. also a lug on the right hand side for the starter han- The symbols mean: dle (fig. 1). Warning! Read the Instruction Book and Storage position: Release
ページ5に含まれる内容の要旨
GB ENGLISH FILL UP THE PETROL TANK Keep hands and feet away from the ro- tating blade. Never put your hand or Fill with petrol before starting the mo- foot under the blade casing or in the tor. Never remove the filler cap or fill grass ejector while the engine is run- with petrol while the motor is running ning. or still warm. STARTING THE ENGINE (Honda) Never completely fill the fuel tank. Al- low a little room for the petrol to expand 1. Place the lawnmower on flat, firm ground. Do if necessar
ページ6に含まれる内容の要旨
GB ENGLISH If the start/stop loop ceases to work, stop CLEANING the engine by removing the spark plug After each use the mower should be cleaned. This cable from the spark plug. Immediately is particularly important on the underside of the take the lawn mower to an authorised mower casing. Rinse with the garden hose. The workshop for repair. mower will then last longer and function better. MOWING TIPS The paint on the underside of the deck will, in time,bewornawaybythe mowing process.To Before m
ページ7に含まれる内容の要旨
GB ENGLISH Honda: Remove the cover and take out the filter. The guarantee does not cover damage to the blade, (fig. 13). Carefully check the filter for holes or oth- blade holder or engine caused by running into ob- er damage. A broken or damaged filter must be re- stacles. placed. When replacing the blade, blade holder and blade To remove dirt, carefully knock the filter several screw, always use genuine spare parts. Non-genu- times against a hard surface or use compressed air ine spare parts c
ページ8に含まれる内容の要旨
MO WI NG A H E A D GGP Sweden AB · Box 1006 · SE-573 28 TRANÅS www.stiga.com
